Question about 1992 Honda Civic
Its easy just take of the distributor cap off without removing the cables. The cap should come off easily with three little screws. Once u have done that place it aside and the distributor has three main bolts they are size 14mm. Once u have done that the distributor should slide out of the engine, just make sure u look at how the angle of the distributor is assembled in the camshaft before putting in the new distributor.
Posted on May 05, 2010
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
Why do you think the Distributor is out? It's not hard to replace if you have the Haynes repair manual for your vehicle and understand how to get to TDC and line up everything. But it is very rare that a Distributor goes out. If it is not turning it is more likely that your timing Belt has broken than the distributor going bad.
Posted on Dec 03, 2009
No your alternator is not longer working correctly. It could be as simple as a broken alternator drive belt. Open the hood an see if you see any naked pulleys. If the belt is in place then you most likely with have bad alternator. NAPA and Autozone have stores that can test your old alternator. Con comeone into removing it and have it tested. If it is bad get a REBUILT one. A new one will cost a small fortune!
Posted on Jan 21, 2010
my friend !its ease to replace it first of all keep in mind the fring order or its better if ur new write down the fringorder.
bring new distibuter of honda 1996 & then open distubeter cap with screws & c router possition coz where u c that position U have to put it back there .
then open 3 bolts & pull it out .you dont have to worry about if u do some thing wrong coz u cant do wrong .coz remember first position where was the router...
just replace it with new distubeter & posh it back in to it......
just screw the bolts back where u take off so it ll be fix thenput back bistuber router& cap with screws..then fring order is same but if u replace cap then take out your paper where u write the fringorder,,,,
its just eseay then crank ur engine with key swich & it ll stare.....ooh one think more dont forget to put distubiter grip on it......
do let me know when u finish it ...tc
Posted on Mar 12, 2010
Tips for a great answer:
Dec 10, 2017 | Honda Cars & Trucks
Jul 23, 2011 | 1992 Honda Civic
Jun 20, 2011 | Honda Civic Cars & Trucks
Sep 21, 2010 | 1992 Honda Civic
Feb 17, 2010 | 1999 Honda Civic
Mar 02, 2009 | 1992 Honda Civic
Feb 21, 2009 | 1992 Honda Civic
Jul 29, 2008 | 1995 Honda Civic
163 people viewed this question
Usually answered in minutes!