Question about 2009 Pontiac G6

1 Answer

2009 G6, hit chuck hole, now tire rubs back of wheel well

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Pontiac Master
  • 3,854 Answers

You have parts that are broken and needs to be replaced. Your going to have to bring the car to the dealer and have them determine which front suspension components needs to be replace.
Thank you for using fixya and be safe.

Posted on Apr 29, 2010


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How to service/replace tire monitors on 2009 pontiac g6

You will need a tire shop that has the communication tool. The only way to access the TPS sensors are by removing the tire and unbolting them from the wheel. Most likely your battery is getting weak and the signal is getting too low for your BMC to pick up.

Mar 26, 2018 | Pontiac Cars & Trucks

1 Answer

Rims. well i was wondering if i will need a tire balance and tire rotation for a new set of rims

If you have 3o-35,000 miles on your car, you may be due for new tires. Tires will ware out, you may have hit a few pot holes,or had a few flats. Manufacturers usually warrenty tires for new cars for about the same mileage I stated above. If your tires are waring well possibly you only need a wheel balancing. Take your car to a tire dealer in your area , and have them check for you. GOOD LUCK.

Sep 25, 2011 | 2009 Hyundai Accent

1 Answer

I have a Nissan Maxima 1997 model the tyres size are P205/65R15. My question is Would Kumho 352 with rims diameter "16 fits on them?

It is possible that they might work if you use avery low-profile tire on them. Take one of the wheels off of the front and place the wheel on the hub. Make sure that the bolt holes line up properly and that the center holeof the rim fits the shoulder on the hub correctly. Put a couple ug nuts on it and turn the wheel around to see if it is going to rub on the brake calipers or other components. If this is OK, then you need to choose some tires that will make the overall diameter of the tire and wheel assembly as close as possible to the overall diameter of the original tires. If your tires are too tall. they will hit the fender when you hit bumps or when you are turning. This will also affect the accuracy of your speedometer.

Has this been helpfull? If so, please take a moment
to provide some feedback by rating my answer.

Jan 16, 2011 | 1997 Nissan Maxima

2 Answers

I'm wanting to put 2009 Wrangler tires on my 1989 wrangler. Do you know if I will have to replace the entire back end? Or just switch the wheels out?

they should fit--only problem would would be a turning clearance up front check clearance by turning wheel all the way to left and make sure tires clear frame and front end components than do same all the way to right

Jan 26, 2010 | 1989 Jeep Wrangler

1 Answer

Car doesnt seem to vibrate much at 20-30 MPH but seems to at 60-70. Seems to be drivers side front

Check the wheel for balance and improper tread wear. If you did not hit a pot holes recently, you may find it is just a defective/damaged tire. Hard to say at this point.

Jan 18, 2010 | 2008 Pontiac G6 Sedan

2 Answers

Loud popping noise when turning.Seems to be coming from the drivers side front wheel

this could be a bad inner axle joint check to see if the axle boot on the left side is torn or missing also check the wheel bearings and tie rod ends by jacking up the front of the vehicle one corner at a time and grab the tire at the 9 o'clock and 3 o'clock position and wiggle it back and forth looking for excessive movement in the tie rod ends then reverse your hands to the top and bottom of the tire and try moving it from top to bottom checking for excessive wheel bearing movement it shouldn't move in or out at the top or bottom

Jan 01, 2010 | 2000 GMC Yukon XL

1 Answer

My 2009 Honda CRV just started vibrating this morning driving to work on the highway. Is there a problem?

Something is causing the vibrating, which is not normal. Need more info-at what speed does it occur, vibrating in steering wheel, or ? What type of climate where you are (driving through something that sticks to the tires can cause vibrating, like road tar). Has anyone else driven the car recently? Could they (or anyone)have hit a large pot hole, curb, minor accident? All these scenarios could cause what you describe. If something was hit as listed, you would need to have the wheel alignment checked, and also suspension components for any damage.

Dec 07, 2009 | 2009 Honda CR-V

1 Answer

Hit on right rear at wheel well, wheel pushed in at top what could be the problem?????thanksComment posted on May 11, 2200+9-

I don't understand your question fully (Hit?). If you were involved and a collision and your tire rubs on the fender, get the fender fixed ASAP! Tires can get peeled like a banana if they come into contact with any sharp piece of metal, and if its rubbing on the inner fender, then friction heat caused by this can cause the tire become weak in that area and subsequently blow out.... If that is not the problem, or case then her are more causes for tires rubbing...

Tires "Out of Alignment", non-factory rims and/or tires, wrong size,width, rim "off-set" etc., suspension coil springs and. or shocks (car sitting lower than usual), twisted chassis due to accident or other impacts

May 11, 2009 | 1992 Buick LeSabre

1 Answer

Steering wheel is vibrating and shaking

it would be one of two things.....most commonly, there is a busted belt in one of the tires. Hitting a chuck hole pretty hard will cause this, or a curb.....the other would be that one of the balance weights is gone, causing the tire to be out of balance.....

Apr 16, 2009 | Ford Taurus Cars & Trucks

Not finding what you are looking for?
2009 Pontiac G6 Logo

Related Topics:

48 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides