Question about 1983 Cadillac DeVille

1 Answer

Starter wiring diagram

How to wire the starter. colors of wires and where they connect

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert whose answer got voted for 500 times.

  • Master
  • 1,297 Answers

This should help...
starter wiring diagram - 3459660.gif

Posted on May 07, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2005 dodge Magnum 2.7 what's the correct way to reconnect the starter wires there are three

Found this diagram. The starter bat terminal should be a bigger wire, two wires go there. You can see the color for the other wire all by itself.

Jun 08, 2016 | Dodge Cars & Trucks

1 Answer

How to remove the starter

Hope the wire colors help? Found this diagram for your starter motor.

Mar 02, 2018 | 2005 Honda CR-V 200i

1 Answer

Tpi wiring diagram

The wire from your key switch to the starter should connect to the solenoid on the starter . If you connect a volt meter ,positive to wire , neg to any ground you should see a reading of battery voltage when the key is turned to start position . No voltage when you let the key go or in run position .

Jan 19, 2018 | GMC Cars & Trucks

1 Answer

Starter wiring diagram

On low reduction starter there are only 2 wires on standard starter there only 3. One is your hot wire red color coded black is ground and white the ignition switch. If there is more that it probably add on connection for accessories usually goes to hot wire to supply power.

Nov 16, 2013 | 1994 Mercury Grand Marquis

2 Answers

2001 Cadillac Deville oxygen sensor wiring diagram

The wiring diagram shows the wiring color code, Power rating and connector plug used. The wiring diagram explains the vehicle's electrical connections with color code. It's a bit complicated to understand.


Apr 07, 2013 | 2001 Cadillac DeVille

2 Answers

I forgot where the wires go on the starter of my 2000 chevy cavalier

There should not be very many wires at that starter, and the positive battery cable along with any other wire(s) with a large 3/8 inch eyelet connector will connect to the main upper large terminal on the starter solenoid. There should be only one wire with a small eyelet connector (usually a purple or pink colored wire) and it will connect to the small terminal on the starter solenoid and is usually marked "S" next to the terminal. Also, if there was a ground strap attached at a starter bolt, then be certain that it gets re-attached to a starter bolt. Here is a diagram to help assist you, and let me know if you require any further assistance.


Aug 01, 2011 | Chevrolet Cavalier Cars & Trucks

2 Answers

Trying to install a push button ignition need to know which two wires to run to the button, without having to spend hours tracing and guessing. A diagram showing the wires would be great.

Your switch has 4 terminals.

1. Red is the hot wire from the battery.
2. Dark Blue is the run wire. This wire powers PCM, and engine and well as all accessories when the key is on.
3. Yellow is the start wire. It powers the engine, ECU and starter circuit when the key is turned to start.
4. Last terminal is accessories. I don't know the color, but it will power the radio, blower, windows, mirrors, etc. when key is turned to ACC. Some diagrams of the switch are below. Please let me know if you have any questions.


Nov 12, 2010 | 1996 Dodge Dakota

1 Answer

Subaru ea81 starter solenoid wiring diagram

Some starter solenoids are mounted on the fender near the battery and some are on the starter itself.

Typically the ones mounted on the fender have two larger posts and one smaller post. For the larger posts: One connects strait to the positive post on the battery. The other connects strait to the starter. The smaller post connects to the neutral safety switch which connects to the start position of the ignition switch. Here is a diagram. Make sure the solenoid is grounded good.

For the solenoid that is mounted on the starter: Connect the positive post of the battery to the large post on the starter. Connect smaller neutral safety switch/ignition switch wire to the smaller post.

Here is a diagram if you have both solenoids

Don't forget to hook backup any other wires that were hooked to the positive side of battery/solenoid like alternator wire etc.

Sep 11, 2009 | 1987 Subaru Brat

1 Answer

Wire Colors

I have sent you the wiring diagram via e-mail. Please let me know if it meets what you need. Thnaks for choosing FixYa!

Dec 03, 2008 | 1993 Toyota Camry V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

81 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides