Question about 1990 Nissan Hardbody King Cab

1 Answer

My 04 hardbody keeps cutting out wont start engine light flashing then next day it will be fine, untill the next time

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Master
  • 395 Answers

Check the egr valve on it

Posted on May 06, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What can be wrong if scan tool cannot connect to ecu of Nissan hardbody 2006 4x4 3.3i v6


Does the scan tool light up, but doesn't connect. It could be wiring or the ECU. If the scan tool doesn't light up, check fuses. Most DLC connectors are power by the lighter /power point fuse.

Feb 07, 2015 | Nissan Cars & Trucks

1 Answer

Hardbody 2.4 cranking only not starting


check starter relay its blue on the right side in the engine compartment

Jan 19, 2015 | Nissan Hardbody Cars & Trucks

1 Answer

I have a 2005 Nissan Hardbody 3.3l V6 4x4. In the morning, you start and drive for long hrs no issues. The problem starts after switching it off, and when its hot. It cuts off, you crank up until batt


Sounds like a "HOT SOAK" problem.
Starter gets hot,it lacks power to crank the engine.

Possible "Vapor lock".

Check for engine codes.Possible bad temp sensor for ECU.

If fuel delivery is suspect ,try starting fluid into intake when "no start" occurs to diagnose fuel problem.

May 19, 2014 | 2007 Nissan Hardbody 3000TD

1 Answer

Renault trafic wont start...engine warning light flashing


The light and the word stop should be sending you a clear message . The engine hard starting and sluggish is also sending a message and if you do not heed the message and have the fault codes read and the problem fixed then the next message may be replace the engine or gear box . The light is there --not to be an annoyance ---but to inform you that something drastic is going wrong and it needs urgent attention.

Mar 09, 2014 | Renault Cars & Trucks

1 Answer

First of all. We have put 2 new starters on this car recently. We thought the first might have been a fluke. However we had the 2nd checked and it tested fine as did the battery and alternator. Problem is...


what do you mean by wont start?? engine cranks but wont run? engine wont crank? Is the anti-theft light flashing? is the car in park? did you put it in Neutral and try to crank it?

Nov 19, 2010 | 1992 Saturn SL

1 Answer

Cuts off, but will restart, then cuts off again


Likely, you have a damaged engine bearing. When there is a problem there it will turn oil pressure light on because bearings keep the pressure inside the crankshaft...It may stop as the bearing overheats and binds, then loosens up a bit allowing a re-start when it gets cooler. Battery sounding dead is likely because the engine is locking up and too difficult for starter to turn.
At this point, it is not a do-it -yourself project ...either you need a lower end rebuild or engine replacement.

May 28, 2009 | 2004 Jeep Liberty

1 Answer

Car wont start - starter only turns for seconds, then cuts out


Very common problem mate. Get the TDC crank sensor replaced. Of course it will drive you crazy until replaced. Takes time until it fails completely. Cheers

May 23, 2009 | 2005 Renault 18I

2 Answers

I HAVE A NISSAN d21 2.4L 1987 hardbody pick up as im driving when i let up on the gas pedal it seems to stumble just a little bit then it seems fine after that ???


Sounds like it could be faulty fuel injectors. (unless of course, it's carburated, then it'd be a poorly adjusted float)

Apr 15, 2009 | 2006 Nissan Sentra

1 Answer

Ford Freestar--engine cutting out


I'd like to come into contact with to purchase your vehicle

Nov 18, 2008 | 1990 Suzuki Swift

Not finding what you are looking for?
1990 Nissan Hardbody King Cab Logo

240 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...