Question about 1989 Ford Bronco II

1 Answer

89 ford bronco 2 starts fine, idles fine,

89 ford bronco 2 starts fine, idles fine, when i hit the gas boggs really hard, if i just barely mash the gas it seems to be fine, if i hold the gas to three thousand rpm it will jump between two and three thousand rpm wich it boggs and returns normal.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 180 Answers

Replace the fuel filter

Posted on May 02, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 96 ford bronco runs rough on acceleration,idles fine. Runs good under light acceleration but if hit the gas hard runs bad and pops. Changed fuel filter no change.what next?


givit a tune--new distributer cap--new plugs and cables--------also have air intake cleaned plus idle control--use a nonchlorinatd solvent sold a napa etc

Jul 22, 2014 | 1996 Ford Bronco

1 Answer

Why would my 89' Ford Bronco have difficulties to start at times?


You really should have said what times you had problems.. Just saying at times does not help. If the engine is hot and is hard to start you should look at the heat shield between the exhaust and the starter. a hot starter = hard to start. ALSO if your timing is advanced it will cause it to be hard to start. also if your battery is weak.

Jul 11, 2014 | 1989 Ford Bronco

1 Answer

1989 ford bronco 2 ignition problems maybe


It could have a weak or failing ignition coil. The other thing I can think to look for would be an exhaust restriction.. (clogged catalytic converter)

What about the fuel filter?? was it replaced?

Jan 30, 2013 | 1989 Ford Bronco II

1 Answer

I have a 89 bronco 2 with a 2.9 engine. I have


Try replacing the Throttle Positioning Sensor
Have the codes checked
You may need to clean the Mass Air Flow Sensor
this is best done by a professional as it contains some very sensitive wires and they are easily broken
The MAF is very expensive to replace

Mar 29, 2010 | 1986 Ford Bronco II

1 Answer

I have an 1988 ford bronco 2 automatic V6 i pulled


There are shift solenoids in the transmission and apparently there's a problem them. I would get it to a trany shop and have it checked right away. If you continue to drive it you will ruin the transmission. Are sure you put the right computer in the vehicle? If you put a computer from a Bronco II with a manual trans in a vehicle with an automatic trans, the trans won't work right.

Jan 22, 2010 | 1988 Ford Bronco

1 Answer

1988 cutlass ciera boggs down when i accelerate


Hello! You have symptoms that point to incorrect fuel pressure.
First have the fuel pressure tested as follows; #1...engine running at idle: 13- 20 psi. #2...key on engine off: 23-30 psi. If pressure is incorrect change the fuel pump.

Does the engine "surge" at idle? If so, check the "fuel injection pressure regulator idle air control valve". Apply a vacuum to it; If fuel flows it is not the problem.


Guru.............saailer


Dec 13, 2009 | 1988 Oldsmobile Cutlass Ciera

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

398 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77194 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22265 Answers

fordexpert

Level 3 Expert

5579 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...