Question about 2000 Volkswagen Golf

Open Question

Golf 1.6 petrol x reg nearside driveshaft

Golf 1.6 petrol x reg nearside driveshaft lostdrive innerjoint had brokenup fitted new complete driveshaft same thing happend again after 400 miles

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: FIT SEAT BELT

TO GET AT REPEATER LAMP ON O/S MIRROR ON A GOLF TDI SE 2004 REMOVE THE TOP COWLING AND THE GLASS NEXT TWO SCREWS AT THE BOTTOM TO REMOVE THE LAMP NO BULB BUT FIT NEW LAMP

Posted on Jun 21, 2008

  • 10 Answers

SOURCE: Golf mk4 rear door nearside will not unlock and

hi thier you must use this door a lot i guess maybe you have a kiddie in the back on this side of the car.? i think you have broken wires in that door if you look in the rubber boot which joins the door to the car you will see the wires broken join them up and it should all work again make you sure you join the right wires i hope that help you . graham the auto electrician

Posted on May 29, 2009

  • 93 Answers

SOURCE: vw golf x reg fuel gauge not working???

suspect it could be tank unit this is similar to a ball valve in a toilet .float arm moves up or down depending on fuel level sends reading to gauge situated in fuel tank sometimes part of the fuel pump

Posted on Dec 09, 2009

  • 1757 Answers

SOURCE: need diagram for golf petrol twin cam 51 reg

My apologies for the delayed response. I am going back and answering questions that were never answered.
Click on the following Link. It has all the Diagrams for the Timing Belt you will need.
Before Clicking, let me know if this helped.
Again my sincerest apologies,,..

http://www.2carpros.com/car_repair_information/year/2001/make/volkswagen/model/golf/2001_volkswagen_golf_timing_belt_diagram_marks.htm

Posted on Feb 26, 2010

SOURCE: all the oil gone after

When you sat all gone do you mean you can no longer see it on the dip stick? Add a litre of oil immediately and check the dip stick. Once you see oil on the dip stick add just 500ml more an check again, the difference between Min and Max is only 500ml. When topped up inspect the exterior of the transmission casing for obvious oil leaks. When you start the engine is the exhaust smokey blue?...indicative of oil burning. 'Leaks' and 'burning' are the only exit routes for the oil.

Posted on Dec 07, 2010

Testimonial: "thank you joe2mercs - I've been told that the oil could squirt out of the oil pressure switch/seal - cos there's none on the drive. Thank you, John"

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Will a 2 litre vw Golf 2011 diesel fit a 1.6 diesel 2011 Golf


I wouldn't suggest it. It wouldn't be just an engine swap that you unplug and unbolt and and then reverse...thats not to say it can't be done with a lot of thinking and work and reprogramming that's usually for vw experts...your better off to keep looking at other wreckers for the exact motor

Nov 08, 2014 | 2011 Volkswagen Golf

1 Answer

Hi, What is the part number or size of the driveshaft to differential oil seal? Can the oil seal be changed if the driveshaft is removed?


Don't remove any seal until a drip becomes a flow.
quite often you will find when you replace seal any way that the drip still persists.

Aug 14, 2014 | Cars & Trucks

1 Answer

How to replace nearside driveshaft on renault trafic 2010


sorry I can not help you I take mine to the garage

Jun 13, 2014 | 2009 Renault Trafic 1.9dCi

1 Answer

Battery ran flat on my 'R' reg VW Golf gti while I was away in Australia. The alarm was disconnected a couple of years ago but now the immobiliser seems to have triggered as there is no spark or petrol...


sometimes it depends on the type of allarm, if it is factory fitted they are a nightmare to do as most of the wireing for the allarm is intergrated into the loom, where as if it is an after marked alarm ( one fitted later on ) it shouldnt be to bad but still a long and complicated job to find all the wires and reconnect the originals bypassing the immobiliser/alarm if you are a complete novice this should not be attempted as you could immobilise the car completely, best thing for you to do is get an auto electrician to have a look at it for you, sorry its not much help

Feb 15, 2010 | 1999 Volkswagen Golf

1 Answer

Need diagram for golf petrol twin cam 51 reg timing belt marks


My apologies for the delayed response. I am going back and answering questions that were never answered.
Click on the following Link. It has all the Diagrams for the Timing Belt you will need.
Before Clicking, let me know if this helped.
Again my sincerest apologies,,..

http://www.2carpros.com/car_repair_information/year/2001/make/volkswagen/model/golf/2001_volkswagen_golf_timing_belt_diagram_marks.htm

Jan 16, 2010 | 2001 Volkswagen Golf

1 Answer

How do I change the CV joints on a 1.8TD Ford Escort P reg


Hi mate

With the driveshaft removed from the vehicle.

Undo the the retaining straps on the CV boot.

Pull the CV boot up the driveshaft a little way, enough so you can clean all the old grease away.

Now look into the CV joint an locate the circlip that locks the CV to the driveshaft.

Now put the driveshaft into a vice with the CV joint facing downwards.

Now open the circlip and at the same time strike the CV joint. You can do this with a ballpin hammer if you are scrapping the CV joint. You can get a helper to stike the CV joint with a hammer while you keep the circlip open.

This will release the CV joint form the drive shaft.

Now clean the driveshaft of any old grease and fit a new CV boot if needed.

Now reverse the driveshift in the vice and fit the new CV joint. It will tap on with no trouble but do not damage it. Test it is on by trying to pull it off with your hands.

Now fill it with new grease.

Fit the CV boot to the CV joint and secure it to the CV joint.

Now it is ready to refit to your vehicle.

I trust this solves the problem for you.

Ray


Sep 08, 2009 | 1998 Ford Escort

1 Answer

Does anyone know what power steering fluid I need for a VW Passat


Mineral power steering fluid only from dealer $30, 1 gal
other oils have been causing the pump not to operate
properly on 99+ passat, jetta, golf, 99+ a4, a6, a8 .

Apr 26, 2009 | 1999 Volkswagen Passat

1 Answer

Using petrol while switched to lpg


get a fitter to have a look as it sounds like a shut off valve needs some new seals to me

Oct 08, 2008 | 2003 Renault 181

1 Answer

FIT SEAT BELT


TO GET AT REPEATER LAMP ON O/S MIRROR ON A GOLF TDI SE 2004 REMOVE THE TOP COWLING AND THE GLASS NEXT TWO SCREWS AT THE BOTTOM TO REMOVE THE LAMP NO BULB BUT FIT NEW LAMP

Jun 20, 2008 | 2004 Volkswagen Golf

Not finding what you are looking for?
2000 Volkswagen Golf Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...