Question about 2003 Chevrolet S-10

1 Answer

How to adjust doors on a chevrolet s-10 pick-up truck? The driver side door has a bit of gap at the top when the door is shut & leaks when it rains .

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Master
  • 10,319 Answers

The door hinge pins and bushings need replacing

Try this website to download a free manual

Posted on May 01, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1993 Ford f150, driver's side door catches on the front finder when you try to open it

Fender needs adjusted. Loosen the bolts on top, pry the fender forward, hold it there and tighten the bolts. There should be about 1/4 inch gap between the fender and door.

Jun 28, 2015 | Ford Cars & Trucks

2 Answers

How to adjust pass door of 03 blazer

Oh is the "A" Frame OK, also the door frame where the hinges are your looking for damage distortion creases etc.
As the body guys say a dent is fixed by reversing how it happened, so to me this will be a body shop job. Ask a friend in the know to have a quick look see.

Regards David

Dec 25, 2017 | 2003 Chevrolet TrailBlazer

2 Answers

Power windows and locks stopped working but only on the driver side

open driver's door, and check wiring between the door and hinge pillar due to open and closing the door, the wiring will break, use a razor knife and split the rubber cover and check for a broken wire, solder as needed. if no wire is broken, suspect master switch on the driver's door.

Jul 27, 2010 | 2006 Chevrolet Trailblazer

2 Answers

AC blows hot air on the driver side and cold air on the passenger side

You may have a bad temperature door actuator motor on the drivers side. The actuator is what moves the temperature blend door and when it fails it usually moves the door all the way to the "hot" position. Sometimes if you shut the vehicle off for a bit then restart it the system will work fine for a while then the actuator will again swing the door all the way open or shut. I've replaced several of these actuators [both drivers side and passenger side] for similar problems.

Jul 08, 2010 | 2005 Chevrolet Silverado

1 Answer

Driver side window leaks at top

it sounds like you need to replace the door bushings. thier only abot a couple bucks and a afternoon hopes this helps

Nov 19, 2009 | 2001 Pontiac Firebird

1 Answer

2001 door adjustment

you might check to see if the hinges are worn out.
Grab the rear of the door and lift up. otherwise, it sounds like the window frame needs to be bent in.
When i worked In the body shop we would sit in the seat with door slightly open, put our knee againts the rear of the door, grab it at the top and pull in real hard untill the window frame bends in.

Nov 18, 2009 | 2001 Dodge Ram 2500 Truck

1 Answer

2001 mitsubishi spyder leaks above driver side window when it rains where do i get replacement weather stripping or do i have to replace the whole top?

te stops may have to be adjusted but must be done professionally or window can hit top when shutting the door . Also inspect the seal .

Nov 02, 2009 | 2001 Mitsubishi Eclipse Spyder

1 Answer

Driver side door and tailgate leaks when it rains.not through the window but between the door and car body pretty sure its the weather strip but not sure..also, the top part of my window to my...

First chk the seals and see if there is a gap. If there is, you may have to ajust the hinges. Loosen the hinge bolts and. Do not remove them . Leave them loose enough to push the top in with the windoe down and latched. Then push the wind inward. Then carefully open the window and tighten two bolts on each hinge. Then ck the closing and alighment. If still needs more then repeat process but leave the bolts a litlle more snug so when you move it, it will stay untill you get the bolts tight. Good Luck, -Ned-

Sep 09, 2009 | 1997 Chevrolet Blazer

1 Answer

How do i shim the driver side door

you can get some shims or washers, loosen the bolts on the hing pillar and put in one at a time. then tighten down and check the door gaps, if still off repete untill all the gaps are good

Aug 10, 2009 | 2004 Chevrolet S-10

1 Answer

Door hinge

The door is bolted to the hinges, work out which hinge has most movement in its hinge (Top or lower), this one will need to be moved forward or back to compensate for wear in hinge.
Also take note of door gap along fender (When door is closed) to
prevent it damaging paintwork.
Hope this helps, MMP

Aug 09, 2008 | 2001 Chevrolet Silverado

Not finding what you are looking for?
2003 Chevrolet S-10 Logo

407 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

79077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides