Question about 2002 Volkswagen Jetta TDI

Open Question

I have 02jetta with power windows I can operate all the windows except driver side all I can here is a click in the motor so I installed another motor but all I get is a click?? And also the interior lights do not come on when I open either of front doors, but dome light comes on when I open either back door?? Any advice Thanks OT

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 84 Answers

SOURCE: Interior lights won't turn on when door opens

Do you have electric locks in the vehicle? One test to do is turn on the car's headlights and open the door. You should hear a chime when you open the driver door. One other thing is to unlock the doors with the remote if you have a remote open the driver door, get in the car but don't put the key in the ignition. The doors might relock after 15-20 seconds. This proves that the door signal open is not being processed. Just tell me what model VW and what year and if you have electric locks and I'll help you.

Posted on Oct 31, 2008

blueextc3221
  • 15935 Answers

SOURCE: door ajar alarm

The doorlach pin is faulty.
On newer vehicles it is inside the door on the locking mechanism.
It is stuck in the closed position, or has become dislodged.
Refer to your mechanic for repair.

Posted on Jan 12, 2009

LAYNRAIL
  • 18 Answers

SOURCE: dome light wont turn off

some times the door switch can be faulty. and it may be coincidence that the interior switch is faulty too. i have owned alot of S- series trucks and a few of them have done this to me. you need to individually check each door for switch contact

Posted on Jan 27, 2009

  • 257 Answers

SOURCE: 2006 Jetta TDI Electrical!!!

There is a known issue with the wiring harness in the doors. It's possible that the passenger door also has a bad harness (assuming they swapped out the one in the driver's door) Is that a correct assumption? It may still be related to your original problem too. I've heard of disconnecting the battery for 20 minutes to reset the electrical (door switches). You should def give that a try - it's free.
Also check out the forums at www.tdiclub.com - those guys know their VW TDI's...

Posted on Jul 13, 2009

Testimonial: "The battery disconnect did not work but I am glad to hear it's not just me."

  • 1 Answer

SOURCE: no power in driver side door

I just fix the same problem :(
Two wires in harness were broke. Let me give you some instructions to fix this. 1- Remove the inside panel. then remove the conection that is in the middle betwen the door and the body of the car, is like black cover for the wires. In my case 2 of these wires were broke.
2- Remove the screws of the door in the frame then close the door and pull the door only a few inches just to have acces of your hand to pull the wires.
3- Add another piece of cable, to meke these cables longer, and put everything back.
call 21-642-9775.

Posted on Sep 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

On 1998 Volvo V70, just replaced the window control unit on the driver's side with a new one. All windows work except for the driver's.


Check for power and ground at the window motor itself. Power motor directly and make sure that motor is ok.

Jun 12, 2015 | 1998 Volvo V70

1 Answer

2002 sable all windows except the driver's side are working.


faulty switch or motor may have broken tooth on raiser

Aug 20, 2014 | 2002 Mercury Sable

1 Answer

Ford focus electric window not working


usually the window motor has expired or shorted out - clicking means you are getting power to the switch, just nothing happens - this is not a job for amateurs - the entire door inner shell, speaker and lock has to be removed - the regulator/motor assembly is usually $70-$100 and about 1 hour labor for a window glass installer - PAY the installer and save yourself 3 hours of headache

Apr 17, 2014 | Ford Focus Cars & Trucks

1 Answer

2003 cadilac deville driver window off track. motor seems to work but window will not go up.


Window regulator is bad in the drivers door . Do you know what a regulator is ? The Trainer 24 Power Window Troubleshooting Do you know anything about automotive electrical testing ? How to read an use a wiring diagram ? Do you know there are two side to a electrical circuit ? B+ voltage an a ground side . Plus there is electronic control modules and class 2 serial data network involved . When you push the switch for a window othen then drivers window on the drivers door . a class 2 message is sent to the other doors modules . The correct module will then open it's window .
http://www.bbbind.com/free_tsb.html Check out free wiring diagram here .Enter vehicle info . year , make , model and engine size. Under system click on body & accessories , subsystem click power windows . Click search button , then click each link one at a time .

Mar 27, 2017 | 2003 Cadillac Deville

1 Answer

I have a 2008 mazda 23 . All power windows except the drivers side front window will not close I opened them all fully and none will close or operate except the front drivers window which operates ok Any...


Welcome to FixYa

You will need to check all connections in door. Make sure to have a 12 volt test light, remove door panel and check window switch for power if ok go to motor hold test light to the hot wire to motor, use window switch does test light light up if so motor is bad.

Need help with door panel and testing with pin connector locations go to this site you with the diagrams and step by step diagrams .

Lee

leedavidian_162.png

Feb 10, 2011 | Mazda MAZDA3 Cars & Trucks

1 Answer

Front passenger side window will not operate from drivers side or from the right door, is there a separate fuse for it


Typically when the window no longer operates, the motor for that power window is shot. The fix is to replace the motor. I prefer to get the motor and track assembly. It is much easier to install. J.

May 31, 2010 | 1993 Oldsmobile Cutlass Supreme

1 Answer

2005 Pontiac Grand Prix power window switch


Disconnect the wire connector at the driver's window motor and install a test light or meter at the connector then operate the switch and see if the light or meter indicate proper function of the switch. If function is correct then the window motor/regulator is probably failed.

Feb 25, 2010 | 2005 Pontiac Grand Prix

1 Answer

1998 toyota sienna window on the driver side won't go up to close


Sadly, the power windows on this van are not very robust. Worse yet, the windows will go down but not go up--except perhaps a little at a time. But eventually the motor will no longer work.

I disassembled my power window and found there was no way to replace the motor except with a (very, very expensive) factory part.

My passenger window is currently broken like this, and I disconnected the wiring to prevent anyone from operating it. I keep my passenger window very very clean because friction (like sap from the Almond tree in our front yard) wears out the automatic windows quicker.

In your case, there's no real workaround because it's the driver's window--go to the dealer and see what type of price you can get for the replacement part.

My condolences.

Apr 09, 2009 | 1998 Toyota Sienna

1 Answer

Rear side windows


This may be just a case of inadvertently hitting the window lock out n th driver door window switch by mistake. Check that first. Here's some background on window operation

Principles of Operation
The driver power window regulator motor is controlled directly by the master window/door lock/unlock switch (and its integrated "auto down" module). Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The driver power window regulator motor is a reversible motor that is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The passenger power window regulator motor is controlled directly by the passenger power window switch and can also be controlled by the master window/door lock/unlock switch. Power is supplied to the power window relay and the master window/door lock/unlock switch, and the passenger power window switch when the SEC/timer module grounds the coil side of the power window relay. The SEC/timer module will ground this relay when the ignition is in the ON position and will remain energized for approximately 15 minutes or until the driver or passenger door is opened.
The passenger power window regulator motor is a reversible motor, which is operated by applying power and ground to the motor leads to lower the window, and then reversing polarity on those leads to raise the window.
The power rear quarter glass is also directly controlled by the master window/door lock/unlock switch. The power rear quarter glass power latches also utilize reversible motors. The power rear quarter glass power latches are operated by applying power and ground to the motor leads to open the window, and then reversing polarity on those same leads to close the window.
Symptom Chart Condition Possible Sources Action
  • All windows are inoperative
  • BJB Fuse:
    • F20.
  • Circuit.
  • Power window relay.
  • Front door power window switch.
  • GO to Pinpoint Test A .
  • Single power window is inoperative
  • Front door power window switch.
  • Front door power window regulator.
  • Circuit.
  • Driver door power window switch.
  • GO to Pinpoint Test B .
  • Vent power window is inoperative — quarter window glass power latch
  • Circuit.
  • Quarter window glass switch.
  • Quarter window glass power latch.
  • GO to Pinpoint Test C .
  • The one touch down feature is inoperative
  • Master window regulator and door lock switch.
  • INSTALL a new master window/door lock/unlock switch. REFER to Switch—Master Window Door Lock/Unlock .
  • The back window will not defrost
  • CJB Fuses:
    • F30 (10A).
    • F32 (20A).
    • F34 (20A).
  • BJB Fuse:
    • F27 (45A)
  • Circuit.
  • Heated back window switch.
  • SEC/timer module.
  • Rear window defrost relay.
  • GO to Pinpoint Test D .
  • The back window defrost will not shut off automatically
  • SEC/timer module.
  • Circuit.
  • Rear window defrost relay.
  • GO to Pinpoint Test E .

Jan 28, 2009 | 1999 Mercury Villager

1 Answer

Driver window won't go up


SOUNDS AS IF MOTOR IS BAD CHECK POWER AT MOTOR WHILE OPERATING SWITCH. IF U HAVE POWER AT MOTOR THEN MOTOR IS BAD OR A POSSIBLE GROUNDING ISSUE.

Jan 20, 2009 | 2005 Nissan Murano

Not finding what you are looking for?
2002 Volkswagen Jetta TDI Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

yadayada
yadayada

Level 3 Expert

75744 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8123 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...