Question about 2001 Ford Excursion

1 Answer

Which direction do I turn the manual lockouts to lock the hubs in.....2001 Ford Excursion---V-10

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert that has over 500 points.


    An expert whose answer got voted for 20 times.

  • Expert
  • 189 Answers


Posted on May 02, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2001 f 350 xlt off road 4x4 hubs are lock hubsin bot dos not work no 4x4 in front

there may also be a button or switch on the dash to engage 4 wheel if not then once u engage shifter and turn lockouts to lock put truck in rev and backup about 3 to 4 ft this should engage your 4 wheel

Feb 07, 2011 | 2003 Ford F350 Super Duty DRW SuperCab

1 Answer

Have A 2000 excursion hade the hubs replaced and now have the ABS light going on off?

The ABS wheel speed sensors are on the hubs. Check the cable connectors are not loose and properly connected. Possibly one of the sensors might have been damaged when the hubs were replaced.

Jan 07, 2011 | 2001 Ford Excursion

1 Answer

I replaced hub on front axel but the noise is

It sounds like it is a front end suspension problem. The following should be checked: upper and lower ball joints, the sway bars links, and even the shocks. Replace what is problematic, and your front-end noise should disappear, if it is a front suspension problem. Hopefully, this will FixYa problem!

Jan 04, 2010 | 2001 Ford Excursion

1 Answer

Locking hubs Problem on an Excursion, or steering issue

it sounds like your hubs are going bad. when you disengage your 4x4 try backing up a few feet. this might help them release

Dec 21, 2009 | 2000 Ford Excursion

1 Answer

I have a 1994 Ford F-150 with manual locking hubs. I locked in the front axle, shifted into 4H and the front end did not engage. What's going wrong? The dash ligh was on and i believe the transfer case was...

its most likely a sticky or dirty lockout,or if its below freezing where you are at,then a frozen lockout--with ice or too thick of grease,then warm up a little with small torch..or a broken lockout..its easy to tell which one,reach under neath with the transfercase in 2wd and turn each front axel shaft all the way around with the lockouts locked in,if 1 side doesnt turn by hand then that side works.if it does turn then fix or replace that side...when turning by hand keep the front wheels straight,otherwise the nuckle joints in the front axel shafts will bind and make you think they are not turning.

Dec 19, 2009 | Ford F-150 Cars & Trucks

1 Answer

Front hub to lock in to 4 wheel drive is locked and wont move. 2000 ford excursion v10 on one side only, is this a ford only part?? thanks

This is common. the locks due tend to freeze up and need either a greasing or replacement. I do suggest automatic locking hubs that you don't have to turn yourself. You can get the part almost anywhere

Sep 30, 2009 | 2000 Ford Excursion

1 Answer

Power locks will not lock or unlock doors. will only unlock if using the key and or manual

The key cylender has a switch attached to it so that is why that works. A relay must be at fault for your problem

May 22, 2009 | 2001 Ford Excursion

1 Answer

No brake lights and no turn signal

Check the fuses that are associated with the brake lights and turn signal. The fuse box is located below the steering column and the fuse box diagram (for fuse assignment) is located in the owner's manual. I hope this helps.

Dec 20, 2008 | 2001 Ford Excursion

Not finding what you are looking for?
2001 Ford Excursion Logo

Related Topics:

303 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers


Level 3 Expert

5516 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides