Question about 2006 Chrysler Pacifica

2 Answers

Cannot fill gas tank at full speed

How do you fix canister fill valve

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Chrysler Master
  • 5,763 Answers

The most common problem that i see is spiders built a web inside the vent hose off the canister, take a look inside the hose for a web, sometimes thel make it inside the valve, if thats the case then clean out vent valve or replace,the canister and valve are at rear of car near fuel tank.heres a diagram of it,this will help you locate the vent valve,hope this helps.cannot fill gas tank at full speed - 6278b5f.gif

Posted on May 05, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 72 Answers

When under the car you should see vacuum lines that go to a plastic canister follow these until you come to a part that has a connector on it this valve opens and closes the vent system replace it there is no fixing it

Posted on May 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the purge valve located on a


Could be getting gas in the charcoal canister. Check the vent line and make sure it isn't clogged up. The small line from the tank to the fill tube.

Jul 24, 2016 | Cars & Trucks

1 Answer

Buildup gas tank pressure I the cap off hear the fumes pressure come out


run the fault codes and look for purge valve and canister problems as the tank is not venting correctly

Feb 10, 2015 | Cars & Trucks

1 Answer

Can't fill the gas tank, I had the check valve replaced in the gas line and it work once and now it's back to not letting me fill it. I unplugged it but would like it to work. Any ideas what it may be?


fuel vent Charcoal canister will make it difficult to fill the gas, this canister vents the gas tank and if you overfill the tank then it screws up the Charcoal canister and will need to be replaced, I just found an old canister from the used parts place and had my mechanic replace it, went directly to the gas station and presto no more problem filling gas. DO NOT overfill your tank after replacing canister!

Sep 05, 2013 | 1999 Oldsmobile Intrigue

1 Answer

Service engine soon light came on, replaced gas cap it went off but a week later it came back on, when it try to fuel the truck it spill the gas back out like it is a full tank


One of the most common causes, is blockage in the venting system from fuel entering the vent lines and into the charcoal canister, the fuel gets absorbed by the charcoal canister causing it to swell and block vent lines. the gas tank contains both fuel and air. when you fill it up the gas displaces the air and the air has to go somewhere. but the air that is displaced is full of gas vapor so the gas vapor goes to the vent lines and into the charcoal canister, when the charcoal canister swells up it prevents the air from escaping the tank, canister could be clogged,canister filter may need replacement,electrical connection to the close valve may be open,canisterf might be damaged,purge valve from canister might be clogged,vent hoses might be clogged, the vent hose could be clogged, or the vent hose may have a kink. all this is caused by overfilling the gas tank, getting that last drop of gas in the neck of the fill tube.
good luck!

Aug 11, 2011 | 2005 Nissan Titan

3 Answers

Fuel gauge stops working at half empty and will not let you fill up gas tank at full outlet speed from gas pump


you have 2 recalls
pcm update fuel pump replacement
fuel pump module replacement and pcm software

May 05, 2010 | 2006 Chrysler Pacifica

1 Answer

Can't complete a fill up without the gas hose shouting off


You said the cannister. Their is a fuel pressure valve for the tank that goes bad, and builds up pressure that won't release if the valve/sensor is bad. take it to a Hyunda Dealer on this. This can be dangerous if not fixed properly.

Aug 29, 2009 | 2001 Hyundai XG300

3 Answers

Can't fill the gas tank on 98 Toyota Camry


I have a 2000 camry that I just fixed today. there is a vent tube and valve on the carbon canister that is located just behind the gas tank and above the cross member. this vent tube will get plugged up by ( of all things ) spiders, dirt daubers, and I even had a mouse pack the tube with dog food. Just remove the tube and the valve from the canister and clean them out. You will now be able to fill your gas tank again.

Jul 20, 2009 | 1990 Toyota Camry

4 Answers

Problems fillng the gas tank 2002 Sonata


i just went through that problem

Evap canister / close solenoid and air filter $211- 230.00 in parts

$675- $71.00 at dealships for this small 30 minute task

If no check engine light Evap canister and air filter - fixxes problem 100 %
note:you may be able to get by just replacing air filter- works
rarely

if have check engine- close solenoid and purge solenoid may need replace- you local autozone- like autozone will pull check codes for free

the how to:

Jack car up in rear - behind right rear tire - canister -canister close solenoid & air filter are located in a plastic box with metal strap and one bolt.

Unscrew bolt everything drops down the EVAP CANISTER is held to plastic box by wirer tie . Remove wire tie and solenoid connection.
There is a small metal wire clip the holds the solenoid electrical connection together with a flat screw driver pry up the wire clip , off is okay too , ....it will go back on.

Once you have done all that you have full access there are i believe from memory 3 rubber hoses with clips ......Mark hose connects very important mark the hoses way the going on evap canister with color tape .

Next, remove whole assembly- the solenoid and air filter will come with the evap canister.

Now that have the whole assembly move to your work bench
look to see how the soleniod hook up to the canister and the air filter - now, disconnect the hose to black solenoid and remove the air filter which hook to solenoid and solenoid at same to ......

Next seperate the the solenoid and air filter- you should be air to put your mouth on solenoid and blew air in one hole and out the other- this solenoid is noramlly open- if air dosen't go threw is stuck closed and must be replaced.

same with air filter- this air filter are know for get plugged and should be replaced every 30,000 miles.

Also note: over fill you gas tank , at fill up - can cause the Evap to get liquid gas inside which cause the chorcoal in the filter to swell up and plyug the system up.------ you should when fill up stop pump gas after the auto pump click off on normal work tank and not try to top off you tank.

note: check with your deal for exact wieghts
weigh the evap canister - six pound - replace it- new one is about 4-4.5 pounds - it is just best to replace .The evap holds gas fumes then send to engine so that dosn't vent to

All parts are dealships only -

This is easy fix and normal, for gas fill problems

canister Evap 161.00
canister close solenoid 43.00 may or may not be used
air filter 7.00

not used in this fix- check engine fix use these parts
sensor price ?
purge valve 39.00
canister close solenoid 43.00

Feb 23, 2009 | Hyundai Motor 2002 Sonata

2 Answers

Code p 1446 solenoid valve malfunction in sentra 2005


I have the same problem with my 2005 sentra. It is the vent control valve. The only cheap way to fix this would be to take it off and spray wd-40 and see if it works. You could also get the part form a junk yard. Nissanpartsdirect also has it. I beleive it is officially called the vapor canister.

Jan 04, 2009 | 2005 Nissan Sentra

Not finding what you are looking for?
2006 Chrysler Pacifica Logo

1,333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...