Question about 2002 Hyundai Santa Fe

1 Answer

The fan switch stopped working, you push in on it & the high works only. how do you replace it?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 18 Answers

Its not the switch try replacing the heater resistor

Posted on Apr 30, 2010

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Blower fan not working


The resistor bank is bad for slow speeds, the switch is bad for high speed. In your test, you have voltage, but the switch wont carry the amps, to run high speed. Open circuits will not blow fuses. Replace both switch and resistor bank for all speeds. Make sure to clean leaves and trash from fan housing and see if fan spins freely.

May 17, 2017 | Cars & Trucks

1 Answer

My 1995 camry is running hot. I have replaced the thermostat, hoses & radiator cap, but its still overheating when I stop for about 3 to 5 minutes. Any suggestions plz?


If your model has electric cooling fans they may not be turning on or reaching high speed. The fans work to boost cooling capacity when the regular water pump is not enough.

There are Relays for the fans and they get the signal to turn on from temperature sensors or setting a dash control.

If all switches work, fans, etc. then your Radiator or block may be clogged.

Jan 23, 2013 | Cars & Trucks

1 Answer

Heater fan only works on high


Replace the step switch, the contacts are burned out or just use it on high until that speed doesn't work...your choice..

Dec 31, 2012 | 2000 Buick Century

1 Answer

2005 Chevy 2500hd a/c blower switch #5 not working. Only 1 thru 4.


switch has failed and needs replaced would be my suggestion....good luck...

Aug 19, 2012 | 2003 Chevrolet Silverado 2500HD

1 Answer

I have an ,05 Audi A6. The A/C stop blowing out air when on. When it does work, it will blow air as if all was fine then stop. When I push the ECON button (while driving) cold air will come out though only...


DONT QUOTE ME but it sounds like the Freon gas is low. the compressor comes on & shuts down & cant build the pressure back up again. There are also high & low pressure switches the can do this. U need to get it checked out further. Good luck

Aug 05, 2017 | 2005 Audi A6

1 Answer

The starter on my 1995 saturn sl2 stopped working i can still push start the car but in the same day the heater fan and cooling fan stops working but then starts working again when the fans don't work the...


You have a electrical power shortage, when componets demand power it's not there [ that's why some componets slow or stop working ]. Start by cleaning the battery terminals and testing the battery to see if it holds a proper charge [ after fully charging, let the battery sit for a few hours and check the voltage = it should be at least 12 volts. If not, replace. Then check the output of the charging system = mininum of 13.8 volts to maxinum of 15.3 volts, & up to 78 ampress when @ maxinum charing. Then check the starter draw = should be around 260 amps, if it's higher then 300 amps. then replace.

Feb 21, 2011 | Saturn SL2 Cars & Trucks

1 Answer

Location of low speeds heater fan fuse & switch. I do not have a owners manual.


the switch is on the dash with the other a/c controls. does the fan work at all? high speed OK? but the lower speeds dont work? if any speeds other than high dont work, replace the blower resistor.

Oct 04, 2009 | 1999 Buick LeSabre

2 Answers

Why does blower fan speed switch lock-out off and low speed positions on 1998 chevy silverado? It stopped working altogether then I replaced a 10 amp fuse and now only medium high and high will work but,...


Sounds like you may have a bad blower motor resistor.  When they go bad, they usually wipe out all speeds except high.  But could knock out just one or two of the speeds.  It should be located near the blower motor.

Sep 10, 2009 | 1998 Chevrolet K1500

2 Answers

Heater fan switch only works on high


that is a common for dodge you need to replace the relay for the fan switch i only know this because it happend to me three times on my dodge .hope this could help.

Jan 05, 2009 | 1997 Dodge Ram 3500 Club Cab

Not finding what you are looking for?
2002 Hyundai Santa Fe Logo

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8266 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...