Question about 2004 Pontiac Bonneville

1 Answer

How to remove the plastic covering to remove the radio on a 2004 pontiac bonneville

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Pontiac Master
  • 373 Answers

Sorry for late reply, but may help someone...
Remove the ignition ring by carefully pulling it straight out

how to remove the plastic covering to remove the - zeevert_9.jpg
Remove the 2 pin clips above the speedo but pushing the center button of the clips IN. After you get them out, you can reset them by pushing ther buttons OUT.

zeevert_10.jpg I'm pretty sure that the panel can then be removed by pulling it straight out against thehow to remove the plastic covering to remove the - zeevert_11.jpging clips.

zeevert_11.jpg

Posted on Nov 16, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 bonneville air only flows out of the vents, will not switch to defrost or heat. Blower and temperature are fine


Dash Switch Assembly's are 90 % the cause of this Problem since they are Made of all Plastic Parts but every once in a while You get a bad heater control Module.

Sep 25, 2014 | 2004 Pontiac Bonneville

1 Answer

The radio display panel went dark on my 2004 bonneville


Check your fuse box ... could be back lighting or or the radio itself ...look for a blown fuse ...

Dec 16, 2010 | 2002 Pontiac Bonneville

1 Answer

Where is the starter located on a 1999 pontiac bonneville


Open the hood, look down behind the fans on the front of the engine at the bottom right side. You will need to disconnect the negative battery cable; jack up and safely support the car, get underneath, remove the wide plastic splash pan (10 mm bolts) that goes between the bumper and the front crossmember. Once that is out, you can easily see - and remove - the connections on the starter. One big one, (15mm?)a positive cable from the battery, and one little one, (5/16 or 9/32) from the trans. Remove the 2 plastic flywheel covers. (10 mm bolts - Gotta kinda twist the one to get it out.) Then remove the two 15mm (head) bolts that hold in the starter. Make note of any shims that fall out when you remove the starter.

Apr 10, 2010 | 1998 Pontiac Bonneville

1 Answer

Need to replace a broken left tail light in a 1999 Pontiac Bonneville.


to remove open trunk remove covering behind light.remove plastic retainers from behind lamp. pull light out remove sockets,

Oct 13, 2009 | 1999 Pontiac Bonneville

1 Answer

Ignition relay??


under hood on the driver side under a plastic cover usaully near the battery

Oct 08, 2009 | 1998 Pontiac Bonneville

1 Answer

How do you take the radio out of a 1995 bonneville


You need to pull the plastic cover that runs all along your dashboard, a/c heater controls,and radio. You don't have to pull it out completely just enough where you can unscrew the 4 screws that hold the radio in its place. Just take a flat head screw driver and gently pry the plastic cover off around the radio area. You also might need to pull (with your fingers or flat head again) the cover by where the a/c vents are. Pull out as much as you need so you have room to stick a screw driver in. Once you unscrew the screws (bolts) pull the radio out slowly and begin to pull out the wire harnesses and antenna cable from the back of the radio and there you have!! If your going to replace your radio you will need a single din and you have to buy the adapter piece to put it in. A double din radio will not fit. Good luck.

Aug 31, 2009 | 1995 Pontiac Bonneville

2 Answers

Where is the relay fuse box located on a 1997 pontiac bonneville


It is under your dash board in the driver side foot well.

Jul 09, 2009 | 1997 Pontiac Bonneville

Not finding what you are looking for?
2004 Pontiac Bonneville Logo

Related Topics:

300 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...