Question about 2005 Lincoln LS

1 Answer

Cannot access #8 sparkplug with appropriate aftermarket socket, will not fit in after coil has been removed, where do i go from here?

Posted by on

  • yadayada
    yadayada May 11, 2010

    somethnig is down inside the plug well u must do whatever it takes to get that out, i assume u have a thin walled socket.

×

1 Answer

I have a 2004 LS V8 and have no issues at all getting the plugs out. Why don't you have a selection of extensions for your ratchet. Use a standard length spark plug socket on #8

Also use the OEM plugs. Their made just for the LS.
NGK-FR5AP-11E was the OE Motorcraft Plug.

Buy -- NGK 6569 But not from the dealer. Too expensive

I assume you use Permatex Anti-Seize on the plug threads on all vehicles !!

Posted on Apr 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I change my sparkplugs on 2008 Fit?


Hi Anonymous. If your Honda Fit is the DSi engine type with 8 ( eight ) spark plugs, the only thing you do is as you do the replacement with the outer four spark plugs by loosing the 10mm bolts holding the coils,pulling the coils upwards and by using the 16mm spark plug socket loose the spark plugs and by using a magnet just pull out the old ones and refit the new ones. It is the same procedure you have to do for the inner side other 4 (four ) spark plugs,you just have to make a slight room to have access and using a shorter extension bar for the 16mm socket. Good luck.

Jun 17, 2014 | 2008 Honda Fit

1 Answer

How to change spark plugs in 2006 nissan xterra


Prior any doing I recommend to remove negative terminal on the battery, Carefully detach air flow meter wire plug by press the lip on it. Also unplug t p s and ground wires on the plenum,detach hose and sensor in one piece with the top of the air filter , use a twelve mm socket and remove intake manifold plenum bolts ,remove plenum ,Wha la unplug coil wires, with a ten mm socket remove coil unit .bingo...use 5/8 sparkplug socket.

Jun 14, 2014 | 2006 Nissan Xterra

1 Answer

I cant find spark plugs


I am writing you the method on how to change sparkplugs, you may now have an idea where spark plug is loacted.

The Ford Expedition uses eight spark plugs to accommodateits eight-cylinder engine. Replacing the spark plugs every 75,000 miles is animportant part of overall vehicle maintenance. 1. Disconnectthe negative (black) battery cable from the battery terminal. Remove thewiring harnesses from the spark plug coils. There will be four on each side ofthe engine block, which you can remove by simply pulling them out of the sparkplug coils. 2. Unscrew the 7mm bolt from each of the spark plug coils usinga socket wrench and 7mm socket. 3. Pull each spark plug coil out of the engine block. Pull themout slowly, being careful not to damage or tear the coils. 4. Use a socket wrench and spark plug socket to unscrew eachspark plug from the engine block. Once you remove these, discard them. 5. Place the new spark plugs into the engine block and tightenthem using the socket wrench and spark plug socket. 6. Slide the spark plug coils back into the engine block. 7. Bolt the spark plug coils back into place using a socketwrench and 7mm socket. 8. Reattachthe wiring harnesses to the spark plug coils. 9 . Connect the negative battery cable to the negative batteryterminal.

Nov 25, 2010 | 2003 Ford Expedition

1 Answer

How do I remove the rear three spark plugs on a toyota avalon 1998


Hi, to change spark plug first remove coil over connecting clip ensuring to depress connector release. Next remove coil over retaining bolts. Remove coil over carefully directing coil toward driver side until rubber end able to flex out of sparkplug access tube. Remove sparkplug using sparkplug socket with rubber insert. Had to remove ratchet to gain enough clearance. At this point you should be able to remove sparkplug by tilting extension & socket toward drivers side of car. Then lay horizontal & remove toward passenger side of car. If unable to gain access in this manner you probably have too long an extension. Take care as not to damage spark plug coil over as they are considerably expensive.

Sep 18, 2010 | 1998 Toyota Avalon

1 Answer

How to change sparkplugs. What steps are involved?


This ignition system utillizes COP (coil on plug) ignition, therefore there are no traditional plug wires. Insted there is an ignition coil mounted on each cam cover/ or head, they have to be unpluged and removed in order to access each plug. You will also need an extension on the 5/8" socket to get down in there. The Labor guide estimates approx 1.6 hours to do the replacement if you've never done it before and 0.5 if you have experience on it.

Sep 15, 2010 | 2002 Chevrolet TrailBlazer

1 Answer

Can someone tell me how can I replace the spark plugs on Dodge Caravan 2005, from above?


Open the hood to access the engine compartment. Locate the sparkplugs sitting to the side of the motor. Six wires run to the motor, three on each side.

Twist the rubber boot and pull away from the sparkplugs. This will expose the sparkplug.

Unbolt the sparkplug with a socket wrench. Use a 5/8-inch deep-well socket attached to the socket wrench.

Pull the sparkplug away from the motor. Discard the sparkplug.

Screw the sparkplug into the motor by hand. Make sure it is hand-tight.

Tighten the sparkplug with the socket wrench, using the deep-well sparkplug socket.

Click the wire to the sparkplug wire to the end of the sparkplug. Gently pull the wire to ensure it clicks into place.

Repeat the procedure for the remaining five sparkplugs. Change each sparkplug one at a time.

Aug 24, 2010 | Dodge Grand Caravan Cars & Trucks

1 Answer

How do I get the spark plugs out of my 1998 ford escort to replace with new ones? Also where does the pcp Valve go?


With you hood open and you are standing in front of the car sparkplug wires need to be removed,i suggest you remove them one at a time, under each wire the sparkplug is threaded into the cylinder head,using a 5/8 sparkplug socket remove the sparkplug and replace it with new properly gapped sparkplug.Note:if you remove all sparkplug wires at once the factory wires are generally numbered 1 2 3 4 the sparkplug closesed to the passenger fender is #1 and the one clossesed to the driver's fender is #4.Standing in front of vehicle the PCV Valve is located between #3 and #4 on the backside(intake side) of the engine fitted down into a rubber hose

Jul 17, 2010 | 1998 Ford Escort

1 Answer

CHANGING SPARK PLUGS 2002 TACOMA 4 CYLINDER


Starting on the pasenger side. Remove the intake tube running from the air filter box to the throttle body and disconnect enough tubes to swing it out of the way. The sparkplugs are down below the small coils you see at the end of the sparkplug wires. With a 10mm socket remove bolt holding the coil, disconnect the plug at the top of the coil by squeezing it at the top and pulling straight off the coils.

Pull the coil straight up. there will be about a 6 inch tube that connects to the top of the spark plug when inserted. You will need a 5/8 sparkplug socket and about 2 feet of extensions to make it easy on yourself. Insert the spark plug socket and extensions down the hole you removed the coils with the tube from and remove and replace the sparkplug. Reinstall your coil onto the engine and move to the next one until you have replaced all the plugs on the passenger side.

Make sure you reconnect all the plugs to the coils, hoses to the intake tube and reinstall your intake tube. The drivers side is a little easier. Pop the spark plug wires from their plastic holders to free enough slack to be able to pull your sparkplug wires out of the block. For the plug closest to the front of the engine you will need to remove the 10mm bolt holding the ground wires to the intake manifold to be able to free enough space for removing the plug.

For the middle plug you will need to remove the 10mm bolt holding the bracket that is holding one of the throttle cables at the top of the intake manifold. For the rear plug just pop the flexible hose that runs behind the black metal bracket straight up out of its clip and push it out of the way along with any other hoses that run through this area. Pull the spark plug wire from its place by pulling straight up just like with the coils. there will also be about a 6 inch tube running down to the spark plug at the bottom of these plugs.

Remove and replace the plugs same as before. make sure you reconnect all your hoses and wires to their previous locations. Doublecheck to make sure you reconnect all the ground wires/ brackets. Also you will need to use " twin ground electrode plugs" (see sticker on front of your plastic timing belt cover? to the right of the radiator hose).

May 27, 2010 | 2002 Toyota Tacoma

3 Answers

I bought new spark plugs for my 01 intrigue. They


the plugs you need are ac delco you can find the replacement proceedure on autozone.com vehicle repair guides

Oct 09, 2009 | 2001 Oldsmobile Intrigue

2 Answers

Where to find sparkplugs on engine


trace the plug wires and they should be in the valve covers. just pull out the plug wire and look in the hole of the cover you should see the plug way down there

Apr 13, 2009 | 1997 Oldsmobile Achieva

Not finding what you are looking for?
2005 Lincoln LS Logo

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

fordexpert

Level 3 Expert

5501 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...