Question about 1995 Ford Econoline

2 Answers

Looks like one or more than one cylinders not

I just bought a 1995 econoline, looks like one or more than one cylinder(s) not working when press gas its vibrates and then picks up speed i removed plug wires one by one i think 2 cylinders are not working is there any better way to make sure and what repair is required

Posted by on


2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 267 Answers

Maybe injectors not working. need to check for metallic clicking sound at injectors. need listening device or use wood rod against injector and try to place your ear on the rod you will hear the clicking but if silent then the injector is not working. this is only one of many posible problems here. good luck

Posted on May 03, 2010

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.


    An expert whose answer got voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

Spay down the wires with water to see if they ark it may be something as simple as those two wires are bad.

Posted on May 03, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Turns on but turns off right after

1993 ford f350 with 460 engine, will not star unless you press gas pedal to the flor and it may stay runnig then but not for long and seems to have no power when you put it in gear it dies

Jan 26, 2013 | 1993 Ford Econoline

1 Answer

Want to know where the fuel pump relay is located on the 1991 Ford Econoline Van? 4.9 Liter....rear gas tank behind axle..?

check under the hood, almost below the master cylinder, there should be another fuse box located there,, the model makes a difference, (E150,250,350)

Sep 14, 2011 | 1991 Ford Econoline

1 Answer

Hello, I hope you can help me. I have a 1989 ford econoline van and I am trying to replace the ignition switch, but i can't get the old one out.

If you look under the the switch you will see a hole turn key on and push into the hole this should release it be carefull not to disturb the gear at the end or you will have to retime it.
Ignition Switch Lock Cylinder-Functional Lock Cylinder Removal
  1. Disconnect the battery ground cable (14301) and wait at least one minute. For additional information, refer to Section 414-01.
  1. Remove the ignition switch lock cylinder (11582).
    1. Insert the ignition key and turn to the RUN position.
    1. Press the ignition switch lock cylinder release pin while pulling out the ignition switch lock cylinder.
  1. To install, reverse the removal procedure.
    • Verify ignition switch lock cylinder operation.

Feb 15, 2011 | Ford E-150 Cars & Trucks

1 Answer

Where is coil no.5 was told cylinder 5 was misfiring bought coil but not sure which is no. 5

5.4 liter?
Drivers front cylinder
1-2-3-4 on the passenger side, 5-6-7-8 on the drivers side

drivers front cylinder
1-2-3-4 on the passenger side, 5-6-7-8 on the drivers side

driver middle cylinder
1-2-3 on the passenger side 4-5-6 on the drivers side

Nov 07, 2010 | 2000 Ford Econoline

1 Answer

Firing order on a 1998 Econoline

For the 1998 Ford Econoline Van:
I do not know if you have the Econoline E150, E250, E350 Model; or the 4.2L V6, 4.6L V8, 5.4L V8, or the 6.8L V10 Engine; however I have included all below.

For the 4.2L V6:
Firing Order:

For the 4.6L V8:
Firing Order:
Click on the following direct free Link:

For the 5.4L V8:
Firing Order:

For the 6.8L V10:
Firing Order:

Let me know if this helped, or if you have additional information questions. Feel Free to contact me at!

Apr 06, 2010 | 1998 Ford Econoline

1 Answer

I need to find where the horn is located for a 1995 e-350 ford turbo diesel 7.3 liter 8 cylinder

it is in the lower front right of engine compartment behind the grill


Sep 02, 2009 | 1995 Ford Econoline

1 Answer

Bonneville ignition cylinder replacement

get new cylinder look at it and see the spring loaded tab you need to push in. Now pull the steering wheel column lock plate (gm tool required unless you have super thumbs) pull out key buzzer switch , roll key over to unlock wheel, press the same area on the lock cylinder to release it

Sep 13, 2008 | 1995 Pontiac Bonneville

Not finding what you are looking for?
1995 Ford Econoline Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers


Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides