Question about 1992 Geo Storm

1 Answer

My 93 geo storm makes a clicking noise while driving and turning

Posted by on

  • 2 more comments 
  • existtoexit May 07, 2010

    I checked them and can find anything physically wrong with them, its a constant noise even when im driving straight and it also makes the car vibrate especially while driving fast

  • existtoexit May 07, 2010

    Well it still vibrates when i put in neutral or let of gas, I have been told that its most likely a wheel bearing but I dont think so, when the car is jacked up I can grab the tire and it has about three inches where it moves in all directions.

  • existtoexit May 08, 2010

    yea i can grab it moves, its only on the front right side

  • existtoexit May 08, 2010

    Thank you very much, so I wont be able to change wheel bearing myself? ill have to find a new hub with a bearing in it?


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert whose answer got voted for 20 times.

  • Expert
  • 160 Answers

Have the outer cv joints check please rate this

Posted on May 05, 2010

Testimonial: "Thank you very much =]"

  • 2 more comments 
  • JIMMY SMITH May 07, 2010

    sound like common complaint for axle issue outer joints cause noise and inner joints cause vibration harder acell. when you let off or put in neutral vibration almost stops

  • JIMMY SMITH May 07, 2010

    on both sides?? if you grab top and bottom of tire it should not move any w/pulling out at top and pushing in at bottom and vise versa on the front if it does check other side may need wheel bearings let me know...

  • JIMMY SMITH May 08, 2010

    you have the problem needs a hub,bearing,and seal kit if not a sealed unit this job requires a 20 ton press and experience very danagerous good luck

  • JIMMY SMITH May 10, 2010

    you will have to buy them as two parts and have them installed im not as possitive on yhis car i work on and for toyota however think they are the same good luck


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


mitchells DIY (google it....)
log in and read?
and be lots more than only vacuum on that ISUZU Impulse (clone)
for SURE.
vacuum can be different in Canada than USA and in California.
(smog laws dictate all vacuum devices, most)
no country stated, in USA?, then use mitchells.
EGR and evap are diffr.

Oct 29, 2016 | 1993 Geo Storm

1 Answer

On a 93 geo tracker battery is good turn key and makes a clicking noise is this the relay and if so where is it located

there is no relay.
the clicking is the starter mounted starter solenoid.
im sure car is fix now but no cranks are here. for ever.

Feb 26, 2013 | Geo Tracker Cars & Trucks

1 Answer

I have a 93 Geo Storm it has a squeaking noise in the front end, the brakes work great but just started this anyone know what it might be. thanks

If the squeak is constant, then it is likely the tab on the brake pads making contact with the rotor. It is an audible warning that your brake pads are getting thin. It is easy to check. just jack up one of your front wheels, place car on a jack stand, remove tire and inspect the relationship between the pads and the rotor. Be careful not to inhale brake dust. Most pads contain asbestos , a known cause of cancer. A dust mask would be a good idea.

Good Luck!

Jun 11, 2011 | 1993 Geo Storm

1 Answer

My valves are bent on my 93 Geo Storm. How much to replace?

For a price you will need to call a repair shop. Yes, the head gasket will need replacement, you are going to have the head off, It may cost more than the car is worth.

Nov 25, 2009 | 1993 Geo Metro

1 Answer

93 Geo Storm wont start

Check your starter.


Jun 07, 2009 | 1993 Geo Storm

2 Answers

93 geo needs a jump to drive and dies when running

Get a voltmeter, place the positive lead on the lug off of the alternator, or on the pos. battery terminal when running. ground to chassis or body. ALTERNATOR VOLTAGE: 13.5 or higher at 1500RPM is minimum

Mar 22, 2009 | 1992 Geo Storm

1 Answer

How to replace a heater core on a 93 geo storm possible diagram

try to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 1993 Geo Storm

1 Answer

My sister broke her only key for her 93 geo storm

I believe that the Geo is made/ sold by Chevy, they should be able to cut a new key. if not then try contacting the local car rental companies, (Alamo, National, etc.) as that they can, (sometimes!), make new keys from the VIN numbers. (I used to work for some of them!) good luck!

Dec 30, 2008 | 1993 Geo Storm

Not finding what you are looking for?
1992 Geo Storm Logo

Related Topics:

190 people viewed this question

Ask a Question

Usually answered in minutes!

Top Geo Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Geo Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides