Question about 1999 Toyota Camry

1 Answer

After driving a while, I pull up to a stop light and after several seconds of waiting it dies. The problem is intermittent. Already replaced idle motor and crank sensor and had fuel system treatment. I can usually get it restarted after a few tries.

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 63 Answers

Try cleaning both the MAF sensor and the Throttle Body. Both require different cleaners, but if either is dirty it will cause the condition that you are having. Cleaning each is rather easy, but take caution with the MAF sensor, it is very fragile and can be damaged easily. Follow the instructions on the cleaning products and you will fine.

Posted on Apr 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

No acceleration when pressing accelerator, only idle speed


do you have a engine light on if so what's the code

Jun 22, 2017 | 2004 Volvo XC90

1 Answer

I have a 2003 RAV4, Drives ok, but engine dies if stopped with AC running or in drive. One day Check engine light came on vehicle would not start. replace both gas pumps. Once the car is moving it is ok,,...


Most likely your idle speed is too low due to dirt on throttle plates and IAC valve. cleaning these items usually restores normal idle operation.

Dec 25, 2017 | 2003 Toyota RAV4

1 Answer

Same thing happened to me!


your crankshaft positon sensor is defective. Replace it and the epc will never come back and no more dying out. this happened to me several times and it would just come and go. i replaced it and now the car starts right away and the epc light hasnt returned since

Aug 10, 2009 | 2002 Audi A4

1 Answer

2002 gmc sierra, 3500, 8.1, flashing mil, dies, starts rough idle



First buy the alldata subscription for your unit and read the engine power management system, once you understand this then you will see you don't need a scanner, you can code out if it's a engine problem then read the codes itself with a paper clip. Then once you get the codes post them here to get a better answer, the more information you can provide the better the answer you will get. A digital test meter will be better than a scanner. Without understanding the engine management system you won't be able to fix it without replacing a lot of parts.

Aug 02, 2009 | GMC Sierra 3500 Cars & Trucks

3 Answers

'98 Toyota 4Runner Won't Idle -Intermittent Problem


Hello;
The problem could actually be in the transmission. Have the filter and fluid changed and see if the problem recurs. You may havesome dirt in the fluid that is sticking one of the solenoids. Once you stop and rest it for a while, the junk drops to the bottom and you can drive normal again.
Hope this helps and rate me highly.
Thanks;
Rich
RPM Northwest

Feb 07, 2009 | 1998 Toyota 4Runner

1 Answer

91 Dodge ram 50 ignition problem, rough idle in drive,dies when braking


my ram 50 starts just like any other vehicle, (no light switch pulling whatso ever), it sounds like somebody haas rewired something wrong or you have a loose connection and when you hit a large enough bump it cuts your power. Start it up and find a speed bump somewhere and drive over it enough to give your truck a jolt and see if it dies.

Oct 23, 2008 | 1991 Dodge Power Ram 50

1 Answer

Car battery


You have a very common problem. You have lost the "base idle" paramater, by changing the battery. What you need to do is drive the car thru several "drive cylces". Drive it in stop & go traffic, stop & let it idle for 2 minutes...then get an the expressway, engage passing gear several times. Pull off somewhere safe, let it idle, and duplicate the cycle again. This will teach the ECU the base idle, and you problem will vanish. We do this every day, for the same issue. Common problem, easy fix.

Oct 15, 2008 | 2003 Toyota Camry

Not finding what you are looking for?
1999 Toyota Camry Logo

Related Topics:

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

79186 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...