Question about 2006 Dodge Durango

1 Answer

Hoping you can help......need the location for the Pcv valve for 2006 Dodge,Durango, 8 cylinder w/ a 4.7L?

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 17,970 Answers

On a 2000 Durango V8 the PCV is located on the side of the oil fill tube under the cap

Posted on May 06, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Location of the pcv valve on 2006 dodge magnum 2.7

Have you checked the parts store to see if they even list one for that car? Some cars do not have one.

Dec 13, 2014 | 2006 Dodge Magnum

1 Answer

Where is egr location on a 04 durango 4.7

, the EGR on a 4.7 is attached to the rear of the left cylinder head, instead of on the front of the right cylinder for the 5.7.

I googled this Hope it helps.

Dec 01, 2014 | 2004 Dodge Durango

1 Answer

How do I find the PCV valve on 2006 ford f150 xlt

PCV valve is normally located in one of the valve covers and connects to a vacuum source near the fuel intake assembly. Connecting hose is normally about 3/8 inch in diameter.

Sep 11, 2014 | Cars & Trucks

1 Answer

2006 dodge charger pcv valve location


9491.jpg The PCV valve (3) is mounted into the top/right side of the intake manifold (2).

1.The PCV valve (1) is sealed to the intake manifold with two O-rings (2).
2.Remove PCV valve by rotating counter-clockwise 90 degrees until locating tabs (3) have been freed. After tabs have cleared, pull valve straight up from intake manifold.3.After valve is removed, check condition of two valve O-rings (2). __________________

Oct 07, 2010 | 2006 Dodge Charger

2 Answers

Were is my pcv on my 2005 dodge durango 5.7

its located in the intake manifold....its just to the right of the throttle body....its hard to recognise because it doesnt look like a typical pcv valve its recessed into the intake, theres a small circle with 2 arrows on it,its under that,just rotate it out of the intake carefully and its held in place by o rings....

Apr 28, 2010 | 2005 Dodge Durango

2 Answers

Where is the pcv valve located on a 2004 dodge durango 4.7 liter?

it is usually located somewhere on your rocker cover it is a small l or t shaped cylinder mounted in a rubber gasket it should have a small rubber hose coming off it

Dec 25, 2009 | 2004 Dodge Durango

1 Answer

Where is the pvc valve located on a 2002 dodge durango 4.7

The pcv valve is attach to the oil fill neck.

Oct 22, 2009 | 2003 Dodge Durango

1 Answer

Need to know where the crankshaftpositionsensor is located on a 2005 stratus 2.4lt engine

I am assuming your Stratus is a Sedan with the DOHC 4-cylinder engine. If so this might help. Do you know where your PCV valve is? (The PCV valve is on the driver-side of the engine up close to the top. It is a little black plastic cylinder with a vacuum tube coming out that goes up to the air intake fairing up near the fan.) The CSPS is right below the PCV valve. It has an electrical connecter with a little red release clip where the wires plug in. The sensor is about 3-4 inches wide and shaped like a rounded diamond with a raised circle in the middle. It is held on by 2 small bolts. I hope this helps.

Apr 18, 2009 | 2005 Dodge Stratus

1 Answer

2006 jeep liberty

the drain plug is located on the back of oil pan in the center. if you have a rock guard you have to remove this first. the pcv valve(positive crankcase vent is located on either the left valve cover in front or on theif it's a v6 or 8 or it is located on the valve cover in the back in a straight six it will have a hose that goes to your air filter breather box or the breather hose. please rate this...........thanks

Aug 30, 2008 | 2006 Jeep Liberty

2 Answers

Dodge ram 1500 hemi

I have a 04 durango I got a pcv valve and can't fine it on the cover I have 4cole packs on each side

Jun 29, 2008 | 2004 Dodge Ram 1500

Not finding what you are looking for?
2006 Dodge Durango Logo

Related Topics:

283 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides