Question about 2008 Jeep Compass
Front wipers not working on my 08 jeep compass
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Before replacing the module ($$$$) check the temperature sensor at the front of the vehicle behind the bumper or grill. A reading of -40 indicates a high resistance (NTC resistor sensor). This is probably due to water ingress on a connector causing the high resistance. But could be a bad sensor too. You can also check the module by unplugging the temperature sensor and shorting the two wires that go back to the module together. Shorting the two wires together should show an off scale high reading like 120 or 130 degrees. If it does then the module is OK the problem is the wiring or the sensor. You can use this method to check the wiring all the way up to the module incase there is high resistance in the wiring between the module and the temperature sensor.
Posted on Sep 22, 2008
SOURCE: location of cabin air filter
It can have a cabin air filter, but most vehicles ship without it.
Either way, you can access the cabin air filter housing by opening the glove box all the way (squeeze the sides so it clears the stops).
The filters are around $15 at the dealer.
Whether or not there's a cabin filter installed, make sure you're also following Chrysler's recommendations in the owner's manual—running the air on recirculate all the time will encourage mold and bacteria to grow.
Posted on Nov 23, 2009
I had same prob with Grand Cherokee - no rhyme nor reason as to when, where or why it wouldn't start. After two new starters the shop finally found a starter wire/cable that was corroded on the inside. Mech' could move it back and forth and it would / would not start. Changed cable six months ago - no problems since. Hope it helps.
Posted on Aug 24, 2010
I am having the same problem. Did you ever get it worked out? I would appreciate any help that you could give me.
Posted on Oct 05, 2010
Tips for a great answer:
May 05, 2015 | 2009 Jeep Patriot
May 08, 2014 | 2008 Jeep Compass
Mar 07, 2012 | 2008 Jeep Compass
Nov 28, 2009 | 2008 Jeep Compass
Oct 26, 2009 | 2008 Jeep Compass
Oct 02, 2009 | 2008 Jeep Compass
Sep 04, 2009 | 2008 Jeep Compass
Aug 16, 2009 | 2008 Jeep Compass
Aug 06, 2009 | 2008 Jeep Compass
83 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: