Question about 1997 Dodge Intrepid

1 Answer

How much is the labor to put in a engine in my 1997 dodge intrepid

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 109 Answers

On an average 500.00 to 800.00 depending on what shop you take it to

Posted on May 13, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a problem with my 1997 dodge intrepid, engine controlr. fuse keeps blowing every time i try to start it. where do i start troubleshooting?


check wiring at the starter for any grounded out wires from their trace to starter relay and then move foward

Aug 29, 2012 | 1997 Dodge Intrepid

1 Answer

Can i put a 2001 dodge intrepid half shaft on a 1997 dodge intrepid? I have both cars and trying to gut one out for another


If the two cars have similar engine/trans setups,measure the half shafts with a tape measure to compare as much as possible.If they seem to be close enough,you can probably swap them.(Sometimes,minor design changes may alter the appearance of parts,but they will still work.)

Aug 08, 2012 | 1997 Dodge Intrepid

1 Answer

We have a 1997 Dodge Intrepid. Heater, defroster blows ice cold air. Where is the vacuum line to open and close the warm air, cold air door in the heater system? It seems to be drawing cold air from the...


The Intrepid doesn't have a vacuum line. It uses a electric motor called a "blend door actuator". It's located on the underside of the heater box near the center of the car.

Jun 14, 2017 | 1997 Dodge Intrepid

1 Answer

NEED TO REMOVE STARTER AND DON'T KNOW HOW


I found your solution (with pics) at:
http://www.autozone.com/autozone/repairinfo/repairguide/repairGuideContent.jsp?pageId=0900c1528006a865

However, www.autozone.com will expect you to register (free) to access their repair guide database.
Note: The Intrepid 3.5L engine takes the Delco starter, while the Intrepid 3.3L engine takes the
Nippondenso starter.
How can you tell which engine's in your Intrepid? read 8th digit of the VIN code.
VIN code "F" - 3.5L 6cyl MFI (multi-port fuel injection) - 60% of 1997 Dodge Intrepids sold
VIN code "T" - 3.3L 6cyl MFI - 40% of 1997 Dodge Intrepids sold

Oct 25, 2010 | 1997 Dodge Intrepid

1 Answer

1997 dodge intrepid 3.5


Transmission control solinoid. Trouble code should give you the awnser.

Mar 15, 2010 | 1997 Dodge Intrepid

1 Answer

DODGE INTREPID WATER LEAK, WATER IS IN THE DRIVER SIDE FLOOR.


Do you have any heat in the heater if not the water is most likely coming from a bad heater core leaking. If it is sorry to break the bad news. You have to take the dash out and some parts in the engine compartment. Heater core is reasonable to replace but the labor will kill ya. Good luck

Jan 27, 2010 | 1997 Dodge Ram 2500 Club Cab

1 Answer

Where's the crank shaft sensor???


1997 Dodge Intrepid 3.5L MFI 6cyl

The Crankshaft Position Sensor is located: Under hood, driver side, lower engine area, mounted on side of transaxle housing

Good luck (rated this help).

Sep 24, 2009 | 1997 Dodge Intrepid

1 Answer

Engine shakes


You need to check for codes first. However,you can visually inspect the spark plug wires.

Jul 15, 2009 | 1997 Dodge Intrepid

1 Answer

1997 dodge intrepid 3.5 engine problem.


It can be but choose a mechanics that is expert to that. Because its called converting, to that 1997 dodge Intrepid car you have.

Jul 06, 2009 | 1997 Dodge Intrepid

1 Answer

Is a 1997 Dodge Intrepid 3.5 a high out put motor?


It ain't a viper , but it has quite a good amount of power.
Pulls a intrepid good if you step on it.
Have been told that the 3.5 is a bit sketchy , may throw a rod out the side of the block more often than the 3.3

May 05, 2009 | 1997 Dodge Intrepid

Not finding what you are looking for?
1997 Dodge Intrepid Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...