Question about 2006 Ford Super Duty F 550 Drw

1 Answer

With the primary fuel filter cover off , and key on , I get no fuel out of the filter housing

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Have you tried to do a momentary crank yet. It usually takes the start circuit to get the pump running. It will only run for 10 to 20 secs. If the engne is not running after that. I am assuming you are trying to bleed the fuel filter. Good Luck

Posted on May 03, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Is the fuel filter inside the tank on a 04 Saturn vue


.The fuel filter (1) is located in the primary fuel tank module. The paper filter element traps particles in the fuel that may damage the fuel injection system. The filter housing is made to withstand maximum fuel system pressure, exposure to fuel additives, and changes in temperature.

Fuel Pump and Sender Assembly - Primary
At the rear of the vehicle, inside the fuel tank, on the right side

Jan 02, 2017 | Saturn Cars & Trucks

2 Answers

Where is the primary fuel pump location on 92 volvo 240 wagon


I believe it is attached to a support bracket for the dash behind the glove compartment.

Sep 15, 2014 | 1992 Volvo 240

2 Answers

Where is fuel filter location on 2001 bluebird shuttle bus with 5.9l 24v cummins?


the diesel fuel filter should be located on the firewall and should be a spin on/off filter like an oil filter and must be filled with diesel fuel before installation. if you go buy the new one first it will help you locate it on your bus

May 14, 2014 | 2001 Dodge Ram 2500 Truck

1 Answer

Where is fuel filter in a touareg 2004


The fuel filter housing in the fuel tank can be accessed from under the rear seat. Cut open the carpet in the pre-cut area. Remove the 4 nuts from the filter housing cover. It may be necessary to remove the seat backrest support.

11_8_2011_11_02_29_pm.jpg

Fig. Filter housing cover bolts (arrows)



Hope this helps; also keep in mind that your feedback is important and I'll appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using Fixya, and have a nice day.

Nov 06, 2011 | 2004 Volkswagen Touareg

1 Answer

The last few days,some light came on shows WATWE in FUEL.


water in fuel,drain the water out of the fuel filter by releasing it through the valve on the bottom of your fuel filter. unscrew the valve on the bottom of primary fuel filter,you have 2 fuel filters. one is primary,one is secondary. you did'nt specify what engine,or what year, but will try to assist you anyway. drain the water out of the primary fuel filter by draining the water out of the primary fuel filter,you will see a pep **** valve under the fuel filter,turn it counterclockwise until you see the fuel coming out, after you drain that fuel filter drain the 2nd one. this will solve your fuel issues for now.but i do suggest you replace those 2 filters. you can prime the filters with transmission fluid in order to restart the engine. i have u.s.m.c. training in heavy equipment,ooooraaahhh.if you know this,,, you'll know #1 we never leave a man behind.wish you the best. thank you for choosing fixya.com

Mar 29, 2011 | Ford E-350 Super Duty Cars & Trucks

1 Answer

How do you replace a 2001 Mazda 626 Fuel Filter


Fuel Filter On all models except the Millenia, the fuel filter is attached to a bracket located in the left rear of the engine compartment, next to or beneath the brake master cylinder fluid reservoir. On the Millenia, the fuel filter is located beneath an access cover in the trunk. Access to the cover is achieved by removing the trunk mat to expose the cover.
---
REMOVAL & INSTALLATION Except Millenia
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Properly relieve the fuel system pressure.
  3. Remove or disconnect the following:
    • Negative battery cable Fig. 1: Exploded view of a common fuel filter and related components 7923mg68.gif

    • Air intake hose and/or filter housing, if necessary
    • Fuel line clamps, if equipped
    • Fuel lines from the filter and plug the openings
    • Filter clamp bolt/nut by loosening them.
    • Fuel filter from its mounting bracket
    NOTE: Note the direction of the flow arrow on the filter so the replacement filter can be installed in the correct position. To install:
  4. Install or connect the following:
    • Fuel filter in its mounting bracket, making sure the flow arrow is pointing in the proper direction
    • Fuel lines to the fuel filter
    • Fuel line clamps, if equipped
    • Air intake hose and/or filter housing, if removed
    • Negative battery cable
  5. Pressurize the fuel system and check all connections for leaks.
Millenia
  1. Before servicing the vehicle, refer to the precautions in the beginning of this section.
  2. Insure the ignition switch is OFF.
  3. Relieve the fuel system pressure.
  4. Remove or disconnect the following:
    • Negative battery cable
    • Trunk mat
    • Service hole cover
    • Fuel lines from both ends of the fuel filter
    • Fuel filter and bracket
    • Fuel filter from the mounting bracket.
    To install:
  5. Install or connect the following:
    • Filter in the bracket. Tighten the nut to 70-95 inch lbs. (8-11 Nm).
    • Fuel lines to the filter
    • Service hole cover
    • Trunk mat
    • Negative battery cable
  6. Run the engine and check for any fuel leaks.
prev.gif next.gif

Oct 17, 2010 | 2001 Mazda 626

2 Answers

Is there a fuel filter on this truck? it is not


Yes there is a fuel filter on a 1991 toyota pickup. Possible fuel pump failure. Hope this helps.

Apr 02, 2010 | 1991 Toyota Pickup

1 Answer

How do i change the fuel fitler in a 03 power


should have a cover on top of the engine, lift cover , there will be a cylindrical Fuel Filter housing with a lever on the side and a cap on top. remove the cap, remove the old filter & install the new filter & the NEW seals. use the little lever to drain the old fuel & any water from the fitler housing & start engine per normal Diesel starting procedures

Oct 08, 2009 | 2003 Ford F Super Duty Chassis Cab

1 Answer

Where is the fuel filter on a turbo desail


Your fuel filter is mounted on the rear of intake manifold, under air cleaner or on rear firewall.
Just a little hint on replacing it, remove your fuel tank cap to release pressure or vacuum in the tank. I'm sending you a diagram the fuel filter assembly so it will make it a little simpler for you to replace your fuel filter. Start by removing the filter element nut. Remove filter element by lifting straight out of filter housing. It is not necessary to drain fuel from filter housing when changing the filter element.
Installation, ensure mating surface between filter element assembly and filter housing is clean. Install new filter element by aligning widest key slot located under element assembly cap with widest key in filter housing assembly.
Tighten element nut by hand. Bleed air from fuel manager/filter assembly. Connect a hose to air bleed valve and place other end of hose in a container.
Disconnect fuel injection pump shutoff solenoid wire. Crank engine for 10 to 15 seconds. Allow starter to cool down for one minute between cranking intervals. Repeat procedure until clear fuel is observed at the air bleed hose.
Close air bleed. Connect injection pump shutoff solenoid wire and reinstall fuel filler cap. Start engine and allow to idle for five minutes. Check fuel manager/filter for leaks.9df1ca0.gif

Oct 03, 2009 | 1994 Chevrolet C/K 2500

2 Answers

I am not getting fuel to my engine


Removal
  1. Relieve the Fuel System Pressure . Refer to the procedure in this section.
Cushion Cover and Pad, Rear Seat — One-Piece and 50/50 Split Fold Removal
  1. Remove the two rear seat cushion bolts.
  1. Fold the rear seat back cover and cushion (60084) forward.
  1. Carefully pull the rear seat cushion and cover (60030) out from under the rear seat back cover and cushion and remove the rear seat cushion and cover from the vehicle
  1. Remove the rear seat cushion and cover (60030). Refer to Section 01-10 for the removal procedure.
  1. Remove the three luggage compartment floor cover hold-down pins and fold the luggage compartment floor cover (45455) forward until the fuel pump assembly access plate is visible.
  1. Remove the four fuel pump assembly access plate screws, the ground lead, and the fuel pump assembly access plate from the chassis.




  1. Disconnect the fuel pump assembly electrical connector.




  1. On 4-door vehicles, remove the fuel vapor tube shutoff valve bolt and the evaporative emission tube shut off valve (9G332) from the bracket on the fuel pump assembly housing.




  1. Loosen the two hose clamps and disconnect the two fuel pump hoses from the fuel pump hose fittings on the fuel pump assembly housing.




  1. Remove the four screws (2-door) or eight screws (4-door) and lift the fuel pump assembly housing from the fuel tank (9002).




  1. Disconnect the fuel level sensor electrical connector.
  1. Remove the two fuel level sensor washers and fuel level sensor nuts and the fuel level sensor.



-------------------------------------------------------------------------------------
Section 10-01: Fuel Tank, Filters, Lines and Electric Fuel Pump 1996 Aspire Workshop Manual
REMOVAL AND INSTALLATION Fuel Pump Removal
  1. Remove the fuel level sensor. Refer to the Fuel Level Sensor removal procedure in this section.
  1. Remove the fuel pump screw, fuel pump grommet and the fuel pump bracket from the bottom of the fuel pump (9350).




  1. Remove the fuel tank sender filter bracket, fuel tank sender filter (9A011) and the fuel tank sender filter retainer from the fuel pump.
  1. Disconnect the fuel pump electrical connector.
  1. Remove the clamp and the fuel pump from the fuel pump assembly housing.

Apr 19, 2009 | 1995 Ford Aspire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

39 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

fordexpert

Level 3 Expert

5537 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...