Question about 1994 Dodge Intrepid

1 Answer

Why is the check engine ligh on. on a 1994 dodge intrepid when it starts to get warm about 3-5 miles it will come on

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Expert
  • 49 Answers

Could be anything from a loose gas cap to bad o2 sensors. get the code read. it will read even if the light doesn't stay on

Posted on May 02, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1994 intrepid starts runs until warm then cuts off wont start until cools off


Chances are its something electrical, but thats a big list.
You'll have to rule out a few things and check for spark and fuel pressure when it won't start.

Jan 24, 2013 | 1994 Dodge Intrepid

1 Answer

How do i drain transmission fluid from a 1994 dodge intrepid


Remove the trans pan. Or pull one of the lines coming from trans to radiator. Start engine and it will shoot fluid. Just make sure someone is helping you and has the end of line in container and (wear safety glasses) run till you achieve the desired amount taken.

Apr 06, 2012 | 1994 Dodge Intrepid

1 Answer

I have a 2000 dodge intrepid. A few months ago the oil light started coming on only when at stop lights. Once you start going, it goes off, or if you rev up the engine it goes off. Now, it is running...


My Intrepid Did The Same Thing When Warm My Engines RPM Drops Down To 500 Which Is Too Low Have Someone You Know adjust The RPM's To About 700 Or 800 Rpm While The Car Is Warm & In Drive With Your Foot Firmly On The Brake While You Do This Operation Should Take Care Of The Problem It Did Mine

Jan 27, 2012 | 2000 Dodge Intrepid

1 Answer

My 1998 Dodge Intrepid 2.7 liter 152,000 miles idled fine in my driveway for 15 minutes while warming the car. It ran fine for about a mile and sputtered a couple of times, the engine smoothed out and then...


PROBABLY IF IT SOUNDS LIKE TAPPING YOU HAVE CLOGGED TIMING CHAIN TENSIONERS DON'T TRAY TO STARTED NO MORE.IF STILL RUNS TAKE IT TO THE NEAREST SHOP AND HAVE'M CHECK YOUR'E TENSIONERS. TO AVOID VALVE DAMAGE.

Jan 23, 2011 | 1998 Dodge Intrepid

1 Answer

2004 Dodge Intrepid "jumps" occasionally when braking?


if your car has the 2.7 litre you have to change the oil every 5oookm or 3000 miles and use the exact grade as per the book.
the 2.7 has small oil galleries.
you have low oil pressure and or idle speed.check the rpm and it should be 700 unloaded at warm temp.if the iac controller is bad and there is low idle,really low rpm could trigger the oil light to come on and the transmission vacuum controls will be causing strange behavior.

May 04, 2009 | 1999 Dodge Intrepid

1 Answer

1994 Dodge Intrepid clicks before starting


Weak battery or flaky starter solenoid. Check the condition of the wires betwixt the battery and the starter solenoid first. Also check the ground wire(s).

Mar 25, 2009 | 1994 Dodge Intrepid

2 Answers

My 1994 dodge intrepid only starts when it is above 40 degrees


I had a very similar problem as most did on this stalling out, no start, and no spark on my 1994 Dodge Intrepid 3.3L V6. I was told to watch my Tachometer in the car to see if it moved at all while cranking the engine over. It did not move. So that told me the crankshaft sensor was not picking up any signal what so ever. I changed it. The engine immediately started. So I left the engine run for approx. 25 minutes then the engine died. I had again lost spark but had minor RPM on the tachometer during engine crank. I dug thru all the wiring harnesses and found that when I moved the connector to the Coil pack/Module the engine would start. I got the problem narrowed down to the connector but have not replaced it yet. I put a little slack in the harness the wires run in so the harness is not pulling on the connector. This has seemed to solve the problem for me. At least for now. richmond980@yahoo.com

Jan 08, 2009 | 1994 Dodge Intrepid

2 Answers

1994 DODGE INTREPID 3.3 WARM UP MISS OUT


sounds like a coil pac problem soon as these get hot they do what "YOU" described use OBD 2 scan tool to be positive good luck

Dec 23, 2008 | 1994 Dodge Intrepid

1 Answer

1994 intrepid


dodgy ignition switch possibly

Nov 11, 2008 | 1994 Dodge Intrepid

Not finding what you are looking for?
1994 Dodge Intrepid Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75197 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...