Question about 1993 Mazda MX-6

1 Answer

I have a 93 mazda mx6 ls my air bag light keeps flashing is there any way to make it stop with out removing the bulb????

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    New Friend:

    An expert that has 1 follower.

  • Expert
  • 161 Answers

Easiest solution would be to pull the fuse, but if you do that your air bags won't be in working order. A flashing light is usually a sign that a relay is out in that system and it isn't working anyway. Your fuse panel will show you which fuse it is.

Posted on Apr 29, 2010

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 93 Mazda mx6 Ls... Everytime I step hard


When my MX6 was doing this it turned out to be an hydraulic leak from the clutch master cylinder, which runs on the same fluid reservoir as the brakes. Clutch master cylinder replaced and all good again!

Apr 10, 2012 | 1993 Mazda MX-6

1 Answer

The best way to replace the headlght bulb


In my opinion, the BEST way is to get somebody else to do it for free!...LOL

However, that is not very likely to happen in this millenium, so I have provided the pictures below.

Also please note that there is a Mazda 6i and a Mazda 6s But there is no Mazda MX6 in 2005. There is, however, a Mazda MX5...so assuming this is what you meant, the pictures are for the MX5.

If you meant Masda 6i or Mazda 6s, these pictures are not even close because the 6-series requires removal of the front bumper to remove the head lights.


12_4_2011_2_50_48_pm.jpg

12_4_2011_2_51_44_pm.jpg

Dec 03, 2011 | 2005 Mazda MX6

1 Answer

Where is my diagnostics connection located on my 93 mazda mx6 4 cylinder?


For 1993 Mazda MX-6 2.0L MFI DOHC 4cyl the OBD Diagnostic Link Connector is located: Under hood, driver side, upper engine area, passenger side rear of air filter housing, mounted next to airflow meter connector.

Hope this helps (remember to rate this free answer)
.

Jun 04, 2011 | 1993 Mazda MX-6

1 Answer

My hold button flashes and seems like the car drags i have a 93 mazda mx6 what could be the problem


the hold light flashing is just like a check engine light but for the transmission. If your hold light is flashing it sounds like a selanoid went bad and your clutchs inside your transmission is coming apart.

Mar 24, 2010 | 1993 Mazda MX-3

2 Answers

Sun roof needs adjustment


no adjustment there two drains at the tracks that sometimes plug up find them and use wire to clean them out,inspect gaskets you can lace the rubber gasket with petroleum jelly this will help keep water out.

Jan 14, 2010 | Cars & Trucks

1 Answer

Air bag light keeps flashing!!!I have a 1999 mazda 626 2.0


The air bag light flashing is indicating the SRS module has detected a failure in the air bag system. It could be anything from a sensor to bag module or wire connection.
I would take your vehicle to your local Auto Zone or Advance Auto and ask them to scan your car for trouble codes, they will do it for you at no charge, write the codes down and respond back and we can begin to diagnose the problem.
Good luck.
Regards,

Aug 27, 2009 | Mazda 626 Cars & Trucks

1 Answer

Sensor directly behind the air filter


93??? think its a carburettor

Mar 17, 2009 | 1993 Mazda MX-6

1 Answer

5 series' of 5 beeps in a row on start up


Check the Air Bag Indicator Light. When you turn the car on it should stay on for 6 seconds and then turn itself off. If a fault is detected in the system operation check, the indicator light will either fail to light, stay on continuously or flash. The flashing may not start until up to 30 seconds after the initial systems check.

If there is a fault in the system AND the air bag indicator light fails to light then an audible tone will alert you- it will be a set of 5 chimes (bells/beeps) five times in a row.

Have the Air Bag serviced and the indicator light bulb changed. Since the dash will be off in order to change the bulb, I would have all of the other dash lights changed at the same time. If one goes out, others will surely follow.

Good luck!

Corri R. / Service Writer

Jan 26, 2009 | 2002 Mazda Tribute

1 Answer

93 mazda mx6. hold light keeps flashing. wont go out of first.


If its flashing than it means a transmission code,I believe its a overheating code for a solenoid in the transmission.

Jan 13, 2009 | 2007 Mazda MX6

2 Answers

Car keeps dying but starts straight up


i have a 93 mazda mx6 2.5 the car stall in every gear when i depress the gas pedal in too hard,have to do that gradually in order to ride smooth?

Nov 29, 2008 | 1993 Mazda MX-6

Not finding what you are looking for?
1993 Mazda MX-6 Logo

444 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...