Question about 2009 Volkswagen Tiguan

Open Question

Hello, I am installing HID lights on a 2010 wv tiguan as well as fog lights I was told they needed relay harness for both because they would flicker and after I installed the relays they worked for a bout a week and now only one light stays of the passenger side is their anything else I need to do? My fogs are fine with the relay it's just my lows that are giving me problems..please help thanks!

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

tripletauto
  • 1450 Answers

SOURCE: hhr fog lights

yes it is you will probably have to have the bcm programmed for the foglight option if your gonna install like factory is

Posted on Sep 22, 2008

  • 88 Answers

SOURCE: need wiring shematic for fog lights 2005 toyota corolla

im pretty sure these cars were already prewired for fog lights .there should be some plugs behind the bumper to fit them.if not get back i will explain how to wire them up.best of luck.

Posted on Oct 17, 2008

jschoon77
  • 55 Answers

SOURCE: Fog light bulb replacement

This bulb can be replaced without removing the washer fluid reservoir. There are 3 screws that go through the bottom edge of the bumper cover into the right inner fender guard. Remove these screws and pull the inner fender down to gain access to the back side of the fog lamp and remove the bulb.


Nissan Scope Technician- 10+ years experience in Nissan dealership.

Posted on Nov 04, 2008

  • 345 Answers

SOURCE: fog light replacement driver side

new light and yes the bumper has too come off to get to the bolts at the bottom of the lights..

Posted on Dec 11, 2008

  • 168 Answers

SOURCE: 200 VW Beetle engine coolant problems

The Heater core is bad. Check with VW to see if there is a recall on the heater core. You can try a stop leek or a little (two table spoon of) black pepper. If you are going to keep it look at replacing the heater core.

Posted on Aug 24, 2009

Testimonial: "All the advice I received indicates something wrong with the heater core. Thanks - I will have it checked."

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ballstic hid light upgrade for my truck


Unless you truck is already equipped with hid, you will need additional harness & relay. You may also have to modify your automatic lights also

Jul 02, 2016 | 2005 Chevrolet Colorado

1 Answer

My mazda buzzes 2 times when I turn the headlights off and the instrumentation lights flash at the same time


Mazda 626 Electrical Issues - Car Forums at Edmunds.com

forums.edmunds.com > Mazda > Mazda 626

May 22, 2007 - 31 posts - ‎24 authors
clicking or buzzing sound coming from the "headlight relay" which is in ... off when you turn on the headlights then it clicks instead of buzzing in that fuse compartment and the headlight flickers about 5-10 times a second in time with the ..... I have a 1992 626 mazda, the battery died and replaced it two days ...

Thread: headlight issue and buzzing sound - Toronto Mazda 3

www.torontomazda3.ca > Forum > Technical Section > Electrical

Mar 3, 2009 - 25 posts - ‎10 authors
1. so in the fall my right headlight burned out, but then after nudging ... 2. sometimes when i turn off the car i hear buzzing coming from .... i turn off the car, was never able to open the hood in time before the sound disappears ... Buzzing sound behind centre console
11 posts
Sep 17, 2010
HID Problem: Bulb/Ballast Misfiring
25 posts
Aug 28, 2010
Buzzing relay after HID install with RELAY harness ...
15 posts
Mar 12, 2008
More results from www.torontomazda3.ca

Jan 07, 2016 | Mazda Cars & Trucks

2 Answers

How do I get the low beams to run automatically whenever driving instead of flickering?




if you did it yourself and did not use factory lights or ballast then it could be a voltage detection problem. If you did use factory parts then the headlight switch may have failed by coincidence. also check connections at HL plugs and or switch. ???????????

Nov 13, 2014 | 2001 Audi TT

2 Answers

2010 jeep grand cherokee laredo fog lights


If it didn't come with fog lights, it may also have not included a fog light relay and/or fuse. Check the owner's manual for fuse and relay locations, and then check if the necessary parts are there.

Apr 21, 2014 | 2010 Jeep Grand Cherokee

1 Answer

I install hid kit bixenon on My Saab 9-3 1999 now the hig beams not working and fog lights only low beams i replace the switch and the Orange relay and fases are fine i still have the same problem


Install an aftermarket harness, ran off of a dedicated line. It sounds like there is now a draw issue on the old wiring with the new load.
most people call them a "flicker free harness" kit WITH dedicated relay.

Jul 05, 2013 | Cars & Trucks

2 Answers

What would cause the headlights in my 98' gmc


Do you have HIDS, cheap HID kits flicker? otherwise check the wiring harness. could be a loose connection.

Apr 01, 2012 | 1998 GMC Sonoma

2 Answers

Left Front HID Flickers off after 2 seconds


Yr left side ECU under the headlight may be the culprit. Hv it checked.

Jul 29, 2009 | 2006 Volvo V50

3 Answers

Hid light not turning on


the part about the lights that won't turn on may be because there is a blown fuse or a broken relay which needs to be changed, the part about the hid lights there may be a short circuit somewhere.

Apr 03, 2009 | 2006 Mitsubishi Galant

3 Answers

HID fog light


check your connections to the relay, sounds like something is breaking down under load

Feb 18, 2009 | 2005 Chevrolet Silverado

2 Answers

HID headlight


Most likely the HID transformer is not producing the correct voltage to properly charge the HID bulb. 12 volts goes into the transformer, but a lot more comes out. The HID needs a lot of volts to run, hence the need for the abovementioned transformer. But, the transformers are REALLY expensive.

Sep 18, 2008 | 2004 Toyota Sienna

Not finding what you are looking for?
2009 Volkswagen Tiguan Logo

Related Topics:

146 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

74945 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...