Question about 2002 Nissan Pathfinder

Open Question

How do i adjust the headlights on a 2002 nissan pathfinder

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 41 Answers

SOURCE: hand brake nissan pathfinder

If you lift the hand brake you should find an adjustment nut (I think it is 10MM). Tighten that and you should be good to go. Be careful, it doesn't take much to adjust - turn gradually/slowly.

i hope i was able to help you with your problem! tc!

Posted on Oct 12, 2008

Ad
mrgreenz
  • 962 Answers

SOURCE: speedo not working on nissan pathfinder

check the speed sensor either at the transmission or on the front wheel axle. You have to remove the front wheel , rotor until you get down to the shaft. The speed sensor is right there on the passenger side of your car.

Posted on Jan 11, 2009

  • 1986 Answers

SOURCE: 2002 nissan xterra headlight is aiming up too high

on each headlamp assembly, there will be either one or two plastic nuts that you can turn.

If you only have one nut on each, that will adjust the vertical aim of the headlights.

If you have two nuts on each, one will adjust the vertical and the other will adjust the horizontal.

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 14, 2009

  • 1986 Answers

SOURCE: adjusting 2001 nissan frontier headlights

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

If you have one adjustment screw, it will control your vertical aim. If you have two adjustment screws, one will control your vertical aim and the other will control your horizontal aim

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

Posted on Sep 30, 2009

  • 1986 Answers

SOURCE: adjusting headlights

The adjustment screws/nuts should be located either on the top of the headlamp assembly, behind the headlamp assembly, or near the frame rail by the radiator support.

You will have vertical adjustment screws for each independent beam (separate highs and separate lows, but will be same screw if highs and lows are the same bulb). You may also have additional horizontal adjustment screws as well

Park your car on a level ground 30 feet from a wall and measure the height from the ground to the bulb and mark on a wall (do this for highs beams and low beams if the bulbs are separate, if highs and lows are the same bulb, only do it for the lows)

For Low Beams: If the headlights read VOR, then aim the brightest part or cutoff part just below the mark on the wall. If it says VOL or nothing, aim them 2 inches below the mark on the wall.

For High Beams (if separate from low beams): Aim the headlight directly at the line you marked on the wall.

Posted on Nov 04, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to adjust Pathfinder alarm


There is no adjustment . Unless it is after market. Then you have to find the module under the dash. There will be a small set ***** to adjust. I have seen this in years though. They did away with it. Factory never had it.

Apr 11, 2016 | 2002 Nissan Pathfinder

1 Answer

Where is the instrutment panel dimmer switch located inside the 2005 Nissan Patfinder?



  • When the headlights are on adjust the little knob just barely up and to the right of the trip reset under the speedometer (see red arrow in pic)

ironfist109_111.jpg


Regards, Tony

May 29, 2011 | 2005 Nissan Pathfinder

1 Answer

2002 pathfinder, the left headlight bulb does not work when the


Sounds like you need a bulb,the daytime running lights send power to the high beam wire so they look like low beam lights are on but really they are high beam lights running on low voltage.

Nov 19, 2009 | 2002 Nissan Pathfinder

1 Answer

02 pathfinder, headlight still won't work


Unlikely to be the column swithch . try high and low? Check for power at the plug.

Jun 02, 2009 | 2002 Nissan Pathfinder

1 Answer

Heating problem 2002 nissan pathfinder


On a typical heater are several (4) in this case various size coils which look like springs.You have a break at those coils but not at # 4.

Mar 31, 2009 | 2002 Nissan Pathfinder

Not finding what you are looking for?
2002 Nissan Pathfinder Logo

216 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

726 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...