Question about Isuzu Pickup

Open Question

2006 isuzu npr stalled while braking, now it wont start. no trouble codes, it has been to two shops now and no-one can find a problem, it cranks but just wont start.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
stevenhurc
  • 450 Answers

SOURCE: cranks, but no start. spark and fuel good, no

cam timming is possibly out due to gear reduction set up in heads
suggest remove rocker covers and make sure cam lobes are in this possition as well as all other timming marks luckily these engines (V6) are free wheeling (wont bend valves) set up like pic below

5b1d17c.jpg

Posted on Nov 07, 2009

Ad
Shorty1_wt
  • 324 Answers

SOURCE: isuzu npr 5.7 gas not starting on its own

sounds like its time to replace the fuel pump.

Posted on Feb 05, 2010

  • 1 Answer

SOURCE: 04 cavalier car stalls and wont rev over 2k trouble code po108

http://www.hotrodlane.cc/New%20LS%20Links%20Page/LS%20trouble%20codes/DTC%20P0108.htm

I could be wrong, but I believe that's the code you are looking for. MAP Sensor [ manifold absolute pressure ]. I googled the engine code for a chevrolet so I hope that helps you.

Posted on May 09, 2010

SOURCE: are there any thing to

The exhaust brake may be what you're looking for. The operation is usually by way of a stalk control or maybe a switch mounted on the dash in easy reach of the driver. When its active it works when you release your foot from the gas pedal and restricts the gas being exhausted from the engine, thereby slowing down without the use of the brake. Don't try to use it to stop! Its there for mountaines terain and steep hills....Over use can over heat the engine and cause cylinder head damage.

Posted on Oct 02, 2010

Testimonial: "someone else told me the same thing i wanted to be sure thanks very much"

  • 3 Answers

SOURCE: 2000 isuzu npr

if you have already replaced the booster, it is probable that the vacuum pump is the culprit.

Posted on Dec 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 Isuzu NPR gauges not working and trans wont shift


huge NPR truck this is no over 14,000 lb truck forum
not at all.
cluster dead.
trans will not shift.
try fuses.
ever heard of them>?
if fuel gauges is dead, is it, fuses.

Jan 18, 2017 | Isuzu Cars & Trucks

2 Answers

Need a wiring diagram for 2006 isuzu npr 300 stereo so i can fit a new stereo


youd need the NPR heavy truck, FSM book page on radio wiring
buy book at any Isuzu heavy truck dealer.
we dont now what radio option cam on that NPR
nor what country , other countries use different radios.
so..... this is USA forum, and we dont have NPR books.

Jun 09, 2016 | Isuzu Cars & Trucks

1 Answer

I don't know how to change fuel pressure regulator in my Isuzu 2007 NPR can somebody give me a hand on that


this is no heavy truck forum. its only light and cars.
NPR what, (the number)
and what engine? fuel parts match up to and engine.
no year NPR. wow. and have gas or diesel engines.
no fuel stated either.
NPR started in USA in 1985 (this is USA forum)
this?

26185177-qvvdcm34jvcwbumk4o5kywm4-3-0.jpg

May 04, 2016 | Isuzu Cars & Trucks

1 Answer

2000 Isuzu npr no power to brake switch.i checked fuse it has power


bad wire or bad connector
work from switch to source of power.
you will find the cause.
using a meter. a volt meter.
the exact point that goes from 0v to 12v (keyon, brakes on)
is the point of failure. (ohms laws and Kirchoff's)

main 12v>>>>fuse >>>>> ignition switch>>>>brake switch>>> lamps. >>>>lamps to ground.

check voltage at each point and BINGO. your answer.
its just a series circuit no more complex than a flash light.

i have no NPR drawings, they are very hard to get... in USA.

Mar 05, 2015 | Isuzu Cars & Trucks

3 Answers

2002 Isuzu rodeo stop while driving wont start


Need more information. Could be fuel pump, fuel filter, crank sensor, cam sensor. Starter??

Oct 16, 2014 | 2002 Isuzu Rodeo

1 Answer

2006 isuzu npr 5.2L Diesel


Slider pins should be replaced and antilock mechanisms cleaned with brake cleaner. If that doesnt help then its calipers. And yes they do stick at the same time if they both have sat for a long time. Good luck!

Oct 17, 2013 | Isuzu Cars & Trucks

1 Answer

Crank trigger sensor code be related to timing belt problems


Rather than have people here guessing at the
unknown & possibly continuing to drive the car,
which you probably should not have been doing
for thast last couple weeks,have a repair shop at
least check it out,before you do some possible
serious damage

Jun 23, 2012 | 2006 Kia Rio

1 Answer

1999 isuzu npr how do you get transmission codes without a scanner?


Use a paper clip to connect terminals #4 & #11 of the DLC (OBDII) 16 pin connector located near the driver side kick panel. Turn the ignition to the ON position, DO NOT START. The CHECK TRANS light on the dash will flash any stored trouble codes. Codes will be repeated three times each. Flashing will continue until the jumper wire (paper clip) is removed. Here is an image of the DLC:11_2_2012_10_55_13_pm.jpg

Jul 29, 2011 | Isuzu MU-7 Cars & Trucks

1 Answer

2000 isuzu npr brake booster servo unit replaced brake booster light still on on dash no brakes?


if you have already replaced the booster, it is probable that the vacuum pump is the culprit.

Apr 10, 2010 | 1995 Isuzu Pickup

2 Answers

Isuzu npr 5.7 gas not starting on its own


ok I had same problem with my 1996 Isuzu npr 5.7 gas burner. on top of fuel tank are wires and cant remember if it was 3 or 4 but anyways one of those wires is your ground wire to the fuel pump its self. make sure the wire has a good ground on the frame and/or the bed body of the truck. wish you the best hope I could help you

Feb 05, 2010 | 2001 GMC W3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

215 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...