Question about 2002 Pontiac Sunfire

1 Answer

Turns over will start but only for a few moments

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Pontiac Master
  • 6,826 Answers

Ignition module is bad

Posted on May 04, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

99 grand marquis let out with air decompressing sound when it died on three tries

Timing may have slipped causing an intake valve to be open at the wrong time.

Jan 09, 2014 | 1999 Mercury Grand Marquis

1 Answer

No power when i turn the key

Sounds like a bad ignition switch or a bad main electrical connection between the battery and the switch. Check all the battery connections and grounds for clean tight connections. Check for power going to the switch.

Oct 23, 2012 | GMC C1500 Cars & Trucks

1 Answer

When I start the car it stays at 2000rpm for a few moments then drops down. I'll drive for a few minutes then put it in park and it revs up and down.

idle air control valve is bad replace it. at start up choke control runs till warm up while driving throttle opening controls engine at idle ,the idle air control valve.

Aug 01, 2012 | 2005 Chevrolet Aveo

1 Answer

Can i start my car if the starter motor is not engaging but giving a spining sound? I need to move it. what can i do?

unfortunately no, however,, it could be a stuck starter,, I would try this old remedy first if you just need to move it,, Its worked before,, if you can get to the starter,, as someone else turns the key to start it,, give it a few short smacks with a small hammer,, that might get it to dislodge,, Ive used this method on many "have to moments" Good Luck,, please take a moment to rate this reply

May 03, 2011 | Hyundai Motor 2002 Sonata

1 Answer

Car was running fine Now it wont start Turns over but seems like no gas

Is the check engine light on? Rent a scanner to read out any codes which should point to certain problem areas. Can you hear the fuel pump run for a few moments (when the key is turned on), then shut off? If not, check the fuse and relay for same. Possible fuel filter problem. Try some starting fluid or gas in the throttle body which should make it fire a few times. Hope some of this helps!

Oct 09, 2010 | 1992 Chevrolet Cavalier

1 Answer

1996 blazer just got brand new battery, but has moments where it wont start, it will click and all the lights come on, but it wont even attempt to turn over and then a few more turns of the ignition, and...

The "clicking" is probably from the starter selinoid. If it's malfunctioning you'll get that clicking and nothing else. Follow cable back from starter to locate selinoid.

Mar 17, 2010 | 1996 Chevrolet Blazer

1 Answer

The car intermittently will not start. This has

You have to find it the moment it does NOT start, few things, batt/starter/solenoid/ignition switch could be at fault. If you say starting it means DOES NOT TURN OVER ? Or turns over but does not want to run??

Aug 19, 2009 | Jaguar XJ8 Cars & Trucks

1 Answer

Erratic idoling when warm

sounds like the air idle valve , if you can get hold of valve to test, try this find valve on inlet manifold and pull hose off going to throttle body,reconect hose to new valve so valves are i line to each other, start car and let it idle for a few moments till the fast idle slows down, then disconnect the wirering goint to the original aiv and connect to the new one , hopefully the original one would have been diconnected in the open position , reconnect wirering to the new valve and turn engine off. disconnect battery for 20 seconds . recon battery and turn ignition on, pump gas pedel 5 times to reset . start engine and let it idle for a few moments ,then try to turn steering wheel , engine speed should rise slightly due to load from power steering pump and then settle back down 875 1075 rpm.this is what the air idle valve should do. if it doesen't look at wiring goig to aiv might have scuffed through.

Aug 09, 2009 | 2002 Land Rover Freelander

Not finding what you are looking for?
2002 Pontiac Sunfire Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8514 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides