Question about 1998 Honda Civic

1 Answer

Power windows are coming out of the run channel in a 1998 civic hx

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

The problem is in the window rails they might of gotten loose or broken off. For this u need to remove the panels of the doors and check to see if they are unbolted or crooked.

Posted on May 05, 2010

Testimonial: "I already did that, installed a new window regulator and the rear portion of the window is lifting out of the run channel. "

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

98 Honda Civic HX sputters when accelerating. Feels bogged down and lacking power.


Time for the dealer to take a look. You need special skill and special tools to diagnose this not to mention years of experience with electronic engine control systems.

Sep 13, 2012 | 1998 Honda Civic

1 Answer

Need the wiring diagram for honda civic 1998 auto. tr. vss


Which Civic model: DX,CX,HX,EX,GX..........
Which engine; SOHC MFI, VTEC-E MFI, CNG.......

There is always some piece of vehicle information people fail to provide us when requesting help.
Please be more specific folks and providfe all the information possible on your vehicles.

Sep 21, 2011 | Honda Civic Cars & Trucks

1 Answer

Which o2 sensor is sensor 1 on a 98 honda civic hx?


the one at the bottom of the exhaust manifold as shown in below picture.

5429168.gif

Oct 12, 2010 | 1998 Honda Civic

1 Answer

I need to know how to connect the coyal wires back


For the 1998 Honda Civic 1.6L SOHC -In-Line 4-Cylinder:
For all: LX, DX, EX, GX and HX Models; VTEC and VTEC-E

Firing Order:
1-3-4-2

Cylinders:
...........(back)..........
|...4.....3....2....1...|
...........(front)

Distributor:
....(back)
..........1
2
........o
.................3
.....4
.....(front)
Rotation: Clockwise
Let me know if this helped, or if you have addtional questions. Feel Free to contact me at FixYa.com!

May 08, 2010 | 1998 Honda Civic

1 Answer

Stuck crank window, drivers side, 97 honda civic


1996-00 Civic 2-doors had a problem with the front windows binding or coming out of the run channel. The window regulator needs replaced and the rubber run channel needs inspected for damage and to make sure its properly seated into the window channels. note: make sure you install the window crank in the 10 o'clock position, so your not tempted to use the window crank as a door handle to pull the door shut. This can break the crank and/or the regulator. -Hope this helps:)

Jan 24, 2010 | 1997 Honda Civic

2 Answers

My honda civic 98 hx m4va transmition type,the trans drives fine exept when gearing up I can't feel when shifting and rpms goes up and down,I replace the transmition and still doing the same, also when...


I have a 1998 Civic HX 2DR as well and mine also takes a moment to engage when you press the gas. I don't know if this is normal or not? I just bought the car and I need to replace the trans fluid only because I don’t know if there is Honda oil or another brand in it. The CVT transmissions only can use Honda's CVT oil. There is a recommend alternative oil but based on the manual it’s only for temporary use until you can replace it with the Honda oil otherwise it will cause damage to the transmission over time.

Jun 09, 2009 | 1998 Honda Civic

1 Answer

Surging


ck the coolant level if this is ok then its the idle air control valve

Nov 14, 2008 | 1998 Honda Civic

1 Answer

98 honda civic hx


what are you doing at the time? just normal driving or stepping on it? email me with more info or questions at meanness628@aim.com

Sep 21, 2008 | 2000 Honda Civic

1 Answer

Driver's side window regulator


I just replaced the regulator in my mother's 98 civic ex and didnt need any special tools. I do recommend replacing the glass run channels on either side of the window. I have replaced the regulator twice and it is still having problems as I haven't replaced the run channels. If not replaced very soon I can see myself replacing the regulator...yet again!

Aug 04, 2008 | 1998 Honda Civic

1 Answer

Front bumper


To remove the bumper on a honda civic;

1. open your hood and unscrew 3 screws ( some have plastic catchers).
2. there is another bolt above your front tyre, you have to unbolt that..(right above the tire, by your mudguard or whatever they call that plastic piece to stop mud or water to get in contact with wires on the door.)
3. same on the other size...
4. you are good to go then...good luck..

Jun 17, 2008 | 1998 Honda Civic

Not finding what you are looking for?
1998 Honda Civic Logo

Related Topics:

140 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

77201 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...