Question about 1992 Buick Park Avenue

1 Answer

If i floor the gas it cut,s out - 1992 Buick Park Avenue

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 59 Answers

Thats called an engine rev limiter which is a protection for the engine so it doesnt blow up

Posted on May 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to drop fuel tank on 1988 surburban


Drain the gas tank. I didn't have a lift so I used a floor jack under neath the gas tank. I used a piece of plywood on top of floor jack that would fit between tank straps. Take the fill tube loose, take fuel lines and electrical connectors loose. Take tank straps loose,you may have to drop tank a little to reach some connections. If I remember correctly the fuel pump is in the middle of tank. I don't know if you would want to cut hole in floor of surburban to reach pump? I don't have any info about cutting that hole, if you try that, that is your responsibility.

Dec 11, 2016 | 1988 Chevrolet Suburban

1 Answer

Where to cut ecces hole f0r fuelpump replacement


Not a good idea to do this. If you cut threw a fuel line while cutting the floor, You will catch the vehicle on fire. This would be very difficult to put out, because the fire would be between the floor and gas tank.

Apr 15, 2016 | 1990 Ford Bronco

1 Answer

Have to hold the gas peadel to the floor to crank when idle put in gear it cuts off changed spark plugs


This could be a bad connection at the crankshaft sensor. Check your TPS switch too.

Apr 24, 2015 | 2000 Mercury Grand Marquis

1 Answer

My Chevy cavalier 99 takes a sec to start I have to hold gas pedal to floor been like this fo at least a year I changed full regulator any suggestions it's a 2.2


if the car is fuel injected, holding the gas pedal to the floor will actually cut off your fuel injectors - which may make it worse. You need to check fuel pressure, you want to make sure the fuel pump isn't bad. Also, check your battery.

Hope this is helpful :-)

-Scott

Feb 19, 2015 | 1999 Chevrolet Cavalier

1 Answer

92 jeep cherokee will not start when hot,starts when you hold the gas pedal to the floor ? Then runs ruff cuts off.


replace the fuel filter then check the air/fuel mix needle valve according to manufacturer specs. Sounds like you have way to rich a fuel mixture.

Aug 08, 2014 | 1992 Jeep Cherokee Sport

1 Answer

Peugeot 206 stalling, either cuts off or I floor the gas pedal


When you "floor the gas pedal" the computor goes into a bypass mode (emergency mode). This honestly sounds a lot like a problem I ran into a while back on a Dodge truck. Problem was a cracked intake manifold (plastic). Short version: vacuum leak.

Dec 11, 2013 | 2001 Peugeot 206

1 Answer

When you put the gas peddle to the floor it spits and sputters


check fule filter,check rubber hose if equiped, at tank,may be hard to tell by sight,
I have had cars that would run fine when driven slowly but when floored promptly died.
I finally found it , and that is what it was,the little rubber hose that connects the steel gas line to tank,for whatever reason , was collapsing when car was floored cutting gas flow off robbing engine of fule
if you can easily pinch the rubber hose that could be the problem.
I haven't seen that one for a while(nostalgic)
I hope this helps!

Oct 05, 2011 | 1996 Chevrolet K1500

1 Answer

The car cuts out if i press the gas to much


You are probably hitting fuel cut off.This is built into the engine to keep you from engine damage.Usually at 3k to 3300 rpm`s.Hope this helps.Good luck.

Apr 20, 2010 | 1997 Oldsmobile Aurora

1 Answer

Why not cut a hole in the floor above the gas tank and remove the fuel pump that way. Probably a dumb question, but I need the ask. Thanks


some have a trap door in floor board to get to fuel pump, check it out.
need to take tank out to cut hole anyway :(

Sep 08, 2009 | 1994 Plymouth Grand Voyager

2 Answers

What is the best way to access the fuel pump to repalce it without adding expenses? They want to cut the floor and do it. Will this cause problems in the winter? We live in Michigan with a lot of deep...


Too bad GM doesnt provide a cover to access tank without dropping the tank. I would think creating this "hole" would be quite the endeavor and done correctly would add quite the additional time and expense. Decline cutting holes and drop the tank in order to service the pump/sender. Any reputable repair firm should or would never recomend this measure in order to access the pump in the fuel tank I would hope....

Jul 10, 2009 | 1997 GMC Jimmy

Not finding what you are looking for?
1992 Buick Park Avenue Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Buick Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Buick Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...