Question about 1997 Chevrolet Blazer

3 Answers

97 blazer. what type of fuel pump? modular? or other? car won't start.was told it may be fuel pump. also the fuel gage never worked since i got it about 6 years ago

Posted by on

  • Zaraki May 11, 2010

    Will the engine start and run for a few seconds if you spray carburetor spray into a vacuum hose fitting on the intake manifold and then try and start the engine?

×

3 Answers

The sending unit in the gas tank,may be your gauge issue. You can check that when you pull the tank to check or replace the pump. The modular question is a non issue. Your going into the tank anyway you look at it. Check fuel pressure with key on or cranking,before you pull the fuel tank.
I assume you have spark, crank signal,no codes set etc.

Posted on Apr 29, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 7,353 Answers

Replace the Fuel Pump Module. It will come with a new pump and fuel level sensor. These engines need 60psi to run, 50 psi wont do it.

Posted on Apr 29, 2010

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Master
  • 3,741 Answers

You can get the required fuel pump for you car from the above link.you can also get proper details about the cost and the part from the above link before you order the fuel pump.http://www.autopartswarehouse.com/mmp/chevy~blazer~fuel_pump~parts.html check out this.keep updated for any further assistance. thanks.

Posted on Apr 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

By pass passlock on 97 chevy blazer


Check this site out!

http://newrockies.com/

Dec 14, 2014 | 1997 Chevrolet Blazer

1 Answer

My 97 Chevy blazer won't start I hear the fuel


Bad fuel pump, fuel filter, it may not have enough pressure or you aren't getting spark

Jul 29, 2013 | Cars & Trucks

1 Answer

2001 chevy blazer replaced fuel pump with fuel pick up switch and fues guage still does not work


THERE SHOULD BE 3 WIRES, FROM PUMP/SENDER UNIT, 1 WIRE FOR PUMP POWER, 1 WIRE FOR GROUND, & 1 WIRE FOR FUEL GAGE, THE FUEL GAGE WIRE GOES DIRECTLY TO GAGE , INSPECT THIS WIRE , MAY CHANGE COLOR ON ITS WAY TO GAGE, WIRE MAY HAVE BEEN DAMAGED UNDER TRUCK, ALONG FRAME RAIL, OR HAS BECOME CORRODED, A BUMP IN THE WIRE INSULATION(CORROSION), ALSO, CHECK ALL GROUNDS, REPEAT, ALL GROUNDS TO FUEL PUMP CICUIT, EVEN IF THEY LOOK OK, THEY COULD BE BAD GROUNDS, YOU NEED GOOD GROUNDS TO COMPLETE ANY CIRCUIT !!! 2001 TRUCK, I'D QUESTION YOURS !!!!! WHAT SHAPE WAS YOUR WIRE HARNESS @ PUMP, THEY GO BAD, ANYTHING UNDER THE TRUCK !!!!!! STAY IN YOUCH, LIKE TO KNOW OUTCOME !

Mar 25, 2013 | 2001 Chevrolet Blazer

1 Answer

Fuel gage on my 2002 Blazer is reading full


I just replaced the fuel pump on my 2000 ZR-2 blazer and the fuel sensor was made on to the pump. It is in the gas tank. It is a flotation type device. You have to drop the tank, turn the lock ring counterclock wise pull the unit and replace it.Be careful installing it because if you bend the plunger rod it will not read correctly

Feb 27, 2013 | 2002 Chevrolet Blazer

1 Answer

97 chevy blazer w/ 4.3 won't start unless i pour full directly into it....what is causing this. was driving and it just stalled ...fires but won't turn over completely


if you can put fuel in throttle body and it runs. then it is not getting any fuel. check your fuel pump fuse and the relay, if ok, then you may have a bad fuel pump or a plugged up fuel filter. check filter and fuses first. good-day !!

Jul 18, 2011 | 1997 Chevrolet Blazer

1 Answer

THE FUEL GAUGE STAYS PAST FULL DOESN'T MOVE .97 BLAZER REPLACED ENTIRE FUEL PUMP AND CHECK PUMP WIRES IF MELTED /FAULTY .THE I REPLACED THE ENTIRE GAUGE CLUSTER. FUEL GAUGE WHEN TURNED ON IT ALSO WENT...


USSUALLY WHEN GAGE GOES WAY OVERFULL IT'S A BAD GROUND
QUICK CHECK USE BOOSTER CABLE ONE END ON TANK OTHER END ON BATTERY NEGATIVE IF GAGE GOES OK MAKE UP SHORT WIRE FROM FRAME TO TANK SEEM LIP
AND ATTACH MAKE SURE METAL IS CLEAN

Apr 19, 2011 | 1997 Chevrolet Blazer

1 Answer

Chevy blazer 97 replaced the fuel regulator and pump and still


mine was doing the same thing, the mass air flow sensor and throttle position sensor were dirty...i changed the tps myself but had the dealer do the mas.

Jun 19, 2009 | 1997 Chevrolet Blazer

1 Answer

Fuel level sensor in tank bad????


Yes it is all one unit, and yes that is what the problem is. don't use aftermarket parts, use OEM, (Delco Remy) they are much better quality.

Sep 08, 2008 | 2000 Chevrolet Blazer

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

158 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...