Question about 1993 Toyota Corolla

Open Question

How do i remove the rear bumper on a 1993 toyota corolla

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
chiquititas
  • 1010 Answers

SOURCE: corolla 2003 rear bumper

Pop the trunk and remove the screws or clips thats connecting the bumper there, and then do the same thing in the wheel wheel and under the bumper along the lip and it should come right off. There might be some under the tail lights so you might have to take out the tail lights.

Posted on Jun 24, 2008

Ad
  • 99 Answers

SOURCE: Remove rear plastic bumper cover

please email me at meanness628@aim.com with any other info or questions if you have already gone to a body shop

Posted on Sep 29, 2008

  • 1861 Answers

SOURCE: replace rear seat belt in 1993 Toyota Corolla

OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).

Posted on Oct 07, 2008

rteemon
  • 578 Answers

SOURCE: My Toyota Corolla rear bumper has at big dent on

you have to take the whole bumper off and the bolt the u see holding it on the re-bar and bumper cover should come off

Posted on Jul 01, 2009

  • 136 Answers

SOURCE: how to remove 2008 toyota yaris rear bumper

Go to this site. http://www.yarisworld.com/forums/showthread.php?t=33767

Further down you will see a diagram of the bumper removal.

remove the two bolts under the hatch, the four plugs along the bottom edge, and the plate light. Don't forget the red circle clip or bolt on the diagram. Then you just pull it off.

Posted on Dec 01, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Corolla rear bumper


Corolla rear bumper

And we continue to wonder
what is next to be typed

Aug 16, 2014 | 2007 Toyota Corolla

1 Answer

How to take out rear bumper from 2003 toyota corolla?


If you follow the same techniques as in this video, you should be fine.....attached video of 2011 which should be very similar to 2003 TOYOTA CAMRY 2011 REAR BUMPER COVER REMOVAL REPAIR

May 26, 2014 | 2003 Toyota Corolla

1 Answer

I ran my 2006 toyota corolla into the garage door! It was at a very low speed so thankfully it only did a little damage. I need to take the right side of the front bumper off and so a few minor repairs,...


I dont own a toyota so i couldnt tell you for sure..but i do know one thing for sure is that you must be careful that you disable the air bag sensors which are usually near the front bumper on most cars before you work on the bumper so that you dont set them off by accident.

Apr 07, 2010 | 1993 Toyota Corolla

1 Answer

My 2009 Corolloa LE was bumped in a parking lot by a yellow truck, on the right rear bulge of the bumper, leaving a ding in the bumper. I can only partially access the backside of the bump by removing the...


Go underneath with socket and wrench. there will be 2 bolts with nuts on one end and two on the other end. Then the entire bumper can then pull off.

Nov 15, 2009 | 2009 Toyota Corolla

1 Answer

Change the front wheel bearings toyota corolla 1992


front wheel bearings on this vehicle are part of a hub assy. you will have to completely remove the steering knuckle, press out the old bearing hub and rear seal and press in the new one.

Aug 03, 2009 | 1993 Toyota Corolla

2 Answers

My Toyota Corolla rear bumper has at big dent on


you have to take the whole bumper off and the bolt the u see holding it on the re-bar and bumper cover should come off

Jul 01, 2009 | 2000 Toyota Corolla

1 Answer

Need to remove rear bumper cover from a 2009 Toyota Corolla


paint it on the car or simply remove all the bolts and screws.  Duh

Mar 15, 2009 | 2009 Toyota Corolla

1 Answer

Replace rear seat belt in 1993 Toyota Corolla


OK. On the front edge of the seat bottom cushion, pull up hard, both sides. This will dislodge the 2 clamps that holds the seat cushion to the floor. Pull the seat cushion out & set it aside. You will now see the female latches bolted to the area where the rear of the seat cushion meets the rear seat back bottom. Remove the bolts (14 mm I think).

Oct 07, 2008 | 1993 Toyota Corolla

2 Answers

Corolla 2003 rear bumper


Pop the trunk and remove the screws or clips thats connecting the bumper there, and then do the same thing in the wheel wheel and under the bumper along the lip and it should come right off. There might be some under the tail lights so you might have to take out the tail lights.

Jun 23, 2008 | 2003 Toyota Corolla

Not finding what you are looking for?
1993 Toyota Corolla Logo

Related Topics:

125 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8826 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...