Question about 1992 Toyota Pickup

1 Answer

92 toyota 3.0 truck starts but quits when key is in the run

Truck starts but quits when key is in the run position. It will stay running if you hold the key in start position. The mechanic has cleaned all grounds,tested computer,mass air sensor,changed distributer rotor,fuel pump, he quit and moved to another mechanic after 1300$ still not running..

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 31 Answers

Sounds like u have an ing switch problem weak or broken spring in switch ?

Posted on Apr 30, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Truck will start and then stops just started acting up


Found on a '92 Toyota pickup w/V6, a bad/intermittent fuel pump relay.
Had fuel rail pressure so fooled us initially, found by listening to pump run then quit, cycle key and pump would run again then quit, sometimes when trying to start, motor would start and run for a few seconds then quit, or not start at all, this created by intermittent relay operation. Need two people, one at passenger side by tank and other to work ignition switch.
Relay located behind right, passenger kick panel, dealer item I believe about $28.00.
Just another possibility.

Mar 12, 2014 | 1992 Toyota Pickup

1 Answer

1997 toyota 4runner starts but wont stay running


Could be your throttle position sensor,here's how to check.Here's the part.

Feb 17, 2013 | Toyota Cars & Trucks

2 Answers

92 Toyota 4runner truck was running perfectly fine Later in the day went to start and the alarm just started going off and wouldn't turn off. Truck won't start even with keys turned in igniti


The alarm system somehow got activated , this is usually because the battery becomes discharged or disconnected try doing this:
Remove the key from the ignition
disconnect the negative battery terminal
put the key back in and turn to ON
exit the truck and leave door open
reconnect the battery terminal
get in and leave door open, if the alarm horn stays off it should start.

Dec 07, 2012 | 1992 Toyota 4Runner

2 Answers

1995 honda odyssey starts and then dies


Isince it cranks, means you have power, elctric system is ok! I guess.. this could be a result of gas delivery problem... either a pump or gas circuit controller.... OR a small propable reason if you have an immobilizer (electronic chip on key!)... but there should be the securit key highlithed on dashboard...

Sep 01, 2012 | 1995 Honda Odyssey

1 Answer

2000 honda cvic will not start but if you push on the it will try to start but will not stay running


Do you notice anything unusual with the dash lights when you turn the key on. All the warning lights should illuminate. If they do not but then come on as you start to rotate the key into the start position than you probably have a bad ignition switch.

If you turn the key to the start position and hold it there (only do this for a few seconds) will the car stay running until you let go of the key? Another clue that the ignition switch may be bad.

if you turn the key to the start position and the vehicle starts slowly let the key rotate back to the run position until the starter disengages. If the vehicle continues to run let go of the key. If the vehicle stalls than the ignition switch is definitely bad.

Feb 24, 2012 | 2000 Honda Civic

2 Answers

93 accord starts but runs only as long as I hold the key in start


replace the ignition starter switch, this switch is attached to the back of the ignition key cylinder, this a very common issue on your car. remove the **** shell covers of the column to access very easy job here is the part number and price.
ACDELCO Part # E1463 Price $46.79

Jul 23, 2009 | 2001 Honda Accord

1 Answer

Ignition won't stay in running position.


You are gonna need a New Ignition. Will solve this Problem.

Jan 04, 2009 | 1998 GMC Sierra

2 Answers

When you try to start car the alarm goes off and car wont start and horn goes on and off the locks click back and forth


'99 camry: with alarm sounding. turn key to "ON" position and press in and hold alarm button (red two position (in /out) on dash board. Button should go from flashing red to solid red. Release button when it stays lit (solid bright red) . Alarm is now in disabled mode and engine should crank when key is turned to "start" position. "Thank you" for over the phone tech support at Richardson Toyota in Texas.

Aug 03, 2008 | 1999 Toyota Camry

Not finding what you are looking for?
1992 Toyota Pickup Logo

Related Topics:

121 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...