Question about 2007 Chevrolet Tahoe

1 Answer

I changed radio in tahoe 2007 and now the reverse sensors don´t work any more and got a a messege that says service suspension system and and tire monitor does not work.. is there any way to reset the computer like the cadillacs dor example the sts 2001?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

    Sniper:

    An expert who has posted more than 50 answers, of which 90% or more were rated as helpful.

  • Contributor
  • 181 Answers

The radio will more than likely have to be programmed to the vehicle by a dealership or someone with access to a dealer level scanner.

Posted on May 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

4 wheel will not work. the selector switch will show it is in but front tires will not engage No messages on control center


Search Results

    4WD Transfer Case Position Sensor/Selector ... - RepairPal

    repairpal.com > Problems > Chevrolet > Tahoe
    Service 4WD Message May be Displayed on Chevrolet Tahoe. The 4WD transfer .... I had a similar problem with 4 wheel drive selector switch. When I select 4 ...

    4WD Transfer Case Position Sensor/Selector ... - RepairPal

    repairpal.com > Problems > Chevrolet > Suburban 1500
    Service 4WD Message May be Displayed on Chevrolet Suburban 1500 ... When in 4 wheel , it will not in engage sometimes and message comes on to service 4 wheeldrive. ... I replaced the 4wd transfer switch in 2007 and now again it is not working, this would be the ... 2008 Chevrolet Suburban 1500- 4WD156,000Visitor.

    Chevrolet Tahoe Repair: Problems, Cost and Maintenance

    repairpal.com > Cars > Chevrolet
    Having problems with your Chevrolet Tahoe? Learn about common Chevrolet Tahoe problems, recalls and typical maintenance and repair costs. ... ABS Front WheelSpeed Sensors May Fail. Chevrolet Tahoe ... 2008 Chevrolet Tahoe.

Jan 21, 2016 | 2008 Chevrolet Tahoe LTZ

1 Answer

My Tahoe Ltz stock radio screen Don work


Do all the other dash lights work?
If so, the LED display in the stereo may have burnt out

Feb 15, 2015 | 2007 Chevrolet Chevrolet Tahoe LTZ

1 Answer

2007 Yukon Denali XL autoride suspension light comes on intermittently


Would need to know what DTC'S - diagnostic trouble codes are stored in the module for the autoride suspension . Hooking up a professional type scan tool ,looking at input data to the module etc... Looking at a wiring diagram an testing electrical circuit's using a DMM - digital multi-meter . Reading how the system works ,what all involved in making the system work . This is how a professional Tech would go about diagnosing this .

The automatic level control (ALC) system maintains a desired rear suspension position under all types of towing, hauling and loading conditions. The following components are involved in the operation of the ALC system:
• Air line tubing--Pressurized air from the ALC compressor is pumped to each of the rear shocks via air line tubing.
• Air drier--Pressurized air from the compressor is run through a drier containing a moisture absorbing chemical preventing water accumulation in the rear shocks.
• Compressor--Supplies pressurized air to the rear shocks
• Compressor motor relay--The relay supplies battery positive voltage to the ALC compressor motor.
• Pressure sensor--The electronic suspension control module (ESCM) module provides a 5-volt reference and low reference to the ALC pressure sensor. The module receives the signal voltage that is relative to the air pressure applied to the rear shocks.
• ESCM--Controls the ALC system and electronic suspension control (ESC) system and detects failures in both. The module monitors inputs from the position sensors, and pressure sensor to determine when to raise and lower the vehicle to trim height as the vehicle is loaded or unloaded. The module limits pump activation to 255 seconds to prevent thermal damage.
• Exhaust valve--An electric solenoid activated by the ESCM to vent air pressure from the rear shocks.
• Left and right rear suspension position sensors--The module provides a 5-volt reference and low reference to all 4 of the body-to-wheel suspension position sensors. The sensors send the ESCM a signal voltage that is relative to the rear suspension ride height
• Left and right rear shock absorbers with internal air chambers and dampers--Dampens the rear suspension and maintains trim height depending on the air pressure applied.

Nov 04, 2017 | 2007 GMC Yukon XL Denali

1 Answer

2007 Tahoe LTZ wipers don't work on intermittent


problem is most likely the wiper control module, not sure but check with your dealer for possible warranty.

Apr 18, 2013 | 2007 Chevrolet Tahoe

1 Answer

07 Chevy Tahoe BCM programmed


The air ride system can be "self tested" with a GM Tech 2 scan tool, you need that done to see what is causing this problem, it could be the suspension height sensor, it could be a leaking air bag (very common) or a defective air compressor or damaged leaking air lines from the compressor to the airbags, also a very common. The airbags are good for about 75,000 miles or less if the roads you travel on are in poor condition.

Mar 23, 2017 | 2007 Chevrolet Tahoe

1 Answer

Bypass suspension code on 07 tahoe


Dealer . need factory scan tool to go into system an turn it off .

Aug 20, 2017 | 2007 Chevrolet Tahoe

1 Answer

When changing rear shocks do i have to do anything special


{: ) Nothing really special to do, except observe safety precautions, also to protect yourself. You can replace it like any conventonal means.
If you have gas shocks, just be careful not to puncture for it contains high pressure gas. Also don't remove the snap ring from inside the top of the tube.
If the vehicle is equipped with air leveling, there is a certain procedure after replacing the shocks, but a scan tool will be needed.
• Remove the scan tool. • Cycle the ignition OFF, then back ON, with the engine ON to allow the air suspension system to regain the desired rear suspension position. • Turn the ignition ON, with the engine OFF.

Feb 08, 2011 | 2007 Chevrolet Tahoe

2 Answers

The service suspension system light came on this today on my way to work. Is this still drivable and or should I head to the dealers? thanks Todd


Yes , it is drivable , check your milage and see if you are ready for an inspection. Sometimes these systems are set for a certain distance or time . If it is not , take it to be seen soon , could be air ride not leveling and will in some way affect the drivability !

Jan 27, 2011 | 2007 Chevrolet Tahoe

1 Answer

Having an issue with 2007 chevy tahoe check engine ligth is on , trottle control sensor , please tell me how to replace it , or is it a dealer only fix


Removal & Installation
  1. Remove the driver's side knee bolster.

  2. Push down on the small tab and disengage the electrical connector.

  3. Remove the pedal bolts and remove the pedal and sensor assembly.

  4. Installation is the reverse of removal.
    22116_sier_g0125.gif hope this helps

Oct 22, 2010 | 2007 Chevrolet Tahoe

1 Answer

My 2007 tahoe service monitor tire light is on


If you have the tire pressure monitoring system, the sensors are located in each tire valve stem. They can be recalibated by following instructions in the owners manual. If you (like I) bought used and the tires were changed the sensors could be missing. I found some on ebay. If you have the sensors you can go to the dealer and they can recalibrate them for you.

Nov 30, 2008 | 2007 Chevrolet Tahoe

Not finding what you are looking for?
2007 Chevrolet Tahoe Logo

247 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

78919 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...