Question about 2001 Chevrolet Blazer
Though the window switch is a possibility, more often then not, the window motor itself is starting to go bad. Intermittent loss of function is the most common initial sign. I recommend leaving the window up until the have the motor replaced. Otherwise you are risking having it stuck in the down position and never being able to get it back up without replacement. These things seem to happen at the worst time, like when its about to rain.
Posted on Apr 29, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: power windows
I had the same problem alot with a 95 Windstar. you need to replace some relays in the fuse panel under the dash. it should be labeled on the cover. unfortunately i've since sold the van... but i believe you need to replace the one touch down relay.
Posted on Mar 18, 2009
First thing to look at is the fuse located underneath the drivers side steering wheel. Remove the fuse box cover lid and on the back side you will find a diagram. Locate the power window fuse, pull it and then replace it. Both windows should work after you replace this fuse. Remove the door panels and then look at the glass window and to if it is lined up with the tracks inside the door. If they are still not working, you will need to test or replace the drivers side window switch. Remove the drivers side power window switch from the door and then use a multimeter to test the switch for continuity. If you are not getting power (continuity) to the switch then you will need to order a replacement. Click on the link below to get a replacement:
Posted on Aug 24, 2010
SOURCE: I've got a terios 2000,my
Something in the system is worn, loose or or out of alignment, you will have to remove the door trim and watch the window while it is operating and correct any fault you see or replace worn parts/
Posted on Jan 16, 2011
There are possibilities
1) the button for the window is bad 2) the motor to take the window up and down burnt 3) the wire went out of its track
take door panel apart and visually investigate.
Posted on Jun 03, 2011
Tips for a great answer:
Sep 28, 2012 | Cars & Trucks
Aug 02, 2012 | Dodge Dakota Cars & Trucks
Jul 17, 2012 | 2004 Oldsmobile Alero
Jun 16, 2012 | Cars & Trucks
Aug 09, 2011 | 1996 Dodge Caravan
Window fuse's and relay's may be up under passenger side dash or behind glove box.
Drivers door window gets used the most so it could be the motor, window switch, relay or fuse.
Could also be a broken wire in the rubber boot going from the door to the body. You will have to eliminate each till you find the culprit.
The motor and the relay are the most likely to cause this problem. Try swapping the relay with a working window relay. If it still doesn't work, remove the door panel and remove the window motor.
Turn the motor shaft in both directions by hand several turns. Then plug the motor in and see if the switch will now run the motor. Sometimes thats all it takes to get it working again. I have had to do this with brand new motors. If voltage is not present at the motor connector, either a bad switch or a broken wire exsists. Make sure to check for voltage coming to that windows switch. Actually, GM use's a circuit breaker type relay for each window and one fuse for all the circuit breakers.
Aug 02, 2011 | 2005 Chevrolet Cobalt
Jun 16, 2011 | 1997 Buick Century
May 30, 2009 | 1989 Toyota Camry
Sep 18, 2008 | 1991 Toyota MR2
251 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: