Question about 1988 Chevrolet S-10

2 Answers

My truck wont start and when it does it dies again and its cranking slow

Posted by on

Ad

2 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 23 Answers

Check the timeing

Posted on Apr 30, 2010

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Guru:

    An expert who has written 7 tips or uploaded 3 video tips

  • Expert
  • 63 Answers

How long you crank it for? may be something in the starter bad or how does the battery look on your gauge?

Posted on Apr 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car turns over but wont start


No the o2 sensors can not stop the car from starting. I would start by spraying some starting fluid down throttle body see if it starts runs dies if this occurs you have a fuel delivery problem if still just cranks then you have a ignition problem (no Spark)

Apr 19, 2014 | 1991 Cadillac DeVille

1 Answer

Pontiac sunfire died while driving gauges stopped working


try hold up the key while starting, shot in the dark. if it startes remove extra items off key ring

Apr 01, 2017 | Pontiac Sunfire Cars & Trucks

1 Answer

2000 kia sephia cranks but engine wont run


The fuel pump may have died. Can you hear it turn on briefly, by turning the key to "on"? You may have to stand by the gas tank while someone turns the key to on. It should turn on for about 2 seconds and then stop, after pressurizing the fuel system. If you don't hear it, then check the fuel pump fuse. If the fuse is good, and the pump won't run, one needs to check that the fuel pump wire at the tank connector has battery voltage on it when the engine is cranking-then, you can assume the pump needs replacing.
If the pump is working and you have gas up to the engine, you would next check the ignition system. Start that by checking for spark on one of the spark plug wires.

Apr 21, 2013 | 2000 Kia Sephia

1 Answer

Car dies slowly while driving


I would suggest checking the fuel pressure when the engine dies. You may have to buy a fuel pressure gauge and carry it with you, or see if letting the car idle for 30 min will duplicate the problem. Could be a fuel pump or relay.

Dec 18, 2012 | Cars & Trucks

2 Answers

96 Dodge Runs fine but after warms up it dies,cools n will crank n run good then dies again after warming up.


if you dont know anything about cars then take it to a dealer as it will be cheaper in the long run

Apr 08, 2012 | Dodge Cars & Trucks

1 Answer

Battery was weak so i put a charge on it. car slow to crank over but started but will not keep running.


+charge batt to full, start the car, then turn on your headlights and heater blower. if the car dies and wont start back/dead batt, check/replace alternator

Dec 16, 2010 | 2004 Toyota Avalon

1 Answer

Had to take timing belt off ,need to reset


is it a clean crank or a lazy slow crank ?
if clean crank check to see if you get a spark or pulse at the injector
slow and lazy crank
double check the timing again
or check to see if you broke or left the crank angle sensor unplug
good luck

May 09, 2010 | 1999 Dodge Intrepid

1 Answer

Dies and wont restart. 1991 bmw 750il


You have a cam or crank sensor that has gone out.

May 01, 2009 | 1991 BMW 7 Series

1 Answer

Cranks but wont start


is the engine light on, check for codes.
i would then test for fuel pressure at the rail.
replace fuel filter,
check for spark at plug.
dirty air filter.
i could go on...

Feb 22, 2009 | 1985 Ford F150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

42 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

79847 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...