Question about 2005 Dodge Ram 1500

1 Answer

2005 Ram 1500: Engine hastate for a second when stepping on the g...

Engine hastate for a second when stepping on the gas for a stopped position.i replaced the egr value and it still does it. dirty fuel injectors??

Posted by Anonymous on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 395 Answers

It could be that the timing is off just by a little

Posted on May 05, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Shut off the change oil lite in a 2011 ram gas petal trick does not work comes right back on when started


1) turn ignition switch to on position(do not start engine)-- 2) fully depress accelerator pedal slowly three times within 10 seconds -- 3) turn ignition switch to off position --- note if message illuminates when you start the engine the system did not reset. Repeat the process

Mar 06, 2015 | 2011 Dodge Ram Pickup 1500

1 Answer

My dodge ram 2005 1500 hemi smells like gas when I


I'm not sure you would smell a fuel leak from the tank while driving, the tank is located to the rear of the cab, under the bed on the driver's side, you may however have a leak in or near the engine compartment. If this is the case, yes a fire is possible. If you smell fuel when you come to a stop, it may be your fuel cannister, or vent lines are leaking which should trigger a check engine light.
While the engine is running, Check the fuel rails and schrader valves on both sides of the engine manifold for leaks. You can also turn the key to the "RUN" position (do not start the engine.) this will cycle the fuel pump to run for a few seconds to pressurize the fuel system, and you can then check for a fuel leak.
I hope this is helpful to you.

Oct 06, 2014 | 2005 Dodge Ram 1500

1 Answer

How to turn off the light whos says oil change? dodge ram 1500 2008 4,7 liter??


turn the key on then pump the gas peddle slowly three times in 10 seconds turn the key off then start the engine. if the light comes back on .do the presager again. sgm1115_80.png

May 06, 2011 | 2005 Dodge Ram 1500

1 Answer

How do i self program a keyless entry remote for my 2005 ram


ATTENTION: You MUST HAVE one working remote to add one more to the system. If you do not have one working remote right now then these instructions will not work. You will have to have a Locksmith or dealership use a computer to program the first remote for you.


1. Turn ignition to the RUN position (as far as you can go without starting the engine).
Wait for chimes to stop.
2. Using original programmed remote, press and hold the UNLOCK button on the
remote for between 5 and 10 seconds.
3. While holding UNLOCK button, and before 10 seconds passes, press and release
the
PANIC button. A chime will sound to indicate that the transmitter programming
mode
has been entered.
4. Within 30 seconds of the chime, press a button on all remotes to be programmed
into the system including any previously programmed remotes, a chime will
sound after each remote has been programmed.
5. Turn the ignition OFF to exit the transmitter programming mode.


6. Test Remotes


Thank you for using fixya and good luck

May 03, 2010 | 2005 Dodge Ram 1500

1 Answer

Program keless entry for 2005 dodge ram 1500 slt 4.9l engine


ATTENTION: You MUST HAVE one working remote to add one more to the system. If you do not have one working remote right now then these instructions will not work. You will have to have a Locksmith or dealership use a computer to program the first remote for you.


1. Turn ignition to the RUN position (as far as you can go without starting the engine).
Wait for chimes to stop.
2. Using original programmed remote, press and hold the UNLOCK button on the
remote for between 5 and 10 seconds.
3. While holding UNLOCK button, and before 10 seconds passes, press and release
the
PANIC button. A chime will sound to indicate that the transmitter programming
mode has been entered.

4. Within 30 seconds of the chime, press a button on all remotes to be programmed
into the system including any previously programmed remotes, a chime will
sound after each remote has been programmed.
5. Turn the ignition OFF to exit the transmitter programming mode.


6. Test Remotes

Apr 26, 2010 | 2005 Dodge Ram 1500

1 Answer

2005 Ram 1500 4wd HEMI PO406 - EGR


Hey greenlee99, your best bet would be to grab one these manuals so that you have pictures and diagrams along with step by step instructions. It will tell you what tools and parts you need. Can't go wrong with having it.

Feb 15, 2010 | 2005 Dodge Ram 1500

1 Answer

Where is the throttle position sensor at on a 2005 Dodge Ram 1500 Hemi 5.7L v8?


THIS ENGINE HAS ELECTRONIC THROTTLE CONTROL..THERE ARE 2 THROTTLE POSITION SENSORS LOCATED IN THE THROTTLE BODY,COMPLETE ASSEMBLY MUST BE REPLACED IF DEFECTIVE..IT ALSO HAS SENSORS IN THROTTLE PEDAL ASSEMBLY AS WELL..WHAT TROUBLE ARE YOU HAVING?

Jul 09, 2009 | 2005 Dodge Ram 1500

1 Answer

2005 dodge Ram 1500 truck 5.7 Hemi check engine lights comes on


Two things you want to know about the check engine light on any vehicle. One is it's an emission warning. The most common cause is a loose gas cap, make sure it clicks when you gas up. Second, is that being an emissions light, is that it'll require some test equipment to find the problem if you checked the gas cap and it's tight. You will want to do that at your friendly Dodge dealer. Why? They'll not only know what it is, it might be fixed free in the emissions warranty which has some parts that are covered longer than the vehicle's regular warranty. The shop on the corner doesn't do warranty work and they're not going to tell you if it might be covered.

Jun 14, 2009 | 2005 Dodge Ram 1500

1 Answer

2001 dodge ram 1500 4wd


I think you're describing a classic case of "hesitation." Basically, the engine hesitates when you step on the gas. I would start by checking the timing with the engine at operating temperature to be sure it's within spec.

Jul 10, 2008 | 2001 Dodge Ram 1500 Truck 2WD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...