Question about 1995 Honda Accord

1 Answer

Need to replace c v shafts both sides . auto tran 4 cyl .how hard is it to do

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 22,095 Answers

Easy shouldnt take long ,about an hour a side max for a weekend mechanic

Posted on Apr 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2000 ply. voyeger 4 cyl. auto trans.on hard stops in drive acts like netural ! than bang burns rubber


Hi, have you checked the fluid level and when was the last transmission filter replacement?

Nov 14, 2011 | 2000 Plymouth Voyager

1 Answer

I need detailed instructions on how to replace the clutch on a 1987 Ford Bronco II, 4wd, manual trans, 6 cyl. Can you tell me where I might find this information online?


It is a copyright infringement to give info copied from a book ,unless you pay for it...I can tell you the fnt end of truck needs to be jacked up so you have plenty of room for repair.also if fluids are drained from trans and transfer case they will be able to handle better...
remove fnt and rear drive shafts and trans shift linkage . also the transfer case linkage . the speedo cable and wirig to trans will need to come off....now support the trans with a floorjack and remove the crossmember support... let the jack down a little to acess to top trans to engine bolts. thenremove all bolt except 2 ...one on each side take the bolts out of clutch slave cylinder and move away from your work...reposition jack to the center of trns and remove trans carfully.one hand on trans tail shaft and one on the jack handle. lower trans assembly to the ground after you have cleared the clutch..now follow instructions in new clutch and reinstall ...

Feb 17, 2011 | Ford Bronco II Cars & Trucks

1 Answer

1997 Honda Accord, 4 cyl, auto trans. When I turn


The starter sit on top I belive on the passenger side above the transmission, have some one hold the key to start while you tap or even hit the starter some time it will crank over if it does replace it, not that big of a job. If it still dont start there a big wire that one comes from the battery and a small one that come from you ignition switch ( key ) jump those two wire's ( if stander transmission make sure you have it out of gear ) there should be voltage at big wire all the time, if it still dont crank over replace starter assembly.Hope this was very helpful.

May 11, 2010 | 1997 Honda Accord

1 Answer

No overdrive


this is a hard mechanical fault in the overdrive forward clutch, u must overhaul the trans to fix this.

Jun 18, 2009 | 2000 Mitsubishi Galant

2 Answers

I need to know where to find the speed sensor on a 98 Ford Contour lx auto trans 4 cyl 2.0


i think the vechile speed sensor on is located on the bottom left side of your transmission

Jun 16, 2009 | 1998 Ford Windstar

3 Answers

Slipping auto trans in 94 chevy truck


actually i would say no because there are 6 cyl transmissions with 4 frction plates and v8's have 5 friction plates in the forward planetary gear

Mar 27, 2009 | 1994 Chevrolet C1500

1 Answer

Location of auto trans dip stick on 91 Ford Tempo 4 cyl.


It's right next to the air filter and behind the radiator fan and to the right of the oil dipstick. The transmissions is black and the oils is yellow. If it's a manual, there's no dipstick there. If not check close to the forewall towards the back of the engine.

Feb 02, 2009 | 1991 Ford Tempo 4 Door

Not finding what you are looking for?
1995 Honda Accord Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...