Question about 2003 Kia Spectra

1 Answer

Where is the knock sencor - 2003 Kia Spectra

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Kia Master
  • 17,970 Answers

It is bolted to the block beside the crankshaft pulley,it reads the crank pulley.

Good luck (remmeber comment and rated this).

Posted on May 04, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is a knock sencor. can show me an image inside the engin?


A knock sensor detects pre-ignition (ping). It is an engine protection device which retards ignition timing when pre-ignition is detected. Normally located on the engine block behind the exhaust manifold

Aug 13, 2015 | Cars & Trucks

1 Answer

Where is the knock sencor on a 1992 Blazer


The knock sensor is J, in the picture. Note vin.knock-sencor-1992-blazer#solution-section-tgdpj5bc1lhzttcuvramaekd-2-0.jpg

Nov 16, 2014 | Chevrolet Blazer Cars & Trucks

1 Answer

Knock sencor on 1999 Trans Am.


Location of the knock sensors? I think this is the LS motor and they are under the Intake manifold ...here is picture link..

Jun 14, 2014 | Cars & Trucks

1 Answer

My Infiniti Q45 Has a knock sensout that is out..Left bank. Would this cause my engine to have a loud knocking sound? Sometimes it knocks and other times it's quiet. I took it to a mechanic and he t


I would go with the engine being bad.
A knock sensor only sends a signal to the engine computer when there is a vibration or noise like a spark knock. The computer then adjusts spark timing to compensate.
If the engine is knocking such as a bearing knock, the sensor will be activated.

Jan 31, 2014 | Infiniti Cars & Trucks

1 Answer

Knock sencor problem were do I find it on A 03 Nissan etterra


Knock sensor is on the side of the block under the exhaust manifold. Either the drivers side or the pass side, just depends.

Jan 02, 2014 | Cars & Trucks

3 Answers

Nissan pathfinder 1998 code p0325 what sencor is it there are 4 Sencors ???


It is the knock sensor. But before you do anything first check the vacuum line which is on the front right tire on the rear side of the tire where small hose from charcoal canister up over the shock to the purge valve. That vacuum hose from the purge valve connected to a metal hose and then the metal hose connected back to a rubber hose on the purge valve. that metal hose because it gets rusted cause a leak causing Injector 2 to missfire.

Aug 18, 2012 | 1998 Nissan Pathfinder

1 Answer

Knock sencer showing up when get checked with light on what to do? when does timing belt need to be changed?


knock sencor switch needs replaced,unless this car has a very high milage and has a major problem.on starting in the morning when engine is cold is there smoke from exhaust with a hint of blue in it if so engine needs major repair.timing belt every 50,000 mls.adrian,,,,

Dec 04, 2010 | 2001 Kia Spectra

2 Answers

If the light on my engine comes on for knock sencor if i replace it later will it hurt the truck


The engine can definitely be damaged if the computer cannot detect knocking in the engine. Strongly recommend u replace it as soon as possible.

Mar 11, 2010 | 2003 Chevrolet Silverado 2500HD

1 Answer

1993 full size blaser 5.7 code 43


Check for a 5 volt reference signal at the wiring to the knock sensor. With key on engine off one of the wires to the sensor should have 5 volts.

Dec 26, 2008 | 1993 Chevrolet S-10 Blazer

Not finding what you are looking for?
2003 Kia Spectra Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

yadayada
yadayada

Level 3 Expert

76691 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...