Question about 1998 Chevrolet Cavalier

1 Answer

How do I remove the starter on a 98 2.4 chevy cavalier

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 2,309 Answers

Jack up thecar and put it on stands, disconnect the battery the starter is behind the radiator on the rear of the engine, remove the two bolts that hold the starter on, then lower carefully not to pull the wires apart, disconnect the signal wire firle the the main, just reverse to install

Posted on May 04, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

98 chevy cavalier 2.2 will not crank. It's not the starter or battery as lights, dinging chime, and fuel pump engage...I turn the key and silence.


It sounds like the solenoid isn't sending fire to the coil while cranking. When cranking the voltage comes to the coil from the starter to by pass the coil resistor. Once cranked it starts going through the resistor to keep excess voltage from frying the coil.

Feb 05, 2011 | 1997 Chevrolet Cavalier

1 Answer

98 chevy cavalier 2.2....replaced starter...car wont turn over..no clicking...battery ok. car will start by jump starting the starter with a screw driver...replaced fuses...any idea what could be wrong?


Sounds like bad battery cables and/or ignition switch. I would clean battery cables thoroughly with wire brush especially the bottom end since they're exposed to road grime, etc... Also check to make sure you put small wires on solenoid on correctly. I've seen people get them reversed because they're looking at them upside down when attaching from under car. More than likely it's those small wires on solenoid.

Jan 03, 2011 | 1998 Chevrolet Cavalier

1 Answer

Does starter fusible link wire stay hot with key off on 98 chevy cavalier


the fuseable link does stay hot i provides power to the car

Feb 09, 2010 | 1998 Chevrolet Cavalier

2 Answers

Starter problems


not likely on a 98,u sure ur wired it right to right,umm ignition isnt sticking?

Aug 26, 2009 | 1998 Chevrolet Cavalier

1 Answer

What is the gap for 98 chevy cavalier?


The spark plug gap is .050". Hope this helped and best wishes.

Aug 26, 2009 | 1998 Chevrolet Cavalier

1 Answer

Reinstall of Starter 1998 2.4L Chev Cavalier


moz-screenshot-4.jpg
  1. Disconnect the negative battery cable at the battery.
  2. Raise and safely support the vehicle.
  3. Remove the electrical connections from the back of the starter.
  4. Remove the bell-housing cover.
  5. Remove the starter support bracket bolt from the engine block.
  6. Unfasten the starter motor-to-engine bolts, then carefully lower the starter.
  7. Remove the nuts/bolts that hold the starter support bracket to the starter.

To install:
  1. Transfer the starter support bracket to the new starter if the starter is being replaced.
  2. Raise the starter into position and secure the starter using the starter motor-to-engine bolts. Tighten the bolts to 32 ft. lbs. (43 Nm).
  3. Install the starter support bracket-to-engine bolt to 24 ft. lbs. (32 Nm).
  4. Install the bell-housing cover.
  5. Install the starter electrical connections on the back of the starter. Tighten the S terminal to 22 inch lbs. (2.5 Nm) and the battery terminal to 106 inch lbs. (12 Nm).
  6. Carefully lower the vehicle, then connect the negative battery cable.

2.3L (VIN D) and 2.4L (VIN T) Engines
See Figure 10


0900c1528003cb99.jpg

Apr 08, 2009 | 1998 Chevrolet Cavalier

1 Answer

How do you get the starter out of 1988 chevy S-10 pick up 4 wheel drive 5 speed trans


Generally there are two bolts holding the starter in.  I have a 98 cavalier and I recently replaced the starter.  Not hard but not too easy either.  You might have a little more room than I did so it houldn't be too hard.  Go to autozone.com.  They have free online repair manuals.  Good luck.

Jan 06, 2009 | 1987 Chevrolet S-10 Pickup

1 Answer

Slow starting


no but we are basically volunteers that answer your question... when i have a moment to give you a more informed answer i will... personal issues i need to attend to first. be that as it may you may get an answer from someone else.

take care

Robert

Sep 25, 2008 | 1998 Chevrolet Cavalier

Not finding what you are looking for?
1998 Chevrolet Cavalier Logo

175 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75744 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...