Question about 1992 Nissan Maxima

1 Answer

My car runs hart in a drive or reberse but it runs smooth on park and neutro.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Nissan Master
  • 2,019 Answers

There is more friction drag on the engine when in drive or reverse.
The torque converter is intended to slip, but still drains power.
If the engine is not running up to the power it should have, then you will notice the drag more.
I would suspect a vacuum leak from a broken hose, the need for a tune up, etc.
Or you could just increase the idle speed.

Posted on May 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2003f350 start smooth, stay smooth in park when drive run good onto engine get hot, Press gas pedal all way down won't run more than 10mph.


Catalytic converters could be clogged up. remove the pre O2 sensors. If it stays running, replace the converters.

May 16, 2015 | Ford F-350 Cars & Trucks

2 Answers

How do i repair the van dont start,when i shift to neutro and then to parking start?


so it does start in neutral. the cable is out of adjustment. inspect the shifter cable for bad ends. you might need to replace the cable if it cant be adjusted or replace the gromets

Feb 12, 2015 | 1998 Ford Windstar

1 Answer

When you put the car in revers it dosnt go even if you try to push it also doesit in neutro its like its in park you try to push it its like stuck in park if you put it in drive it goes fine culd that be...


The reverse is the gear that is the weakest in the transmission by design. When you have trouble with reverse it is a signal to get your vehicle to a transmission shop before you are in the middle of no where and end up walking home.

Sorry, but it is not something simple that can be fixed by an untrained person! I work on cars all the time but when we find a car with internal transmission faults we send the transmission to professionals.

Aug 17, 2011 | 2003 Suzuki Aerio

2 Answers

Run for 20 minute car turn off in drive position and reverse but mantain on in parking and neutro . example, turn on my cars in the morning,run for aproximali 10 min constantly when stop drive position the...


make sure it is getting fuel, check your fuel filter. the vehicle will run at an idle, but as soon as it is put in gear it may stop. its hard to tell without looking at it but. change fuel filter, also check cam and crankshaft sensor. these will set a problem code, if you do not have a scanner any auto parts store will scan for free. a bad camshaft sensor or crank sensor will make it shut off while driving when engine gets warm.

Feb 09, 2010 | 1994 Chevrolet Cavalier

1 Answer

When put into drive the car shakes and stalls. It


I have a 1989 5-series BMW which sometimes stalls after changing from reverse to drive. It also sometimes shakes when first driving in reverse before changing to drive.

Jan 30, 2010 | 1992 Mazda Protege

2 Answers

At what millage should i change the automatic transmission fluid? The car is shaking when i put it in drive it dosnt shake when is in parking i need to put it in neutro everytime i stop in a light so it...


around 75,000 miles, plus or minus 15,000 or so. when you say shaking, do you mean a rough idle? thats not cause by your transmission per se...

Sounds more like a weak fuel pump, idle controller, or well, theres a bunch of reasons you could have a rough idle.

Jun 20, 2009 | 2002 Kia Rio

1 Answer

2001Pontiac Grand Am Rough Idle In Drive Only


I had the same problem with '99 GA I changed the idle control valve , solve the problem

Mar 23, 2009 | 1999 Pontiac Grand Am GT

2 Answers

Parking/neutral switch


Hi....
The PARKING NEUTRO SWITCH. ( neutro safetly switch).
If you car is an Auto, trans. is a little switch located on just
alittle upper of the trans. on the radiator side. use a Connector of 3 wires. And the switch is Thread installed.

But if your trans is MANUAL.
The switch is on the Clutch Pedal Base.

Ok.. I hope this help on your question.

Thank you for use fixya.

Aug 10, 2008 | 1996 Plymouth Neon

1 Answer

Starting


You need to adjust the Neutro safety switch.
Or replace, Check the shifty cable for any inproper clamps.
or loose clamp..

Jul 01, 2008 | 2005 Chevrolet Cavalier

Not finding what you are looking for?
1992 Nissan Maxima Logo

Related Topics:

52 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...