Question about 1992 Eagle Talon

1 Answer

Dip stick poping out of tube, Why? - 1992 Eagle Talon

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Eagle Master
  • 76,164 Answers

This can be caused by excessive crankcase pressure, make sure the PCV valve is working, chec the valve and the the hose to it.

Posted on May 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2002 x-type dipstick broken in tube


yes you can still change oil with oil drained remove dip tube extract dip stick replace tube Then repair/replace dip stick, fill as per normal

May 31, 2012 | 2002 Jaguar X-Type

1 Answer

I can't locate where to check the transmission fluid,there's a cap on top of the ****** that says ****** fluid but there's not dip stick


I am at a bit of a loss. Not only do I not know what Saturn you have but this site edits words that should not be edited. (I don't know what a ****** or a ****** is)

Regardless of what Saturn or those words, most the automatics I see (German cars are oddballs)have a tube where the transmission is filled and the dip stick is inside that tube. (may have a red handle) Perhaps your dip stick broke off. Can you look into the tube and see anything? The dip stick is long enough and the tube is deep in the pan where the broke dip stick should not fall all the way into the pan.

Sep 11, 2011 | Saturn L-Series Cars & Trucks

2 Answers

How do you remove broken oil dipstick from a 1999 ford escort?


The dip stick tube is pressed into the engine block. Put a bolt into the top of the tube so that the body of the bolt goes into the tube and the bolt head rests on the tube (so it does not fall down the tube). Use a wrench (such as a Vise grip) to hold onto the tube at the bolt and gently work it back and forth, being sure not to deform the tube. Remove the tube and old dip stick. Replace the tube by forcing it back into the eng. block. Replace the dip stick - done :)! Some dip stick tubes have a gasket at the engine - others just **** up to a shoulder that is built into the tube. Let me know if this works. Thanks.

Dec 19, 2010 | 1999 Ford Escort

1 Answer

Replace alternator in chrysler town and country minivan


REMOVAL
  1. Release hood latch and open hood.
  2. Disconnect battery negative cable.
  3. Disconnect the push-in field wire connector from back of generator.
  4. Remove nut holding B+ wire terminal to back of generator.
  5. Separate B+ terminal from generator.
  6. Raise vehicle and support.
  7. Remove the right front lower splash shield.
  8. Remove accessory drive belt, refer to the Cooling System for proper procedures.
dak408_172.gif

  1. Remove the lower oil dip stick tube bolt (Fig. 2).
  2. Remove wiring harness from the oil dip stick tube
  3. Remove the 3 mounting bolts.
  4. Lower vehicle.
  5. Remove oil dip stick tube from vehicle.
dak408_173.gif
  1. Roll and remove the generator from vehicle (Fig. 3).
INSTALLATION
  1. Roll and place generator in position on vehicle (Fig. 3).
  2. Install upper bolts to hold generator in place.
  3. Lubricate the O-ring. Install oil dip stick tube.
  4. Install the upper oil dip stick tube bolt.
  5. Place B+ terminal in position on generator.
  6. Install nut to hold B+ wire terminal to back of generator.
  7. Connect the push-in field wire connector into back of generator.
  8. Raise vehicle and support.
  9. Install the lower mounting bolt and tighten.
  10. Install the lower oil dip stick tube bolt and tighten (Fig. 2).
  11. Install accessory drive belt, refer to the Cooling System for proper procedures.
  12. Install the right front lower splash shield.
  13. Lower vehicle.
  14. Install wiring harness to the oil dip stick tube
  15. Connect battery negative cable.
  16. Verify generator output rate.

Dec 13, 2010 | 2001 Chrysler Town & Country

1 Answer

How do i refill the transmission oil in my 1997 Micra auto (1 ltr). Can't find the cap.


Hi: To Refill your Auto Transmission with Tranny Fluid, There is NO CAP, Look For a Dip Stick Similar to your Oil Dip Stick.You Refill your Transmission where the Transmission Dip Stick comes out of a Tube. You'll Need a Funnel that Fits inside the Transmission Dip Stick Tube. This Should Resolve your Question. Please Vote and That actually sends me How Well I have Helped You. OH Look Towards the middle to the Back of Your Engine to Locate Your Tranmission Dip Stick: From the WYOCWBOY

May 30, 2010 | 1996 Nissan Sentra

2 Answers

How to refill oil in transmission for Dodge caravan 1995 (automatic transmission)?


You refill the transmission through the dip stick tube. Make sure you don't over fill the transmission though, that's just as bad as having low transmission fluid levels.

Feb 22, 2010 | 1995 Dodge Caravan

4 Answers

Oil dip stick handle for Ford Focus ZX3 broke off. Rest of the dip stick still in the tube. How do I retrieve the remaining portion of the oil pan dip stick?


Drill small hole in what's left inside the tube - insert bolt extractor - pull out dip stick. Material is relatively soft so drilling is easy. Buy new dip stick.

Feb 12, 2010 | 2003 Ford Focus

1 Answer

How to check transmission fluid and fill if nessesary.


if it is an automatic transmission, the dip stick is under the hood and should be on the drivers side of the engine,start the car leave it in park,pull the dip stick out and wipe it off with a cloth,reinstall the dip stick in the filler tube completely,and remove again and notice where the fluid level is on the dip stick,if you need to add fluid to bring it up to full,the correct fluid for your car is printed on the dip stick,you need a transmission funnel and put in in the tube you pulled the dip stick out of.
if you transmission is a standard,there is a 5/8 bolt on the side of the transmission you remove and put something like a screw driver in the hole to see where the fluid level is,.

Jan 19, 2010 | 2004 Pontiac Grand Am

Not finding what you are looking for?
1992 Eagle Talon Logo

Related Topics:

41 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Stewart Dibbs

Level 2 Expert

308 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...