Question about 2000 Honda Passport

Open Question

P1340 honda passport how do i fix?

2000 honda passport< code p1340, how do i fix?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

motor1258
  • 6674 Answers

SOURCE: where is throttle position sensor located on 2000 honda passport

Normally attached at opposite end of throttle linkage. Remove your air cleaner intake hose at throttle body, and observe throttle plate that opens & closes as you press accelerator, it will be at the end of that, on outside of housing.

Posted on Jan 10, 2009

  • 3 Answers

SOURCE: 2000 Honda Passport wont start.

I ended up finding a repair shop here in Cleveland. The problem ended up being a short in the electrical system. My fuse kept blowing. That's why it wouldn't restart. If you decide to take your vehicle to a repair shop, have them check out the electrical system. My problem was found under the drivers side fender. Some of the wires were corroded. Good luck!

Posted on Feb 18, 2009

honeymokey
  • 3113 Answers

SOURCE: Vacuum Leak on a 2000 Honda passport

Replace upper intake gaskets. They are made of metal and plastic. A common problem. Do not remove the very top plenum cover gasket.

Posted on May 10, 2009

gladys_neal
  • 334 Answers

SOURCE: evaporative emissions leak for 2000 honda Passport

if small leak indicated it is most likely a gas cap

Posted on Nov 10, 2009

  • 1 Answer

SOURCE: what are p1515 and p1295 for, for honda passport 2000

I had the similar problem after changing out the waterpump and timing belt, came to find out it was the battery cable connectors needed cleaning. simply use a wire brush and clean the inside of the connector before connecting it to the battery terminal post. When you have insufficient voltage going to your electrical components, it will tend to chatter(relays). This was the first symptoms i had with my passport, but once i cleaned the cable connector to the battery post, it started right up,problem fixed. I hope this helps. 2kpassport.

Posted on Dec 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Can you cross reference this code p1340 on a 2000 isuzu rodeo check engine light on


code p1340 refers to ignition control module (ICM)-cylinder identification/ syncronization===causes--wiring--ignition coils--ICM---ECM Talk to the service dealer as to the most probable failed unit before you waste money

Dec 06, 2013 | 2000 Isuzu Rodeo

1 Answer

2000 Honda Passport check engine light on code P 1340 reads ION sensing module cylinder identification malfunction


Use Google & ask the question

Start with the code & type: 2000 Honda OBD P1340

All the causes & solutions are on the internet, most likely
in about a hundred places

Just remember to study what is there, because codes
have nothing to do with changing parts.

Aug 31, 2013 | 2000 Honda Passport

1 Answer

I need serpentine belt diagram for 2000 honda passport


08f9562.jpg



This is a picture i drew in paint , for the 2001 honda passport belt wrap with a 3.2Liter V6, hope you can use it for the 2000 model.

Sep 01, 2010 | 2000 Honda Passport

1 Answer

Honda passport 2000 3.2 l v6 eng automatic transmission the check engine light stays on i used a scan tool and it returned a code P0463 which is fuel level circuit A high input... what does this mean?


2000 Honda Passport v6 auto transmission..at time transmission did not down shift when stoping and it would stay on low grear. when going after stop it would be on low grear but pick up speed to go 45 mi. pmh but would not down shift when stoped. until maybe 3 miles and it would down shift at stop or when driving at slow speed?

Feb 08, 2010 | 2000 Honda Passport

2 Answers

2000 Isuzu Rodeo, 3.2, 112,000 miles, Service Engine Soon light is on, won't pass inspection till I get it cleared off. Hooked up a scan tool the only code is P1340 and it scan tool says it's a...


well clear code and drive it about 50 to 100 miles to try reset the monters and see if light stay out if so go get it smog so the system that could couse this is a bad wireing harness this may be hard for you to diagnosis this system put if you want me to help you can emaile me and i will send you the hole diagnosis chartDTC P1340 ION Sensing Module Cylinder ID Fault (Cylinder Synchronization Fail)

cant do it here to big

Oct 05, 2009 | 2000 Isuzu Rodeo

1 Answer

What are p1515 and p1295 for, for honda passport 2000


I had the similar problem after changing out the waterpump and timing belt, came to find out it was the battery cable connectors needed cleaning. simply use a wire brush and clean the inside of the connector before connecting it to the battery terminal post. When you have insufficient voltage going to your electrical components, it will tend to chatter(relays). This was the first symptoms i had with my passport, but once i cleaned the cable connector to the battery post, it started right up,problem fixed. I hope this helps. 2kpassport.

Jun 08, 2009 | 2000 Honda Passport

1 Answer

Code p1340


P1340 Igniter Circuit Malfunction (No. 8)
P1340 Camshaft Position Sensor B Circuit Malfunction
It all has to do with your ignition system or misfire.
You will need a special tool to remove this item. I would recommend taking it to a mechanic and having them fix it

Feb 07, 2009 | 2000 Isuzu Rodeo

Not finding what you are looking for?
2000 Honda Passport Logo

Related Topics:

503 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...