Question about 2002 GMC Sierra C/K1500
I have a 1995 GMC sierra and the heater ha quit working. I believe it is the switch. It started making strange noies and I would have to turn the dial over and over agin to get it to kick on. Now it doesn't kick on at all
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.
Posted on Jan 17, 2009
your heat/cool and vent selection options are controlled by engine vacuum through small clear tubes attached to the rear of your climate control interface. Other vehicles have small steel pull wires that operate the desired changes. You might try removing the trim and any fasteners affiliated with the interface/console. GENTLY pull outward and look to see if any of these tubes are pulled off or cut/damaged. Did anyone recently install a new stereo in the vehicle? If so, the vacuum tubing and or pull wires that change your outlets could have been damaged when the stereo unit was pushed into place. Hope this helps
Posted on Sep 09, 2009
Testimonial: "Very good information. THANKS!"
May want to look at replacing the wiper circuit board.It is located on the firewall adjacent to the wiper motor and has a some what square black cover with 3 torx screws and wireing harness pluged into the side.We had a truck that every time you washed it the wipers would stay on until it dryed out.You can try removing it and spaying it down with contact cleaner just watch the brease on the two contact tips.Well hope this helps.
Posted on Feb 05, 2010
Tips for a great answer:
Mar 31, 2013 | 1991 GMC Sierra
Jan 27, 2013 | 2003 GMC Sierra 1500
May 19, 2011 | 1995 GMC Sierra C1500
Jan 19, 2011 | 1995 GMC Sierra C1500
Mar 27, 2010 | 1995 GMC Sierra
Jan 17, 2010 | 1995 GMC Sierra
Oct 10, 2009 | 1996 GMC Sierra
Oct 02, 2009 | 1995 GMC Sierra
Jul 13, 2009 | 2002 GMC Sierra C/K1500
67 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: