Question about 2000 Honda CR-V

2 Answers

Honda 2000 CRV Car just died no spark even after replacing the coil,cap,and rotor.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 72 Answers

I would check the crankshaft sensor

Posted on May 05, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,857 Answers

Other two options are a crank sensor and ignition module. If you have a way to check RPM you should have about 200 cranking. If no rpm then crank sensor is bad and this could be tested if you know how with a digital meter. If you do have rpm most likely the ignition module or worse case scenero computer failed. If your extremly lucky you just popped a PCM or IGN fuse

Posted on May 05, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

99 Honda crv I'm driving the car just dies doin any speed pull off rd try to start it it takes awhile but dies again scary any answers


Check fuel pressure, check engine codes, check for spark when it is dead. Spark related might be distributor or cap or rotor. Check codes for free at autozone unless you buy a obd2 scanner from them.

Mar 05, 2016 | Honda Cars & Trucks

1 Answer

Engine died while driving, no spark, replaced coil, now starts, idles, runs well at low rpm, but misfires when accelerating. No check engine costs thrown. What should I check next.


Change your ignition module. The distributor is a weak point of the Honda, I will always change out the whole thing than just try the coil.

Jun 05, 2015 | 1996 Honda Civic

1 Answer

2000 Honda CRV won't start, turns over, no spark


Do you have a spark at the coil? Try pulling off the cable, and with somebody inside to crank the engine, check to see if there is a spark jumping from the center high-voltage terminal. If you have no spark, you may have a bad coil or bad electronic ignition module.

Jan 12, 2014 | 2000 Honda CR-V

1 Answer

Spark


The best i can say is check to be sure the distributor is turning.I am assuming that when you say you replaced the distributor that indeed you replaced the entire thing.(not just cap) Take cap off turn engine over and have someone watch to be sure rotor is turning. IF you haven't already check for voltage (12) going to coil .

Nov 26, 2013 | 1991 Honda Accord

1 Answer

My honda died on me while I was driving.I got it towed to my home,after droppihg the car in my driveway I got in the car and started as if there is nothing wrong with it.what could cause this.could it be a...


The most common reason for this would be a bad distributor or coil, the distributor contains modules and other components, depending on the type of the distributor the coil may also be part of it, i would star by running the engine until it dies and then check it for spark, if theres no spark then i would start with a coil and then if that doesnt help i would replace the dist, note; make sure to replace the distributor cap and rotor also, with coil first, then replace the dist if the car still dies out. good day.

Jul 16, 2011 | 1995 Honda Civic

1 Answer

Hi I have problems with my car can you help me It`s a HONDA CRV and the scanner give a code P1399


P1399 - Random / multipe cylinder missfire detected.

Need to check coil pack, spark plug wire's for spark, also replace spark plugs if not replace yet.

Jan 15, 2010 | 2000 Honda Accord

Not finding what you are looking for?
2000 Honda CR-V Logo

Related Topics:

463 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...