Question about 1997 Mitsubishi Eclipse

Open Question

How to replace water pump om mitsubishi eclipse

How to replace a water pump on mitsubishi eclipse 1997 turbo

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
dustyboner
  • 331 Answers

SOURCE: self diagnostic test codes

anytime you do the self-diagnostic you will almost always get those 2 codes.

12 - direct power input to the PCM has been disconnected within the last 50 key-on cycles

55 - End of error messages

Posted on Jan 25, 2009

Ad
DSMprostyle
  • 37 Answers

SOURCE: crankshaft position sensor location

Hello. One way to check if it is working is when you try to start the car does the needle move on you tac? If not then your crank sensor is more then likely the problem. It is located on the backside of the engine under the intake manifold. If is in about the center of the block. There will be a 10mm bolt holding the sensor in. If you decide to change it yourself (not to terrible of a job) unplug the sensor, remove the bolt and spin it back and forth slightly while pulling it out. It may be stoburn and you might have to work at it for a little bit (not a done of room) but it will come. When it's out the sensor will be shaped kind of like an L. I have changed a few of these over time and they can be a little stoburn. To install just reverse the process.

Posted on Mar 26, 2009

  • 35 Answers

SOURCE: brake light bulb Mitsubishi Eclipse Cars

look for access panels in rear hatch there will be one on each side remove those and there will be 10 ml nuts holding the light housings on remove those then you can access the lights

Posted on Jul 02, 2009

  • 117 Answers

SOURCE: engine will not idle will cut off as soon as foot is off peadle

possible solution, there is an idle circuit on your mass airflow sensor that allows air to bypass the throttle plate. if this little actuator is not working then no idle air will be able to get by the throttle plate which then tells the mass air flow sensor that there is no air moving which in turn tells the computer to stop pumping gas into the cylinders...which make your car shut off. hope this helps, cheers

Posted on Jul 08, 2009

  • 138 Answers

SOURCE: need to replace the water pump on my 1997

If nothing in the cooling system has been touched in the life of the vehicle, you should have the cooling system flushed, new thermostat and new hoses (upper/lower radiator hoses and input/output heater core hoses). A new belt probably wouldn't hurt, but it all depends on the maintenance history of the car.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why is my 98 mitsubishi eclipse 2.0 non turbo is making a horrible squeaking sound about 2 minutes of running engine? Was told it could be my power steering pulley. What does this mean? Do I tighten i


The mechanic who did the work may have gotten coolant on the drive belts or not sufficiently adjusted the belt tension . I'd replace the belt especially if the sides of the belt are shiny.

Oct 10, 2014 | 1998 Mitsubishi Eclipse

1 Answer

I have a 1997 Mitsubishi Eclipse Gs non turbo that has a water outlet that has been pitted and needs replacing. I cannot find the outlet for the non-turbo. Any suggestions?


Your problem is most likely because you are describing your vehicle as a "Gs". The only similar listings in the catalog are for a "GSX". (The parts counter person probably has no clue that there is a difference) The GSX is only built in a turbo version, therefore you will not find a water outlet for the non-turbo version...it simply does not exist.

Now, if you simply describe it as an Eclipse, there are water outlets listed for the turbo 2.0L, the non-turbo 2.0L and the non-turbo 2.4L engines. You did not bother to mention engine size, so I will list the part numbers for BOTH of the non-turbo engines.

For the 2.4L engine: Compressor Works Part Number 815517

For the 2.0L engine: Compressor Works Part Number 815576

Both are available from AutoZone

Apr 17, 2011 | 1997 Mitsubishi Eclipse

1 Answer

How do i reset my timing gears on my 1998 mitsubishi eclipse 2.0


this link is to a step-by-step guide for installing the timing belt. 2.0L NT TIMING BELT diy

if your car is the 2.4L non-turbo let me know and i'll post up the procedure for that motor.

Jun 01, 2010 | 1998 Mitsubishi Eclipse

1 Answer

Location of the fuel reay switch


The fuel pump relay for the 2.0 non turbo is mounted on a bracket at the
left rear of the engine compartment. On the 2.0&2.4 turbo it's located
behind the center of the dash. Hope this helps.

May 16, 2010 | 1997 Mitsubishi Eclipse

1 Answer

What is the firing order for a 97 eclispe spyder


1997 Mitsubishi Eclipse Spyder GS-T FWD 2.0 liter DOHC Turbo L4

a6519be.gif



1997 Mitsubishi Eclipse Spyder GS FWD 2.4 liter SOHC L4

97f1103.gif

Hope help with this (rememmber rated this).

Apr 12, 2010 | 1997 Mitsubishi Eclipse

1 Answer

Need to replace fuel pump - 1997 eclipse turbo -where is it located?


in the fuel tank. replace the filter also. happy holidays

Dec 29, 2009 | 1997 Mitsubishi Eclipse

1 Answer

Engine will not idle will cut off as soon as foot is off peadle


possible solution, there is an idle circuit on your mass airflow sensor that allows air to bypass the throttle plate. if this little actuator is not working then no idle air will be able to get by the throttle plate which then tells the mass air flow sensor that there is no air moving which in turn tells the computer to stop pumping gas into the cylinders...which make your car shut off. hope this helps, cheers

Jul 08, 2009 | 1997 Mitsubishi Eclipse

1 Answer

Re: 1997 Eclipse


wowwwww it is so dificult, and might be between 7 to 11 hrs labor to do it, depending on engine size.

Jun 22, 2008 | 1997 Mitsubishi Eclipse

Not finding what you are looking for?
1997 Mitsubishi Eclipse Logo

Related Topics:

357 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76691 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8531 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...