Question about 2002 Subaru Forester

1 Answer

I have a 2002 subaru forrestor. do i have to pull the motor out to change the valve cover gaskets. because theres oil leakin where the spark plugs are.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Subaru Master
  • 75,797 Answers

No u don't, u do that from under the car.

Posted on May 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1999 Subaru Impreza sport wagon had a misfire in cylinder 2, after I changed all four spark plugs and fuel filter the problem got worse. Now the throttle lags and misfires only happen when the car...


Check the firing order tu might have installed it differently, clean the Hi-TENSiON wire terminals on the distributor cap and to spark plugs, oxidation makes contacts to these points might have attributed to the problem! The oil must have leaked from the o-ring seals around the TUBE where u put the spark plugs! It also makes the spark plugs misfires! Replacing these o-ring seals, u have to pull down the valve cover, u will see the rubber around the tube, pull it off and replace w/ new one, clean the area first and put a little silicone sealant! Put everything back! Thats it! Taaah!

Nov 12, 2010 | Subaru Impreza Cars & Trucks

2 Answers

I pulled a spark plug to change plugs and the spark plug wire boot was all wet from oil. The other three plugs were fine. The rest of the engine looked fine apart from the regular dirty engine look. No oil...


yes, the valve cover gasket is the only thing that can cause this, and yes, you have to remove the cover and put a new gasket in to fix. Please let me know if you have more questions.

Sep 09, 2010 | 1996 Saturn SL

1 Answer

I have a 2003 Subaru Baja with 126k. Recently has developed what I thought to be a misfire. When I pulled the spark plugs they were loose and covered with oil. I changed the wires and plugs and still have...


I would replace the filter and verify the fuel pressure. should be 30-40psi but I dontt have the exact spec. The oil in the plug tubes may be caused by leaking valve cover gaskets.

Sep 06, 2010 | 2003 Subaru Legacy

1 Answer

Changed the spark plugs and the old ones were covered in oil


Your valve cover gasket is leaking, allowing oil to get into the spark plug holes. You'll need to replace the valve cover gasket.

May 14, 2010 | 2000 Saturn SW2

2 Answers

Changed the spark plugs and the old ones were covered in oil


i'm guessing that your car is a 4-cylinder. this is common for inline 4-cylinder engines. since the spark plug holes usually go through the valve cover, the valve cover gasket will leak and collect in the spark plug holes. to fix this you will have to replace the valve cover gasket.

Mar 23, 2010 | 2000 Saturn SW2

2 Answers

I have an oil leak in a spark plug chamber how do is fix it


depends where the oil came from.of it has leaked down from a valve cover gasket,that is not hard to fix.if it a leaking valve seal that is expensive and if the head gasket is leaking,expensive.look at the outside edge of the valve cover,and check the edge for oil.if there is alot of oil,by the time the plug is unscrewed oil can go inside.the oil would burn off,so if there is oil inside it is dripping down probably from a valve seal.take off the valve cover and inspect the seals they are probably no good.there are 2 seal sets,one is in the valve cover,and that results in oil on the outside of the plug,and the actual valve seal which results in oil in the inside of the engine.

Jul 13, 2009 | 2002 Nissan Maxima

1 Answer

1996 Toyota Corolla Valve Cover leaking oil


i have a 1996 1.3 toyota corolla and i changes my roccer cover off a glanza turbo and my car leaked oil we changed the gasket but still seemed 2 b leakin a small bit we also put on gasket sealer now the car is not leakin oil but the oil light is commin on only when the car is under 1000 rpm does any1 no wat is worng with it?

Apr 07, 2009 | 1996 Toyota Corolla

1 Answer

Oil on spark plug


no, not a blown headgasket, remove the valve cover and inspect the spark plug hole seals(tube seals in the valve cover) replace if brittle and old. also change the valve cover gasket since u have it off...adjust the valves as well

Apr 05, 2009 | 1997 Honda Accord

Not finding what you are looking for?
2002 Subaru Forester Logo

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Subaru Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Subaru Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...