Question about 1996 Dodge Ram

Open Question

Trans leaking from manual shifter on an auto transmission, is this easy to replace

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 pt crusier won't shift out of low


You could try the linkage cable from the shifter(under the hood). It could be alot of things. Is it auto or manual trans? And what do you mean by wont shift? Is the the shifter moving from P,R,N,D, ect... or the transmission is not shifting into a higher gear?

May 29, 2014 | 2006 Chrysler PT Cruiser

1 Answer

I have a acura mdx 2003 and the reverse lights stay on even when it's in drive what do I do?


Replace your reverse light switch . It's more than likely sticky or stuck. It is located on the transmission under the car. Inside the trans. Some cars have them in the shift linkage area in the shifter console . You didn't specify if auto or manual trans.

Aug 09, 2013 | Cars & Trucks

1 Answer

I have a 1998 ranger manual tran will change gears but wont go in to 5 gear hard to shift


The ball on the Shifter that mounts on the TOP of the transmission is worn and needs to be replaced in order to get the Complete throw (Movement) of the shifter. It is an easy repair, 8 screws to take the cover off, 4 bolts on the cover and then pull up the shifter and replace the ball

May 26, 2011 | 2001 Ford Ranger Regular Cab

1 Answer

Would i be able toi swap my 93 4L60E for a manual transmission?


Yes it is possible to swap the auto trans to a manual trans but it will be a big job.
You will need the manual trans and shifter, flywheel, clutch and pressure plate, manual trans ECM and possibly wiring loom, pedal assembly, clutch master & slave cylinder and a whole lot more little bits.
The best way to do it would be to have a complete manual trans vehicle there to strip all the needed parts out of.

Nov 29, 2009 | 1993 Chevrolet Suburban

2 Answers

Where is the dipstick located for the transmission fluid on a 2005 Pontiac Sunfire


According to the owners manual unless you drive in hilly, or heavy stop and go traffic like a taxi, you should never have to add trans mission fluid unless you have a leak. The manual doesn't even give a fluid capacity for the auto transmission. So I guess when you have to have the auto trans. filter changed, you have to take the car to a transmission specialist. If in fact the filter even needs to be changed. The manual leaks you to believe that the transmission fluid and filter are lifetime products.

Nov 09, 2009 | 2005 Pontiac Sunfire

1 Answer

1998 pontiac transport 3.4 auto leaking trans fluid


It sounds like the Transmission line has a leak. Check the transmission line from the transmission to the radiator. You have two steel lines which runs to and from the transmission to the transmission cooler in the radiator. The line could be corroded and may need to be replaced, good luck and service the transmission too. The transmission on the transport are know to have problems when ran low on fluid or dirty transmission filter.
Good luck and hope this helps.

May 25, 2009 | Pontiac Trans Sport Cars & Trucks

1 Answer

Replace Auto transmission with 5 speed Manual !


More work than it's worth,You would have to change the PCM, wire harnesses, maybe driveshafts, trans mounts. Would have to add a shifter console, because the car was never built with one. Somehow figure out the clutch pedal and clutch master cylinder, and who knows what else. I believe it would be a difficult task. Good luck, Honda Al

May 19, 2009 | 1998 Honda Odyssey

1 Answer

1999 DODG 3500 AUTO TRANS SHIFTS TO 2ND WITH A LITTLE HELP


I have a 1999 Ram B 1500 Van, auto transmission, 5.9 L engine.
Same problem, trans hesitates in 2-3 upshift, sometimes 1-2
to 2-3 upshift. Posts trouble code P1756 - Transmission Govenor pressure too low at below 15 to 20 Psi. Transmission pump shot or valve body leak stops trans from reaching proper pressure to shift, which is minimum 15 Psi.
Either trans is leaking in valve body, valve is stuck, shift solenoid on valve body is sticking, or pump is shot.

Feb 14, 2009 | 1999 Dodge Ram

2 Answers

Need to locate backup light switch on 1988 chevy 1500


I had the same problem. My backup lights wouldn't come on in when I put the auto. trans. shifter into the Reverse position. They WOULD come on briefly as I moved the shifter from Park position into Reverse, but would go off again when the shifter reached the Reverse detent. I got the solution from the Haynes service manual, in which the relevant switch is referred to as something like the neutral safety switch. Check on top of the steering column close to the firewall. Set the parking brake, then move the auto. trans. shifter into Neutral position. Get under the dash and rotate the neutral safety switch clockwise as far as it will go. Then move the shifter into the Park position, and your switch should be set. If the backup lights don't come on now when the shifter is put into Reverse position with the ignition switch 'on', there may be another problem.

Feb 10, 2009 | 1988 Chevrolet C1500

4 Answers

1998 SUNFIRE GT TRANSMISSION PROBLEM


There are 3 transmissions that could be in your car,the 3 speed auto and 4 speed auto overdrive,and of course the manual 5 speed.The 3 speed is designated the 3T40,the 4 speed auto is the 4T40E trans.To check the fluid level,first,the car has to be warmed up to at least 100 degrees Fahrenheit.The car has to be raised in the air,as there is a steel plug in the trans case that has to be removed to check the fluid level.The plug takes an 11 mm or 7/16" socket or wrench and is located on the passenger side of the trans case,near where the passenger side axle engages into the trans.The procedure is to warm the car up to at least 100 degrees,engage the shifter into each gear selection pausing for about 5 seconds in each gear,then remove the plug.If fluid drips out,it is full.If no fluid drips out,add fluid through the top of the trans after removing the red plastic cap,and make sure to use a long funnel to avoid a mess.Add fluid until it drips out the hole.When done,replace the plug and cap.Just a note,a transmission does not "use" fluid like an engine uses oil.If you have to add fluid,that means there is a leak that needs to be repaired.Good luck

Aug 29, 2008 | 1998 Pontiac Sunfire

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...