Question about 2002 Nissan Sentra

Open Question

Car: 2002 nissan sentra, 1.8 L How does the upper drive belt ( the small one) get removed and installed??

Posted by on

  • babul4 May 11, 2010

    Here is your solution » BMW »
    Buick »
    Chevrolet » Chrysler » Dodge » Ford » GMC » Honda » Hyundai » Jaguar » Lincoln » Mazda » Mercury » Mitsubishi » Nissan » Oldsmobile » Pontiac » Saturn » Subaru » Suzuki » Toyota » Volkswagen » Volvo a

×

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does it have timing belt or chain


Both the 1.8 and 2.5 have chains. After the xterria 2003 all nissans have chain camshaft drives. Last sedan with belt was the 1994 Maxima

Lots of images of Timing chain kits here

http://www.bing.com/images/search?q=2002+Nissan+Sentra+timing+belt+or+chain&FORM=HDRSC2

Aug 14, 2015 | 2002 Nissan Sentra

1 Answer

I have nissan sentra 99 motor 2.0 timing belt


Assuming that is a motor out of a 1999 Nissan Sentra this link should be a link to a Timing Belt Diagram. There is insufficient space to explain everything involved in removing the old one and all the parts that have to be pulled, if you need those directions I highly recommend you get the Haynes Repair Manual on a 1999 Nissan Sentra for those instructions.

http://www.2carpros.com/diagrams/nissan/sentra/1999

Aug 28, 2011 | 2002 Nissan Sentra

2 Answers

Alternator


1996 Nissan/Datsun Sentra 1.6L SFI DOHC 4cyl

Nissan Sentra/Pulsar/NX 1982-1996 Repair Guide
The alternators for Pulsar and Sentra have not changed much over the years. However, the 1987-88 alternators for Pulsar and Sentra have a different internal diode assembly.
  1. Disconnect the negative battery terminal.
  2. Disconnect the 2 lead wires and connector from the alternator.
  3. Loosen the drive belt adjusting bolt and remove the belt.
  4. Unscrew the alternator attaching bolts and remove the alternator from the vehicle.
To install:
  1. Install the alternator and retaining bolts loosely.
  2. Install the belt and connect the wiring.
  3. Adjust the belt as outlined in . Torque the retaining bolts to 25 ft. lbs. (34 Nm).

I hope help you with this (rated this help).

Sep 11, 2009 | 1996 Nissan Sentra

2 Answers

Where is the blower resistor on a 2001 Nissan Sentra?


Its actually not that bad to change. If you open the glove box and remove the screws then the screws along the bottom of the glove box at the bottom of the dash the box will slide out. Remember to disconnect the light if it has one. Now you will be able to see the underside of the dash. You can see a large black box that has wires and vacuum lines all over. You need to locate a small flat plate with two screws and a plug in the middle. Disconnect the plug and remove the screws. The resistor will come straight out. The back side will look like small coiled up springs of different sizes. Install in reverse.Hope this helps. Good luck. Please re-post with updates. Thanks cj2176.

Jul 13, 2009 | 2002 Nissan Sentra

1 Answer

Replace timng belt


well maybe there was some mis-communication there , nissan stopped using timing belts in sentra's and actually most all models in 2000 , maybe they were telling you that your serpentine belt needed changed ? but to answer your question , you do not have a timing belt in your 2002 nissan sentra . its a chain . thanks

J5

Jan 19, 2009 | 2002 Nissan Sentra

1 Answer

Squealing noise in 2002 Nissan Sentra


Seems like a drive belt problem, to confirm pour some water on belts the noise should go away or may get louder for a second. If either happens the belt or belts needs to be adjusted or replaced. Good Luck, If I fixed ya, leave me a FIX-YA comment thanks

Dec 18, 2008 | 2002 Nissan Sentra

2 Answers

2002 Nissan Sentra


its your engine belts need to change them. have a nice day

Dec 18, 2008 | 2002 Nissan Sentra

1 Answer

Front crank seal slight leak 1998 nissan sentra


hi!replace the crankshaft oil seal.most of nissan's vehicles use timing chain so just remove the drive blets and the crankshaft pulley.use a screw driver to remove the old oil seal. install a new one.guaranteed the leak will stop.

Aug 11, 2008 | 2002 Nissan Sentra

Not finding what you are looking for?
2002 Nissan Sentra Logo

Related Topics:

54 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75817 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

723 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...