Question about 2001 Chrysler Sebring

1 Answer

Removal for cleaning headlamp covers for my my 2001 sebring, thay are stained and yellow

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 63 Answers

Much easier to clean them with them in place. Use some 2" wide blue (low-tack) masking tape to mask off the paint surfaces, then use a polish kit to remove the stains, polish your lamps and put a sealant on them. Turtle Wax makes a good kit that is reasonable in price.

Posted on May 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chrysler Sebring 2008 headlight assembly removal


some times headlamp units have a plastic retaining clip on the underside of headlamp, does the headlight move from side to side? try to pull the headlight back from the top of unit then lift up the headlamp unit, if not it could be the headlamp adjusters holding unit in place.

Dec 06, 2013 | 2008 Chrysler Sebring

2 Answers

How do i remove my front light cover to clean the inside


The front cover is mounted in a way that you cannot remove it. If you are trying to clear the yellow, polish the outside with an appropriate polish. The damage is usually done to the outside. Ifnyou have done this and it is still yellow, then you need to replace the lights.

Oct 16, 2010 | 1992 Lexus Es 300

1 Answer

How do I get to the drivers side light bulb in a 2006 Chrysler Sebring Sedan? I have the replacement bulb and want to change it myself.


I will assume you are talking about the headlight?!

Removal
CAUTION: do not touch the glass of halogen bulbs with fingers or other possibly oily surface, reduced life will result.

1) Disconnect and isolate negative battery cable.
2) Remove headlamp unit retaining screws. (bolts)
3) Remove headlamp unit to expose back of unit.
4) Disconnect wire connector from back of headlamp bulb.
5) Rotate retaining ring counterclockwise.
6) Remove retaining ring.
7) Pull headlamp bulb and remove from headlamp unit.

Installation

1) Install headlamp bulb to the headlamp unit.
2) Install headlamp bulb retaining ring.
3) Rotate retaining ring clockwise.
4) Connect wire connector to bulb.
5) Install headlamp unit.
6) Install headlamp retaining screws. (bolts)
7) Connect the battery negative cable.

More detailed info on how to get unit out.

Removal

1) Disconnect and isolate the battery negative cable.
2) Remove the two retaining screws.
3) Remove the upper fascia retainers by prying under the head of the fasteners with a flat bladed tool.
4) Remove headlamp unit from fender side first, then pull headlamp unit out.
5) Disconnect the wiring harness from the bulbs.
6) Remove the headlamp unit.

Installation

1) Connect wire harness to the bulbs.
2) Install headlamp unit.
3) Install the retaining screws.
4) Install upper fascia retainers.
5) Connect the battery negative cable.

I hope this will help you to get the light changed.

Jan 11, 2010 | 2006 Chrysler Sebring

2 Answers

Where to add oil


when you open the hood you will see a black cap on it you will see a picture of oil and written 10/30w oil take iit of by twisting it then add oil dont over flow the eng

Apr 28, 2009 | 2001 Chrysler Sebring

1 Answer

How to change right headlight on 2006 chry. sebring


It's very tight under the hood with these cars, you just have to unscrew the two (or three) long bolts holding the entire headlamp enclosure in, pull the headlamp enclosure out and rotate the bulb to remove it. Some sebrings have a cylindrical plastic guard around the main bulb, that just screws off as well. You might have to adjust your headlights after you change them.

Apr 18, 2009 | 2001 Chrysler Sebring

1 Answer

2001 ford expedition broken wipers?


you need to remove the wiper arms first. thay must be in the highest position for removal. take your hand and move them to that point then remove the nut cover at the base of the arm and remove the nut, a wiper arm remover tool may be required if thay dont come off easy,this tool is available at your local auto parts store.then remove the panels that sorround the wiper arm studs from which you took the wiper arms from,these panels may have little plastic screw covers on them that need to be removed to reveal the screws that hold the panels down

Jan 12, 2009 | 2001 Ford Expedition

1 Answer

Headlamp assembly question


two ways to fix, walmart will do it here for 40.00 while you shop, but if you are up too it I can tell you how. You can do it yourself with the help of some 1200 grit wet sanding paper and a buffing compound and buffer. It's not hard but if your don't have these thing already available to you walmart is the way to go.

Dec 28, 2008 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Am trying to figure out how to replace the headlamp bulb on a 2001 montero


Disconnect the wiring from the bulb.
Remove the rubber boot, covering the back of the headlamp.
Unhook the spring securing the bulb and remove the bulb.

Install the spring and sealing cover after the bulb replacement, or the water could get in the light unit.

Dec 05, 2008 | 2001 Mitsubishi Montero

1 Answer

Replacing headlights


these headlight assembleys are held in with retainer slides at the top of the light assembley, simpley push rearward and pull up thay should slide straight up. thare are 2 per headlamp.

Aug 11, 2008 | 2001 Ford Expedition

Not finding what you are looking for?
2001 Chrysler Sebring Logo

Related Topics:

96 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts

yadayada
yadayada

Level 3 Expert

80407 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

chargerhp
chargerhp

Level 3 Expert

814 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...