Question about 1995 Mercury Sable

1 Answer

The fuel guage doesn't work, stuck on 3/4 tank,

The fuel guage doesn't work, stuck on 3/4 tank,and the tachometer doesn't work either, how do i fix ?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 5 Answers

Replace the fuel pump assembly, comes with fuel pump, new wire harness, and new float

Posted on May 03, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My temperature gauge,Tachometer,Speedo,Fuel Tank on my 2003 Opel Astra 1.6 16v Elegance doesn't work intermittantly


connection on the back of the dash needs cleaning if you push on the dash and it all works then this is the fault. sometimes hitting it works just fine for awhile but not to hard.

Sep 13, 2012 | Opel Astra Cars & Trucks

1 Answer

Fuel guage doesn't work


Most common cause of this is a defective fuel level sending unit inside the gas tank. Remove the gas tank and replace the sending unit.

Aug 23, 2012 | 2000 Kia Sportage

1 Answer

The indicator of fuel shows empty doesn t move but gasoline tank is full


suspect the following

1. the fuse for the fuel guage.
2. the float switch in the fuel tank is defective or sunk to the bottom of the tank and cant move.
3. cable has come off at some point.

I hope this was helpful.

May 03, 2011 | 2006 Ford GT

2 Answers

Silverado 2000 5.3 4x4 gas gauge not working properly. Listen I have installed (2) new fuel pumps and fuel level sensor. I installed a insturment cluster. I ran a new ground wire from fuel pump to...


there are 4 wires at the sender - and 3 wires for the vapour sensor-the two heavier wires are for the pump and the lighter wires are for the guage-the lighter purple wire should have 5 volts on it-if not you may have a wire or computer problem-th guage is an input to the pcm(computor) under the hood and then is transmitted via comm. line to the cluster-if the rest of the guages work in the cluster you need to look at the pcm or wiring to the tank

Aug 16, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

I have a 1997 Ford Escort. The Fuel Guage is stuck at 1/2 tank. How do I fix this and have guage run properly again?


If the fuel gauge is ok, but the sending unit for level in the tank is stuck, then replace the sending unit by lowering the tank and disassembling the sending unit on the tank which contains the pump and the level sensor.

If you disconnect the sending unit and the meter still says 1/2 tank, the gauge itself may be bad.

Jul 12, 2010 | Cars & Trucks

2 Answers

Fuel guage wont work stuck on full


THIS PROBLEM IS CAUSED BY A DEFECTIVE FUEL GAUGE SENDING UNIT, THE SENDING UNIT IS LOCATED INSIDE THE FUEL TANK AND PART OF THE FUEL PUMP MODUAL ASSEMBLY, THE FUEL TANK MUST BE REMOVED TO REPLACE THE SENDING UNIT

Jan 28, 2010 | 1995 Buick LeSabre

1 Answer

1989 F250 Diesel twin fuel tanks fuel guage does not work


Dual tanks sound like the float in the tank is stuck. Need to make sure its not binding up. (I did alot of those jobs)

Mar 23, 2009 | 1989 Ford F 250

1 Answer

Fuel guage stopped working


The fuel sending unit has gone out. This sending unit operates the fuel gauge. It is located in the gas tank. You will have to remove the tank to fix this. You can try banging on the tank, sometimes the float arm on it gets rusty and will get stuck in one position and the banging will free it up. From your description though, it sounds like the sending unit has shorted out and needs to be replaced.
Please remember to rate this fix.

Feb 16, 2009 | 2003 Mitsubishi Diamante

1 Answer

97 Silhouette Fuel guage not working correctly


drop fuel tank. if guage moves all around its probably the fuel level sensor on fuel pump assembly in the fuel tank. If the guage stay's in one spot its the guage , replace instrument cluster assembly. you can take just the glass off the cluster and move the fuel guage needle and it will work (if stuck) but for how long? The wires to the guage come from the sending unit to the power train control module to the instrument cluster. pray its not in the wiring.

Sep 14, 2008 | 2000 Oldsmobile Silhouette

Not finding what you are looking for?
1995 Mercury Sable Logo

Related Topics:

143 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...