Question about 1996 Ford Mustang

1 Answer

No fuel getting to injectors ... changed fuel filter ran fine for 3 days back to same thing

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 12 Answers

I would be willing to bet you have some gas residue that is contaminating your fuel lines. I would drain the gas tank and have it checked and cleaned.

Posted on May 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Have a 1996 ford explorer. It started the other morning just fine and ran good, that afternoon I couldn't get it to start. Changed the fuel filter and it started and ran fine again. Cut it off when I...


first need to make sure you have enough fuel pressure. Hook up a tester and check against the specs. if its too low, then your probably looking at a fuel pump. By replacing the filter, you allowed more fuel to flow. Also, make sure you are getting spark and injector pulse.

Apr 14, 2013 | Cars & Trucks

1 Answer

Car will not stay running fuel keeps cutting out


Fuel filter, fuel filter. Usually in fuel rail under car on frame.When you ran out, you got debris in filter, when did you last change it?

May 14, 2017 | 1995 Chrysler LeBaron

1 Answer

My car wont start engine turns over but doesnt start like ist recieving no gas


Considering it ran fine after pump replacement for awhile then it is probably a fuel issue. Couple things it could be. 1. you could have a ton of sediment in gas tank and it keeps clogging up your pump. 2. you could have blocked fuel filter and or clogged injectors.

Oct 31, 2012 | Chevrolet Cars & Trucks

1 Answer

Ran out of gas ran fine for about 2 days went to friends when leaving it died,started right back up,but shaking real bad like a missfire,checked and seems the coil packs r ok,


Sounds like something in fuel system is clogged form running to low on fuel if vehicle is old and fuel filter has not been replaced for a long time.
It does not take much but a small particle to clog injector or it could be fuel pump is going out. You need to check fuel pressure and change filter and also you might have to get fuel system flushed and you might just have replace injector at worst. Hope this helps

Oct 24, 2012 | Cars & Trucks

1 Answer

I have a 2004 Jeep GC 6cyl 4WD. My check engine light is on, scanned and got P0203, P0300, P303. Changed the spark plugs, fuel injector #3. Started it up and ran rough, I left it in the garage all night...


codem p 0203 refers to injector 3---circuit malfunction===causes wiring--injector--ECM
chweck for harness connection , bad wire for no 3 injector or corroded pins for no 3 injector in the connection

May 14, 2017 | 2004 Jeep Grand Cherokee

2 Answers

Repaced rotor cap plugs wires, ran fine. tell


First thing I would do is change your fuel filter. Check all vacuum lines and all your wire connections. Also check fuel pump relay to see if it is faulty or if there is shorted wires under the relay or fuse blocks.

Oct 11, 2009 | 1995 Ford F250

1 Answer

I changed the fuel pump, fuel filter and fuel pressure regulator and the car still wont crank and it ran 3 days ago. I checked the plugs and wire and there fine. the fuel in the fuel filter was grey and...


well you can check the injector pulse with a noid light and if no blink then you can assume that the injectors are good then you can either go after the pick up coil and make sure you have spark through the wires but if you have a blinking light then you lack something else you need three things compression fuel and spark and it will run hope this helps oh most important check all the fuses and relays

Aug 30, 2009 | 1988 Honda Accord 4 Door

1 Answer

99 Buick Century won't start


spark plugs known problem when cold

Nov 24, 2008 | 1999 Buick Century

1 Answer

1998 Plymouth Breeze


change your sparkplug wires that will salve yor problem

Sep 16, 2008 | 1998 Plymouth Breeze

Not finding what you are looking for?
1996 Ford Mustang Logo

Related Topics:

59 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...